查询词典 partial pressure

Sodium vapor lamp in which the partial pressure of the vapor during operation does not exceed 5 Pa - for example a SOX lamp.

工作时，灯内局部气压不超过5Pa的钠蒸气灯，例如SOX灯。

The dissolve of tin in slag tended to bemore affectively by oxygen partial pressure.

相比之下，锡的氧化溶解更容易受到氧分压的影响。

In the present study, tungsten oxide nanomaterials were synthesized by a modified plasma arc gas condensation technique. The effects of the plasma currents (70~90 A), chamber pressures (200~600 torr), production time（3~12 min）, oxygen partial pressure Ar:O2（1~6:1）and plasma including the hydrogen（0~10 %）on the preparation of tungsten oxide nanostructures were investigated. Pre-treatment on the tungsten oxide nanorods for surface modification was investigated by atmospherical plasma jet. The optical, filed emission, and gas sensing characteristics of tungsten oxide nanopowders were also examined.

本研究系利用电浆电弧气凝合成法来制备氧化钨奈米材料，分别探讨不同腔体压力（200~600 torr）、电浆电流（70~90 A）、制备时间（3~12 min）、氧分压Ar：O2（1~6：1）、电浆气含氢量（0~10 %）对於产物的形貌、相态影响，并使用常压低温电浆设备对氧化钨奈米棒进行表面处理，且针对氧化钨奈米材料的光学、场发射以及使用自行组装气体感测量测设备量测其气体感测特性。

Preparation of the cathode includes:shaping under the press of 40Mpa, sintering at 550℃for 1 hour and at 900℃for 8 hours and threading with molybdenum bar; Considering the literatures we choose CaCl2 as salt for preparation titanium. Pretreatment of salt is for 1 hour at 100℃and for 2 hours at 300℃. Partial pressure of oxygen which need lower than 5.11×10-7Pa to reduct titanium oxides and hygroscopic property of salt need a sealed equipment to electrolyse. And finally successfully designed a satisfied one and the results show that the equipment can be satisfied the requirment of the experiment. Flow of the inert gas is 1.5L/min, the voltage is 2.8 V, temperature is 850℃and time is 2 hours during pre-electrolysis. Flow of the inert gas is 0.2L/min, the voltage is 3.1 V, temperature is 900℃and time changes with the mass of TiO2 during electrolysis, namely the greater need the longer time; To eliminate influence of salt and other impurities, the products need to wash with distilled water and dilute chlorhydric acid , then wash with dilute hydrochloric acid under supersonic wave assistant. Finally, electrometical properties of the electrolysis of TiO2 is researched by cyclic voltammetry and chronoamperometry, and results show that there are two main reodox steps, namely from TiO2 to TiO and from TiO to Ti.

阴极制备主要包括40MPa压力下模压成型、两段式烧结(1小时内升至550℃保温1小时，再1小时升温至900℃保温8小时)及烧结后TiO2块打孔用钼棒串接三个主要环节；实验中选用CaCl2作为电解熔盐，并对其进行预处理(100℃，保温1小时； 300℃，保温2小时)；经热力学计算，还原钛氧化物的氧分压至少要低于5.11×10-7Pa，结合电解过程中所用熔盐CaCl2有极强的吸水性的特点，电解装置应有较高的密封性，自行设计了一套密封性可靠的电解装置，便于实验过程中熔盐预处理和氧分压的控制；通过干燥处理预电解过程中Ar流量大约为1.5L/min、电压为2.8 V、温度为850℃、时间为2小时，电解过程中Ar流量大约为0.2L/min、电压为3.1V、温度为900℃，实验结果表明电解时间与TiO2质量密切相关，质量越大需要电解的时间越长；通过自来水冲洗—稀盐酸浸泡、洗涤—在超声波辅助作用下稀盐酸洗涤，可减少熔盐及其它杂质对电解产物检测结果的影响；最后，通过循环伏安法、计时电流法对电解机理的研究，确定电解还原TiO2制备金属钛主要经历了TiO2-TiO-Ti的过程。

Firstly, it is difficult to densify CeO2 based solid electrolyte materials and a sintering temperature above 1600℃is required to prepare dense CeO2 based solid electrolyte materials by the conventional solid-state reaction method;Secondly, doped ceria are brittle materials and have weak mechanical strength, which would be susceptible to fracture due to thermal stresses and mechanical stresses during cell fabrication and operation; Thirdly, electronic conduction will be introduced because of the reduction of Ce4+ under low oxygen partial pressure, which would reduce the output voltage and output power of the cells.

