查询词典 piece by piece

Acclivity 20° against to fall the silk brick, in resistance wire Yi Congcao does not drop out. The drum stove pot uses the 1Cr18Ni9Ti stainless steeliness full circle columnar order, or uses the chromium manganese nitrogen high-temperature steel casting, an origin bearing spider outside the furnace bodythe supporting, and uses the electric motor belt speed reducer to carry on the biography to use, to cause the stove pot to revolve slowly, the work piece causes it heating along with drum stove pot revolving to be even, and work piece mutually between non-cover phenomenon, after the heat treatment, theluster is consistent, stove pot another end is a feed head, by two hoop supporting.

滚筒炉罐采用1Cr18Ni9Ti不锈钢制成圆柱型，或采用铬锰氮耐热钢铸件，一端由轴承支座在炉体外支承，并采用电动机带减速机进行传用，使炉罐缓慢旋转，工件随滚筒炉罐旋转使之受热均匀，并且工件互相之间无复盖现象，热处理后色泽一致，炉罐另一端为进料口，由二只滚轮支承。

The private letter of his a pair, all through respectively of the attendant secretary(call attendant a secretary again) dismantle to read to send to present and the general batch piece is also added by attendant secretary, if the airtight piece, aviso be all another to beat mark to add a fire paint to print and outside receiving and dispatch to have negligence immediately can look up.

他俩的私人信件，都经各自的侍从秘书拆阅送呈，一般批件也由侍从秘书加封，若密件、急件均另打记号加火漆印，外收发有所疏忽立即能查出。

This invention has been possible since the problem of connecting the corner cube piece with the solid interior has been solved, so that the said corner piece can be self-contained and rotate around any semi - axis of the three-dimensional rectangular Cartesian coordinate system, be protected during rotation by the six caps of the solid, which is the central pieces of each face, to secure that the cube is not dismantled.

自从通过可靠的内部连接魔方角块的问题解决后，高阶魔方的出现成了可能。角块能够完全独立，并在三维直角坐标系的各个轴上旋转。而且在角块转动过程中，有6个可靠的cap提供保护。这种cap就是每个面的中心部分，它们可以保证魔方在转动的过程中不会散架。

Start with one piece covered by a piece of blotting paper.

松开标本夹，移除纸板和吸水纸，每个标本应覆以一张吸水纸。

The third part is the judge method and its improvement method of a piece matrix is a diagonally dominant matrix: By using the Schur repair property of matrices, gives the sufficient and necessary conditions to judge a piece matrix be a diagonally dominant matrix.

第三部分为分块广义严格对角占优矩阵的判定方法及其改进：利用矩阵Schur补的性质，给出判定分块广义严格对角占优矩阵的充要条件，并利用逐次降阶的方法，使一个任意阶矩阵A逐次降为只需要利用定义判定一个矩阵是否满足要求，从而判定A是否是广义严格对角占优矩阵。

At length I spy'd a little Cove on the right Shore of the Creek, to which with great Pain and Difficulty I guided my Raft, and at last got so near, as that, reaching Ground with my Oar, I could thrust her directly in, but here I had like to have dipt all my Cargo in the Sea again; for that Shore lying pretty steep, that is to say sloping, there was no Place to land, but where one End of my Float, if it run on Shore, would lie so high, and the other sink lower as before, that it would endanger my Cargo again: All that I could do, was to wait 'till the Tide was at highest, keeping the Raft with my Oar like an Anchor to hold the Side of it fast to the Shore, near a flat Piece of Ground, which I expected the Water would flow over; and so it did: As soon as I found Water enough, for my Raft drew about a Foot of Water, I thrust her on upon that flat Piece of Ground, and there fasten'd or mor'd her by sticking my two broken Oars into the Ground; one on one Side near one End, and one on the other Side near the other End; and thus I lay 'till the Water ebb'd away, and left my Raft and all my Cargo safe on Shore.

最后，我终于在小河的右岸发现一个小湾。我费尽艰辛，好不容易把木排驶到最浅的地方。我用桨抵住河底，尽力把木排撑进去。可是，在这里，我几乎又一次险些把货物全都倒翻在水里。这一带河岸又陡又直，找不到可以登岸的地方。如果木排一头搁浅在岸上，另一头必定会像前次那样向下倾斜，结果货物又有滑向水里的危险。这时，我只好用桨作锚，把木排一边固定在一片靠近河岸的平坦的沙滩上，以等待潮水涨高，漫过沙滩再说。后来，潮水果然继续上涨，漫上沙滩，等水涨得够高了，我就把木排撑过去，因为木排吃水有一尺多深。到了那儿，我用两支断桨插入沙滩里，前后各一支，把木排停泊好，单等潮水退去，就可把木排和货物品平安安地留在岸上了。

During the period of design, according to change direction various parameter of the arm spare parts, analyze it is anticipate by the metals to change in to take shape the Forging piece to transform process, draw up more reasonable craft process;From change direction the arm Forging piece system process, design more economic, use convenience, more reasonable molding tool.

在设计过程中，根据转向臂零件的各种参数，分析了其由坯料变为成形锻件的变形过程，制定出了较为合理的工艺流程；由转向臂锻件的制坯过程，设计出了较为经济，使用方便，较为合理的模具。

The part when 1900 was challenged by Jelly Roll Morto is the best of the film is agreed without quarrel. The climax is when 1900 played his last piece: enduring movement, a piece which is played solely on the black keys,(in other words half-notes), and require the best of skills in piano playing.

电影中最为人称道的电影片段无疑是1900和Jelly Roll Morto斗琴的一部分，尤其是1900最后演奏的一首"无穷动"，这首曲子全部是钢琴黑键弹奏的，也就是全是半音演奏，需要极高的钢琴技巧才能弹奏。

Begin from 2005, peaceful wave city establishs job of culture market control to head a group, as a whole the culture market control such as whole town Internet bar works, build system of joint meeting of the Internet bar that joins by 13 relevant sections and job of network game management, progressively form is in charge of into division of labor with catch condominium together, piece cooperate with with piece give priority to, self-discipline of daily go on a tour of inspection and technical monitoring, industry and society are supervised " 4 union " pattern of Internet bar management, whole town 905 Internet bars bring into normative and orderly orbit.

从2005年开始，宁波市设立文化市场管理工作领导小组，统筹全市网吧等文化市场管理工作，并建立由13个相关部门参加的网吧及网络游戏管理工作联席会议制度，逐步形成分工负责与齐抓共管、条块配合与以块为主、日常巡查与技术监控、行业自律与社会监督"四结合"的网吧管理模式，把全市905家网吧纳入到规范有序的轨道。

The shutdown is to pull out the plug-in board-by-block, each pulled out a piece of plate on the boot machine running observation, once pulled out a piece of normal operation after the motherboard, then the cause of the malfunction is the fault of the plug-in board or the corresponding I / O Bus slot and load circuit fault.

该方法就是关机将插件板逐块拔出，每拔出一块板就开机观察机器运行状态，一旦拔出某块后主板运行正常，那么故障原因就是该插件板故障或相应 I/O 总线插槽及负载电路故障。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。