查询词典 parameters

PSO is a population-based optimization algorithm, which mimics the social behavior of animals in a flock. It makes use of individual and group memory to update each particle position allowing global and local search optimization. The objective function considered was the total weight of the structure subjected to stresses, displacements and forces constraints. The effects of the parameters were investigated as well and such combination of tuning parameters promote a better global search behavior avoiding premature convergence while rapidly converging to the optimal solution. Results showed the effectiveness of the proposed method by comparing with ANSYS Design Optimization Tool (zero-order method). The PSO with the tuning parameters makes it an ideal method for offshore wind turbines foundations optimization tasks.(2) A reliability analysis method for pile foundation bearing axial loads based PSOThe performance function of pile foundation's axially bearing capacity sometimes is nonlinear and complex, on the basis of geometric meaning of structural reliability index, an optimum model with PSO for structural reliability analysis under arbitrary random variables was established, The PSO algorithm is very efficient to solve global optimization problemsIts use in structural reliability field presents not only the advantage of its facility of implementation, but also the possibility to obtain the design point and the failure probability with a good accuracy. In addition, PSO is a zero order algorithm, for no derivative is necessary for its implementation.

本文的研究针对桩式海上风机基础结构的特点，在国内外有关研究成果的基础上对海上风机基础结构优化设计理论和可靠度方法一些相关问题进行了较为深入的研究，具体做了以下几个方面的工作：(1)基于粒子群优化的桩式海上风机基础确定性优化设计方法桩式海上风机基础的优化设计是一个复杂的、非线性约束的优化问题，针对传统的基于梯度信息的优化方法在处理非线性问题中易陷入局部最优解的问题，本文将一种耦合惩罚函数的PSO算法引入到海上风机基础结构概念设计中，PSO算法是从群体动物聚集觅食这一活动中受到启发而发展的，该算法利用个体和群体的信息共享不断改进自身的位置从而进行局部和全局最优搜索，本文中以桩和三脚架连接段直径及壁厚为设计变量，以基础总重量作为优化的目标函数，在给定的约束条件下建立了三脚架基础优化数学模型，另外本文还研究了PSO参数变化对结果的影响，协调的参数组合可以避免陷入早熟收敛而能够快速的获得全局的最优解，通过与ANSYS优化模块的计算结果比较验证了该方法的有效性，本方法为海上风机基础的确定性设计提供了一条有效的途径。

Based on description method of damping motion in mechanical vibration, variables movement of generator are divided into two basic motion models: damping oscillation and critical damping motion. Detail methods of extracting damping parameters from simulation data is introduced to establish variable motion models. An approximate method is put forward to simulate low-frequency signal and generator response characteristic, from which motion models and damping parameters of main variables are obtained. The influences of oscillation amplitude, frequency and initial operating point of power system to the motion damping parameters are analyzed.

借鉴机械振动中阻尼运动的描述方法，将低频振荡下发电机主要变量的运动归纳为阻尼振荡和临界阻尼两种基本运动形态；介绍了从仿真数据提取阻尼参数建立参数运动模型的方法，实现对发电机振荡特性的量化分析；提出一种系统侧低频振荡信号的近似模拟方法，并应用于发电机响应仿真，获得了主要变量的运动模型和阻尼参数；分析了系统侧振荡幅度、频率以及初始工况对发电机功角振荡的影响。

The variation regularity is discussed that the stress, temperature and deformation of the current-carrying annular plate are altered with the variation of loaded electromagnetic parameters. According to the relation between the deflection of annular plate and the parameters, it is proved that the deformation and stress can be controlled by changing the electromagnetic and mechanics parameters.

变换电磁参量，讨论了载流环形薄板应力、温度及变形随外加电磁参量的变化规律；根据圆环形板的挠度与参量之间的变化规律，并通过实例证实了可以通过改变电、磁、力场的参数来实现对板壳的应力、应变状态的控制。

By using the group-chain, the wavefunctions of the 4f〓 configuration for RE ions are also expressed as linear combinations of group-chain basis functions in Butler's irreducible representation notation. The matrix elements of the CF Hamiltonian then are calculated by means of the Wigner-Eckart theorem and factorization lemma of the jm factors. Before the CF level fitting, a point-charge calculation of the conventional CF parameters B〓 has been performed by means of the lattice-sum technique from the known crystal structure data. The corresponding parameters in the group-chain are calculated by the conversion relationship between two schemes that proved identical in essence, which are usually used as initial values in the fit to the experimental levels. The ratios of the same k-value CF parameters are suggested as the constraint conditions in the fit, in order to utilize fully the symmetry distortion degree of the studied system.