其一，CeO_2基电解质材料难以致密化，用常规的固态反应法制备的CeO_2基电解质粉体需要在1600℃以上烧结才能达到致密化；其二，CeO_2基电解质为脆性材料，机械强度低，使其容易在电池的制造及运行过程中由于热应力及机械应力而破裂；其三，CeO_2基电解质在燃料极一侧由于Ce4+还原为Ce3+出现电子导电，降低电池的输出电压和输出功率，影响电池的性能。

After the oxidative polymerization of DMP,styrene was in-situ polymerized under the initiation of dibenzoyl peroxide and dicumyl peroxide,finally thermodynamically compatible PPO/PS alloy was prepared.When styrene content was 50 wt%,for the synthesized PPO/PS alloy the yield and the weight-average molecular weight were determined to be 95%and 1.7×10~5 for PPO,93%and 2.0×10~5 for PS,respectively.The influence of the concentration of DMP and catalyst,molar ratio of N/Cu, oxygen partial pressure,NaOH concentration and temperature on the initial polymerization rate(R_0) of DMP was studied.It was found that the initial polymerization rate of DMP increased with the concentration of DMP and catalyst. The initial polymerization rate increased with the molar ratio of N/Cu at first and then decreased.

通过测定DMP氧化聚合过程中氧气吸收量随时间的变化，研究了DMP和催化剂浓度、N/Cu摩尔比、氧气分压、氢氧化钠浓度及温度对水介质中DMP氧化聚合初始速率的影响，发现DMP氧化聚合初始速率与氧气分压的0.1次方成正比；DMP氧化聚合初始速率随DMP和催化剂浓度及温度的增加而增加；随氢氧化钠浓度和N/Cu摩尔比的增加DMP氧化聚合初始速率先增加后降低。

The electrical conductivity and thermal expansion of La2Mo2O9 under low oxygen partial pressure were studied with the help of thermoelectric power and dilatometric measurements, respectively.

通过热电势和热膨胀测量，分别研究了La2Mo2O9在低氧分压条件下的电学性质和热膨胀行为。

If the partial pressure of oxygen decreases by 5% or more or by 4 mm Hg [0.5 kPa] or more when the patient moves from a supine to an upright position, or if the patient has worsening dyspnea related to further ventilation perfusion mismatch, then hepatopulmonary syndrome may be the problem.

如果当病人从仰卧位变为直立位时氧分压降低大于等于5%，或者降低大于等于4 mm Hg （0.5 kPa）--直立性低氧血症--或者病人由于通气灌注障碍导致呼吸变得更加困难，都可能是肝肺综合征造成的问题。

Partial pressure of arterial oxygen was positive correlation to lung compliance and negative correlation to intrapulmonary shunt.

俯卧位和旋转体位能改善ALI肺的顺应性、减少肺内分流，改善氧合；但俯卧位比旋转体位安全并能减少TNF-α的产生。

Objective To investigate oxygenic liquid effect on partial pressure of brain tissue oxygen (PbtO2),and prognosis in patients with severe head injury.

目的 观察对重型颅脑损伤患者脑组织氧分压的变化情况及氧合液对变化的影响及临床意义方法选择重型脑损伤患者（GCS计分3～8分）80例。

The concept of equivalent rotationally rigidity is offered and the formula of rotationally rigidity is obtained.

主要做了如下几个方面的工作：对伸臂位于顶部的单层框架—筒体模型进行分析，提出了等效转动约束的概念和转动约束刚度的表达式。

Male cats normally do not need aftercare with the exception of the night after the anesthetic.

男猫通常不需要善后除了晚上的麻醉。