查询词典 parameters

To simplify the finite element analysis process of tower crane jib, the parameters modeling created by the rapid input to the key parameters to complete the tower crane jib analysis and calculation.

目的 利用参数化设计系统简化塔式起重机臂架有限元分析过程，创建参数化模型，通过对关键参数的输入快速完成塔机臂架的分析计算。

Three antioxidative parameters(SOD super oxide dismutase、MDA malondialdehyde and GSH reduced glutathione hormone)were also measured.Results:The skin elasticity and water content improved increasingly according to the MPA measurements of the two group 4 weeks after the last irradiation.The hydroxyproline of the skin in the Q-switched 1064-nm Nd:YAG laser of 0.6J/cm~2、1.5 J/cm~2 and 2.5 J/cm~2 group showed 7.1%,13.1%and 19.8%(p＜0.05)increase respectively compared to their controls,the enhancement of dermal thickness were 15.5%,29.7%and 38.4%;The hydroxyproline of the skin in the Q-switched 532-nm Nd:YAG laser of 0.5J/cm~2、1.2 J/cm~2 and 2.0 J/cm~2 group showed 6.9%,9.6%and 14.2%(p＜0.05)increase respectively compared to their controls,the enhancement of dermal thickness were 5.5%,15.1%and 29.9%,among which the Q-switched 1064-nm laser group had the greatest effect. The result of antioxidative parameters showed some juvenescence change at the radiated skin.

结果：末次照射后第4周，Q开关1064-nmNd：YAG激光组(以下简称1064 nm组)和Q开关532-nmNd：YAG激光组(以下简称532-nm组)大鼠各实验侧的皮肤弹性和含水量都明显好于对照侧；1064-nm组和532-nm组实验侧的皮肤羟脯氨酸含量和真皮内胶原厚度都较对照组显著增大(P＜0.05)，其中1064-nm组的三种不同能量密度：0.6 J/cm~2、1.5 J/cm~2、2.5 J/cm~2的激光照射的皮肤区域的羟脯氨酸含量增加率为7.1%，13.1%和19.8%，真皮厚度增加率为15.5%，29.7%和38.4%，532-nm组的三种不同能量密度：0.5 J/cm~2、1.2 J/cm~2、2.0J/cm~2的激光照射的皮肤区域的羟脯氨酸含量增加率为6.9%，9.6%和14.2%，真皮层厚度增加率为5.5%，15.1%和29.9%，相比而言1064-nm组的羟脯氨酸及真皮层厚度增加率均较高；抗氧化指标显示两组大鼠实验侧皮肤的抗氧化能力增加，呈年轻化改变。

Kinesis parameters and parameters of air state are displayed in data table, and all calculation results in micro every stage can be seen distinctly through it.

以数据表的形式给予运动参数及气体状态参数，通过该数据表，可清楚看到每一微段的计算结果

In the subjects given, learners operate an integrated simulator landing stage of flight data to meet the aircraft and instructors to give students hands-on consolidated results. And then for the visual route trilateral, quadrilateral, and five edge-to-landing phases, with 37 operators' experiments through interviews with senior instructors, the instructors selected seven simulator modules to assess and define the effectiveness of the actual operation of the parameters. Through the way of neural network learning , the establishment of the definition of parameters of simulator training with the students finished the cause and effect comprehensive results relationship, so this research create a set of objective assessment of the effectiveness of flight training simulation platform.

在给定同样操作课目之下，以学员操作落地阶段之模拟机综合飞行数据，配合学员实际操作飞机教官给予之综合成绩，再针对目视航线三边、四边及五边到著陆阶段，以37位操作者为实验，各选取七个模拟机数据，透过资深教官访谈，定义教官评量学员实际操作成效之参数，透过类神经网路的学习，建立模拟机定义参数与学员完训综合成绩的因果关系，如此即可建立一套可以客观评估飞航训练成效的研究模拟平台。

First of all, this study will be multi-walled carbon nanotubes by chemical oxidation process purified so it can be modified to deal with than the purification of purity before the modified 5 wt%, more than 1.89 times the surface area to increase the surface potential decrease of about 10 ~ 20 mV and the surface functional base (-COOH and-OH) to increase 1.45 times, and then the control technology of electroless preparation parameters include: analysis of plating time, plating analysis of temperature, metal ions in solution than the (Fe2+/ Ni2+), bath pH and the added value of dispersion Agent and other research towards Fe-Ni particles to increase the iron content and Fe-Ni particles spread in the MWCNT upper fixed targets,the results found that when the parameters for the preparation of 50 ℃, pH10, do not add dispersant, metal ions than the solution (Fe2 +/ Ni2 +) 7, the highest iron content can be Fe = 40.55 at%(flat iron content 111.17 mg / g) of nanocomposites Fe-Ni/CNT, then for a series of the nature of its analysis, the final evaluation Fe-Ni/CNT nanocomposites were processed on the effectiveness of the application of mixed pollutants, the results showed that in 120 minutes at the same time when Adsorption of heavy metal ions lead nitrate 10 ppm, selenium heavy metal ion degradation of 1 ppm and orange azo dye AO7 50 ppm standard of effluents, and after a total Fe-Ni nano-particles to SEM / EDS analysis of more than 50% still remaining.