利用群链理论，属稀土离子4f〓组态的波函数表示为以不可约表示标记的群链基波函数的线性组合；借助Wigner-Eckart定理和2jm和3jm因子的分解定律计算了晶场哈密顿的矩阵元；根据点电荷模型和已知晶体结构数据，利用点阵求和技术计算得到传统晶场参数B〓初值，相应的非传统形式的群链参数初值则由两种方案下的转换关系求得；这些初值通常作为非线性拟合晶场能级计算的初值，系统的对称性畸变信息则反映在以同阶晶场参数的比值作为能级拟合的约束条件。

The gross geometrical parameters, physical parameters and biomechanical parameters of femur diaphysis were measured.

实验发现：与对照组相比，实验组股骨的若干几何及物理参数发生了明显变化，表明应力环境可以改变活骨组织的成份和结构并逐渐改变其力学性能。

The data analysis shows that: 1 different texture parameters have a clear scattered distribution, 2 the main direction of texture is the direction represented by the maximum parameter of Gauss-MRF parameters, and 3 for those samples basing the same main direction, the finer the texture is, the greater the corresponding parameter is, and the smaller the other parameters are; and the higher the order of Gauss-MRF is, the more clearly the texture is described.

数据分析表明，各不同纹理特征参数之间具有明显的分布性；Gauss-MRF参数值最大的参数所表示的纹理集聚为向为纹理的主方向；对于纹理主方向相同的样本，纹理越细致，其相应参数越大，而其他参数越小；Gauss-MRF阶数越高，纹理描述越细致：在2阶Gauss-MRF模型情况下，弦切纹理的B1参数大于径切纹理的B1；弦切纹理的B2、B3、B4分别小于径切纹理的B2、B3、B4。

The system parameters are determined by optimizing an output-error cost function. To deal with the non-uniqueness of the fully parameterized state-space system, a projected gradient search algorithm is presented by restricting the update of the parameters to the tangent space to the manifold of observationally equivalent state-space systems. The sufficient condition to employ L-M algorithm for optimizing parameters is also introduced. The proposed hierarchical optimization identificationmethod includes two steps: First, the parameter search direction is determined by the proposed adaptive L-M projected gradient approach; Second, the optimum step size is computed according to a line search method.

通过极小化输出误差目标函数获得了系统参数估计；提出了正交梯度搜索方法用于解决系统参数的非唯一性问题，正交梯度搜索的本质是在输入-输出等价类相切平面的正交垂空间更新系统参数；给出了用 L-M 算法进行参数优化的充分条件；提出的系统参数递阶优化辨识方法包括两步：首先用给出的自适应 L-M 算子正交梯度方法确定参数优化方向；其次由一维搜索方法计算最佳步长。

From the mechanics analysis, the relationships between the configure parameters (such as the wheel parameters and the position of mass center) and the mobility performane indexes (such as the wheel sinkage, motion resistance and drawbar pull) are obtained. The design principles of the wheel parameters, position of mass center and the wheel space are given. It is demonstrated that the mass center is crucial to the mobility performance of the lunar rover.

通过对移动性能的分析，得到了构型参数和地形参数与下陷量、运动阻力、牵引力等性能参数间的关系曲线，给出了月球车车轮、质心位置和轮距等构型参数的设计原则，论证了质心对于月球车移动性能的重要性。

After the pertinence analysis of endoplasm parameters, designed an artificial neural network which built the training sample with grape images information and pericarpial pigment parameters and another artificial neural network which built the training samples with pericarpial pigment parameters and total acid, total sugar, soluble solids of sarcocarp. Using this combined module, realized the nondestructive measurement according to grape images information.

通过对内质参数的相关性分析，设计了由葡萄图像信息预测色素内质参数的人工神经网络及由果皮色素参数预测果肉总酸、总糖、可溶性固形物的人工神经网络模型，通过两个模型组合来实现根据葡萄图像信息进行采前无损检测的目的。

The mechanical parameters in the model are treated as random variables and it is then resolved with Taylor extension stochastic finite element method, The distribution characteristics of the pore pressure, the effective stress and the displacement are researched by treating the mechanical parameters of the rock as random variables. The sensitivities of the pore pressure, the effective stress and the displacement to the random mechanical parameters are also analyzed.

视模型中的参数为随机变量，采用Taylor展开随机有限元法对该模型进行数值模拟，研究参数具有随机性情况下耦合场中孔隙压力、有效应力，位移等场变量的随机分布特征及孔隙压力、位移等场变量对参数的灵敏度。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。