查询词典 penetration depth

To create a unitized rapid method to measure the chloride penetration resistance of concrete, the influence of test duration and electrolyte solution on the charge passed and depth of chloride penetration of concrete were studied.

为了建立统一的混凝土抗氯离子侵入性快速试验方法，进行了通电时间和电解质溶液对混凝土电量值及氯离子渗透深度影响的研究。

Answer: Shoots the frequency wave is the wave band is the 40.67MHZ electromagnetic wave, causes through the different technique to shoot the frequency wave penetration surface layer base first floor the melanophore, depth of penetration 2mm-20mm, resonates the principle through a minute small water-kettle to cause the organization to heat up to the threshold value temperature 65 ℃-75 ℃, both affects to the collagen organization, and may affect to the fat, achieved dispels wrinkles the skin, dissolves the effect which the fat loses weight, does not have any damage to the epidermis.

答：射频波是波段为40.67MHZ的电磁波，通过不同的手法使射频波穿透表层基底层的黑色素细胞，穿透深度2mm-20mm，通过分水子共振原理使组织加热至阈值温度65℃-75℃，既作用于真皮层胶原组织，又可作用于脂肪，达到祛皱紧肤、溶脂减肥的功效，对表皮无任何损伤。

A trace is automatically recorded of the resistance of the elastomer to penetration and the depth of penetration.

弹性体对于穿透的阻力和穿透深度曲线自动记录下来。

Analysis of ultimate penetration depth of suction caissons in sand.

砂土地基中吸力式沉箱的极限沉贯深度分析。

While laser welding can improve productivity [1, 2] through increasing penetration depth in the root pass so that the area of groove to be filled can be reduced, technologies have been developed to modify the conventional GMAW (the most widely used process for fill-up) to achieve higher deposition rate so that grooves can be filled in fewer passes or at a higher travel speed.

而激光焊接可以提高生产率[ 1 ， 2 ]通过增加渗透深入的根通，使该地区的槽来填补可以降低，技术已经发展到修改常规气体保护焊（最广泛使用的进程填补行动），以实现更高的沉积速率，这样可以填补沟槽较少通行证或在较高的旅行速度。

This analytical approach shows that, as increasing the wear flat of indenter, the maximum indentation force needed to develop critical plastic zone increases and its corresponding critical penetration depth also increases slightly, Note that the effect of wear flat will affect rock fracture behavior. In addition, regarding the simulation of the effect of doubled-indenters, result shows that two adjacent indenters may interact each other as reaching the transient/critical relative space between indenters of 2~3. It dicpicts that a proper spacing arrangement between indenters may enhance a efficient mechanical cutting due to the less required maximum indentation force and energy dissipation.

由数值模拟之结果得知，当楔尖磨耗增加时，岩材产生脆性破坏之初裂贯切力随之增加，而其对应之临界贯入深度则亦微幅增加，故磨耗效应确会干扰岩材脆性破坏机制之形成；而由双刀效应之模拟，可知两贯切刀楔互制影响之破坏裂缝生、衍行为，当双刀相对刀距为时，岩材之破坏特徵有明显变化，即定义此为临界相对刀距，并探讨其产生脆性破坏所需初裂贯切力之变动范围及应力重叠区，由此得知适当之刀距安排将有助於减少能量之耗损。

To validate the above conclusion, a series of mixture tests were performed and different samples were made by mixing each of three kinds of nature silt and the nature clay with different mixture ratio. The liquid-plastic limits of all the samples, in which the clay particles content were between the nature silt and the nature clay, were attained using the combined test method. The results showed that the lowest clay particles content of the silt, when it was suitable with the combined test method, is 12% to 15% with little differences. If the point of 3～4mm depth of penetration of fall cone exist, and the loglog relationship between the depth of penetration of fall cone and the water content of all the points were clearly linear, it could be concluded that the clay particles content of the sample is over the lowest value when the combined test was suitable.

3其后为了进一步验证所得结论，针对三种粉土，分别与一种黏粒含量较大的天然黏土进行多种组合的配比试验，配比后的土样其黏粒含量均介于原粉土与原黏土之间，并对各种配比后土样进行联合测定法确定液、塑限的试验研究，得出各种土对联合测定法适用的最低黏粒含量限值因粒径组成不同、矿物组成不同等因素，存在微小差异，在12%到15%之间；当圆锥下沉深度在3～4mm之间的试验点存在，且与其他试验点之间能形成良好的双对数直线关系，即认为土中黏粒含量超过该土对联合测定法适用的最低限值，联合测定法适用。

The projectile velocities of the model experiments and the prototype experiments are not proximal, so a grey pre-estimation model of maximum penetration depth is established.

由於模型试验的弹速不够接近原型试验的弹速，在模型试验数据处理中引入了灰色系统理论，建立了最大侵彻深度灰色预估模型。

The shift in the peak extinction wavelength and the change in the corresponding intensity of the LSPR band as a function of the refractive index of the solution are 71 nm/RIU and 0.21 a.u./RIU, respectively. The penetration depth of the electromagnetic field excited by LSPR upon the response of the sensing film is estimated to be about 16 nm.

研究结果表明，所制备的LSPR传感膜粒子分布均匀、单分散性好、稳定性高、重现性好；消光峰位对样品溶液折射率的检测灵敏度为71 nm/RIU，相应的峰强检测灵敏度为0.21 AU/RIU，对表面吸附层的渗透深度约为16 nm。

Based on the research of thaw time and RF and penetration depth of frozen Spanish mackerel, the experiments results validated RF thaw method if superior to microwave thaw and other usually used methods.

本实验对冷冻水产品的复合相介电常数模型、实部和虚部进行了分析研究，在分析研究冷冻鲅鱼的解冻时间、射频穿透深度的基础上，通过实验验证了射频解冻的质量优于微波解冻和一般常用的解冻方法。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。