本研究首先将多壁奈米碳管以化学氧化法做纯化改质处理能使其纯度较纯化改质前提高5 wt％、比表面积提高1.89倍、表面电位下降约10~20 mV以及表面官能基提高1.45倍，再控制无电镀技术之制备参数包括：析镀时间、析镀温度，镀液中金属离子比(Fe2+/Ni2+)、镀液pH值及是否添加分散剂等，研究朝提高Fe-Ni粒子的含铁量与Fe-Ni粒子散布固定在MWCNT上等目标进行，研究结果发现当制备参数为50 ℃、pH10、不添加分散剂、镀液金属离子比(Fe2+/Ni2+)7时，可得到最高铁含量Fe = 40.55 at％(单位铁含量111.17 mg/g)之奈米复合材料Fe-Ni/CNT，接著对其作一系列性质分析，最后评估奈米复合材料Fe-Ni/CNT对共处理混合污染物之应用效益，结果显示其在120分钟时能够同时吸附重金属硝酸铅离子10 ppm、重金属硒酸根离子1 ppm及降解偶氮橘色染料AO7 50 ppm达放流水标准，且共处理后奈米Fe-Ni粒子以SEM/EDS分析仍剩余50 %以上。

In Kuksin's the monograph, assuming the potential depends on n-parameters, he showed that the Schrodinger equation with Dirichlet boundary condition possesses many invariant tori for "most"(in the sense of Lebesgue measure) parameters.

Kuksin 在他 1993 年的专著当中表明，对于依赖于参数的势函数来说，满足 Dirichlet 边值条件的非线性薛定谔方程，对于大多数(在 lebesgue 测度意义下)的参数，存在许多不变环面。

The four different ERH/EMC models including the Henderson, Chung-Pfost, modified Halsey and Oswin equations were respectively used to investigate the fitting agreement of the measured data. Based on the comparison of the residual distributions, the coefficient of determination R2 values, the residual sum of squares SSE values, and the mean relative percentage deviation P values obtained from the regression analysis of six temperatures 20、30、35、40、50 and 60 ℃ tests, the Oswin model with two parameters and the modified Oswin model with three parameters all had the equivalent representative to the prediction of ERH/EMC values for the samples of lemon balm, and was also the best predicting models for the desorption isotherms of lemon balm.

试验时分别以四种平衡含水率模式，即Henderson、Chung-Pfost、修正Halsey与Oswin方程式，经由量测数据适称性之探讨，综合回归分析之残差图及决定系数R2值、残差平方和SSE值与平均相对偏差百分比P值比较后，获致在六个温阶20、30、35、40、50与60 ℃下，Oswin二参数模式与修正Oswin三参数模式皆具有相等的之平衡含水率与平衡相对湿度之适用代表性，可作为香蜂草去湿平衡含水率之最佳预测模式。

Clustering algorithm based on the fuzzy likelihood function was used to determine the structure and the premise parameters of the Takagi-Sugeno fuzzy model, which the conclusion parameters of the model was identified by least squares method.

基于模糊似然函数的模糊聚类算法确定模型结构和前件参数，并结合最小二乘法完成该模型后件参数的识别。

Based on AFCT, a new adaptive staring principle is established using floating threshold which is calculated by system reference model based on extrapolation method and linear regression algorithm. The principle of "forecasting model on line identifier"and"forecasting model parameters'selftuner"are put forward. In the module of"adjustment mechanism", the forecasting method of break points is introduced to fulfill control functions to "forecasting model parameters'self tuner".

本文详细讨论了针对输电线路主保护的自适应预测模型的建立方法，应用时间序列法和自回归模型或动平均自回归模型建立了精确反映保护对象状态量的系统预测模型，以自回归模型为例给出了"预测模型在线辨识"环节和"模型参数自适应校正"环节的算法，应用"适应机构"实现其对"模型参数自适应校正"环节的控制作用，应用并行计算算法实现了在继电保护中的"预测模型在线辨识"环节，使系统状态预测模型自适应于变化的电力系统。

The current research points out that for the CFCHS joints the linear extrapolation method can be used for chords,whereas the quadratic extrapolation method must be used for braces.The hot spot stress distributions on the CFCHS joints tend to be more uniform and their SCFs become smaller significantly,compared with the CHS joints.Axial tension on the brace puts the CFCHS joints at a disadvantage,which produces higher SCFs than axial compression.The effects of nondimensional geometric parameters β,τ and γ on SCFs of the chords of the CFCHS joints are basically the same as those of the CHS joints,but for the braces,there is a bit difference in the effects of parameters β,τ and γ between the two kinds of joints.Concrete has the function of improving the CFCHS joint rigidity and then decreasing SCFs which is expected to increase fatigue strength,but concrete strength grade does not exert significant influence on SCFs.

研究表明：CFCHS节点的热点应力，对主管可采用线性外推方法，对支管需采用二次外推方法；相比CHS节点，CFCHS节点的热点应力分布趋于均匀，SCF显著减小；CFCHS节点支管轴向受拉比受压不利，SCF增大；CFCHS节点几何参数β，τ，γ对主管SCF的影响效应与CHS节点基本一致，但是对支管SCF的影响效应与CHS节点有些差异；混凝土的作用主要是改善CFCHS节点刚度，从而降低SCF，并预期可提高疲劳强度，但混凝土自身强度等级的高低没有显著影响节点的SCF。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。