查询词典 photosensitive

Exposure energy will change with different CCL , thickness of ink and baking stage , so we must carry on experiment to confirm printing ink minimum surviving width , surface gloss and photosensitive degree on the back , then establish suitable condition .

曝光能量会因基板的材质及涂膜厚度烘干程度之不同而有差异，故需进行试验确认油墨最小残存宽度，表面光泽及背面感光程度后，再设定适宜的条件。

Lines are induced on the surface of a photosensitive glass by focused femtosecond laser transverse writing with scanning velocity in a wide range of 40-1800 μm/s. The formed lines are analyzed using scanning electron microscope and optical microscope.

利用聚焦飞秒激光的横向直写方式，采用宽的扫描速度范围(40-1800 μm/s)，在光敏玻璃表面上诱导了直线结构，并扫描电子显微镜和光学显微镜分析了形成的直线，发现随着扫描速度不同，形成的直线具有三种不同的形貌。

An opaque border or pattern placed between a source of light and a photosensitive surface to prevent exposure of specified portions of the surface.

遮光''。'板'。''置于光源与感光性表面之间的、防止表面特定部分曝光的边或''。'图形'。

Exposure energy change with different thickness of ink,so we must carry on experiment to confirm printing ink minimum surviving width,surface blare and photosensitive degree on the back,then establish suitable condition

曝光量会因基板的材质，及涂膜厚度之不同而有差异，故需进行实验确认油墨最小残存宽度、表面光泽及背面感光程度后，再设定适宜之条件。

Microconcavesurfaces were fabricated on the surface of a photosensitive glass by focused irradiation of femtosecond laser (with 775 nmwavelength and 150 fspulse duration),heat treatment and wet chemical etching in 8% ultrasonic solution of hydrofluoric acid for 50 minutes at room temperature.

利用聚焦的飞秒激光（中心波长775 nm、脉宽150 fs）照射FOTURAN光敏玻璃，经热处理及浓度为8％的氢氟酸溶液室温腐蚀50 min后，在FOTURAN玻璃表面制作了微凹面。

Micro-concave-surfaces were fabricated on the surface of a photosensitive glass by focused irradiation of femtosecond laser (with 775 nm-wavelength and 150 fs-pulse duration),heat treatment and wet chemical etching in 8% ultrasonic solution of hydrofluoric acid for 50 minutes at room temperature.

利用聚焦的飞秒激光（中心波长775 nm、脉宽150 fs）照射FOTURAN光敏玻璃，经热处理及浓度为8％的氢氟酸溶液室温腐蚀50 min后，在FOTURAN玻璃表面制作了微凹面。

From by passing light through film onto a photosensitive surface, especially sensitized paper.

翻印通过使光线穿过胶片投射到感光板，尤指感光照相纸上，从而晒制出图象

Approach is to dip cotton balls ethanol scrub, scrub the parts, including LED, lens and mirrors, photosensitive surface, it is necessary to pay attention to ethanol must be pure, or else they will become more dirty washing, but also can use water After ethanol washing, the lens at the lens and reflectors Oh breath and then gently wipe clean swab until unabated until smooth.

处理方法是用棉球沾无水乙醇擦洗，擦洗的部件包括发光管、透镜及反光镜、光敏管表面，要注意无水乙醇一定要纯，否则会越清洗越脏，也可以在用无水乙醇清洗后，对准透镜及反光镜片呵一口气，然后再用干净的棉棒轻轻擦拭，直到光洁如初为止。

Approach is to dip cotton balls scrub ethanol, scrub the parts, including LED, lens and mirrors, photosensitive surface, it is necessary to pay attention to ethanol must be pure, or else they will become more dirty washing, but also can use water After ethanol washing, the lens at the lens and reflectors Oh breath and then gently wipe clean swab until unabated until smooth.

处理方法是用棉球沾无水乙醇擦洗，擦洗的部件包括发光管、透镜及反光镜、光敏管表面，要注意无水乙醇一定要纯，否则会越清洗越脏，也可以在用无水乙醇清洗后，对准透镜及反光镜片呵一口气，然后再用干净的棉棒轻轻擦拭，直到光洁如初为止。

Such failure is due to the accumulation of toner than age at first, so that the toner can not produce a position to enter the toner, and the waste toner in粉仓will continue to "squeeze" caused by "powder leakage" phenomenon, Then, as the toner contains纸灰, fiber and other filth, more rough, and long cartridge friction, and more tight, the pressure increases, eventually the surface of photosensitive film cartridge has been worn away, cartridge will be ruined.

产生这种故障的原因是起先废粉堆积过满，使再产生的废粉无法进入废粉创仓，而废粉仓中的废粉也会不断"挤"出来而产生"漏粉"现象，接着，由于废粉中包含着纸灰、纤维等脏物，较粗糙，与硒鼓长时间摩擦，而且越来越紧，压力越来越大，最终将硒鼓表面的感光膜磨掉了，硒鼓就损坏了。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。