查询词典 photocurrent

In addition, for the first time, we observed that 〓 is a good acceptor and cansensitize the cathodic photocurrent.

另外，我们还首次发现〓的存在可以敏化阴极光电流的产生，它是一个好的电子受体。

Through fluorescence spectrum and photocurrent action spectrum measurements,we found that fluorescence signal of CdS weakened after TiO_2 film was deposited CdSby electrodeposition, and accordingly improved photoelectric capability of TiO_2 filmand achieved sensitization action.

通过荧光光谱和光电流作用谱结果表明在TiO_2薄膜电极上采用电化学沉积法沉积CdS之后，CdS的荧光信号减弱，从而提高了TiO_2薄膜电极的光电性能，起到了敏化的作用。

It is determined that the sun vector measurement error is about 5.74° which is caused by many factors, such as the non-ideal cosine curve between incident angle and photocurrent, the photocurrent noise, the nonlinearity of the analog circuit and the A/D converter, and the temperature inaccuracy etc.

通过分析获得太阳入射角——光电流非理想的余弦特性、光电流的噪声起伏、处理电路非线性、A/D采样非线性、温度测量不确定性等因素导致的太阳矢量实际测量误差为5.74°。

Taste cells are cultured on the LAPS chip for several days and then the change of extracellular signals can be detected by measuring the change of LAPS photocurrent. Compared with MEA and FET array, LAPS chip is easier to fabricate and allows us to track taste cells cultured randomly and locate it to desirable site taking advantage of light-addressability of LAPS.

与MEA和FET阵列芯片相比，LAPS芯片不仅制各工艺简单，而且其光源可移动寻址，方便对芯片表面随机培养的细胞进行跟踪定位，克服了MEA和FET阵列芯片固定检测位点几何特性的限制。

Influence factors on semiconduction properties of oxide films on a cupronickel electrode in the simulated water was studied by cyclic voltammetry and photocurrent response method.

用动电位伏安法和光电化学方法对模拟水中白铜B30耐蚀性影响因素进行了研究。

AlN MSM devices were fabricated on AlN epitaxial thin film deposited on GaN/Sapphire substrates using helicon sputtering system at the low temperature of 300°C. The device characteristic was found to be improved by in situ metallization of Al electrodes. The extremely low dark current (1.39pA at 20V), the ideal factor (1.0125) and the Schottky barrier height (0.916eV) are superior compared to those of AlN MSM in the literature. When the device was illuminated by the 150W D2 lamp, the ratio of the induced photocurrent to dark current is more than 2 orders of magnitude. The illumination effect also shows the linear relationship between the radiation power and the photo current for the MSM devices, indicating the potential applicability for deep UV sensors.

氮化铝金属-半导体-金属光侦测器则是用In situ metallization制程，利用低温回旋溅镀法在氮化镓/蓝宝石基板上沉积之氮化铝，再直接溅镀金属铝作为指叉电极，比较目前文献制作出来的氮化铝MSM元件，可得到很好的元件金半接面之理想因子1.0125，算出萧特基能障高度为0.916eV，并有很低的暗电流为1.39 pA，提升了元件的特性，使用150 W氘灯入射，光暗电流差距可到两个order，且元件之光电流与入射光功率呈线性，显示所制作之氮化铝MSM元件，很适合针对深紫外光波段侦测。

The improvement of the determined equipment was including:(1) adoption of the 635nm laser lamp-house whose homochromatism is good;(2) continual feeding device used the auto-feeding device based on the gravity potential energy theory;(3) absorbing pool is the 126μL micro- absorbing pool;(4) signal sensor used silicon electric eye;(5) the photocurrent signal was amplified by single route.

其中对检测装置的改进主要包括：(1)采用单色性良好的635nm的激光光源；(2)连续进样装置采用重力势能原理自动进样器；(3)吸收池采用126微升微量吸收池；(4)信号检测器采用硅光电池；(5)对光电流采用单路信号放大。

The photocurrent density increases exponentially with the incident light power. After every kind of pixel unit circuit was introduced, the new pixel unit circuit for BJPHGT was brought forward and its noisiness was analyzed.

介绍了CMOS图像像素采集单元的各种电路形式，提出了针对双极光栅晶体管的新型像素单元电路并对其噪声特性进行了分析。

Strong photocurrent signals are observed for the QDIPs under the normal incidence condition at the temperature of 77 K.

在77 K时，这些器件在垂直入射条件下观察到了很强的光电流信号。

The calculated positions of several photocurrent peaks are in good agreement with the experimental results.

理论计算出的几个光电流峰位置与实验测量的结果符合较好。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。