查询词典 parameter

In this paper,results of Markov chain are used under the circumstances of the automaton model which belongs to logical level of Discrete Event System to analyze the steady states and transient states of the Markov model of DES,respectively based on four conditions of discrete-time parameter and continuous-time parameter.A simpler decision rule of system ergodic property which applies both to the conditions of discrete-time parameter and continuous-time parameter is presented through an example.The transient states of DES which under the condition of continuous-time parameter are analyzed and computed based on Kolmogorov backward equation or forward equation.

利用马尔科夫链的结果，在离散事件系统逻辑层次的自动机模型基础上，对DES的Markov模型的稳态和暂态特性，分别从时间参数连续和离散的情况下，分四个情况进行了分析，通过实例对系统遍历性提出了一条更简单的且在连续和离散时间参数情况下都通用的判定规则，并利用Kolmogorov向后或向前方程，对连续时间参数DES的暂态特性进行了分析和计算。

In order to improve the reliability of the nuclear Generating Sets and the stabilization of the power system, prevent the long time low frequency oscillation caused by the disturbed of the outside electrical net, assured improving the stabilization margin of the nuclear generating sets in the precondition of enough transient stability, validate the sensitivity of the parameter to the damping of Generating Sets of the MEC5220 digital excitation adjustor produce in Japan that used in the Second Project of Qinshan Nuclear Power Plant, confirm the parameter rationality of the digital excitation adjustor, optimize the parameter of PSS, in this paper, we put up a in-depth study to the principle of MEC5220 digital adjustor produce in Japan by the PSS/E software that develop by the PTI Company in the USA, completed the modeling of the excitation adjustor, PSS, generator, excitor, described the performance of this excitation adjustor, analyzed the essential reason that caused the low frequency oscillation, illuminated the factor that influence the damping characteristic of the MEC5220 digital excitation adjustor. Based on model and emulate, this paper optimized the primary parameter of the excitation adjustor, make a reasonable regulation to the PSS parameter.

为提高核电机组的运行可靠性和接入系统的安全稳定性，防止在外电网的干扰下核电机组发生长时间的低频振荡，保证机组在暂态稳定的前提下提高其稳定裕度，验证秦山核电二期核电机组所配日产MEC5220型数字式励磁调节器参数对机组阻尼的灵敏性，确定数字式励磁调节器的参数的合理性，优化PSS整定参数，本文利用美国PTI公司研发的PSS／E软件对日产MEC5220型数字调节器的原理进行进行了深入细化的研究，完成了励磁调节器、PSS、发电机、励磁机的建模，描述了该型励磁调节器的性能，分析了产生低频振荡的根本原因，阐明了影响阻尼特性的因素。

By now you should have a fairly good idea of how to use the Parameter library.

到目前为止，你应该对如何使用 Parameter 库有了很好的掌握。

And the channel composed of the new radio induction system for communication is different from the parameter-constant channel and the traditional parameter-changing channel, its parameter is decided by the mutual induction between its antenna and induction-cable, by the location of its antenna, by the signal frequency passing through, its parameter has nothing to do with the time parameter. The channel composed of the new radio induction system is a new parameter-changing channel independently of time for communication.

而且，由新型无线感应系统组成的信道既不是恒参信道，也不是一般目前所知的变参信道，其信道传递函数的幅值只与信号的频率有关，与系统中天线和感应电缆之间的互感和天线的位置有关，而与时间无关，其信道传递函数的相位只与天线的位置有关，而与时间无关，由新型无线感应系统组成的信道是一种不随时间变化的新型变参信道。

So it holds a ideal ability to anti-interference and has 2 scalar level resolution in location and measuring velocity than traditional radio induction technology. And the channel composed of the new radio induction system for communication is different from the parameter-constant channel and the traditional parameter-changing channel, its parameter is decided by the mutual induction between its antenna and induction-cable, by the location of its antenna, by the signal frequency passing through, its parameter has nothing to do with the time parameter.

而且，由新型无线感应系统组成的信道既不是恒参信道，也不是一般目前所知的变参信道，其信道传递函数的幅值只与信号的频率有关，与系统中天线和感应电缆之间的互感和天线的位置有关，而与时间无关，其信道传递函数的相位只与天线的位置有关，而与时间无关，由新型无线感应系统组成的信道是一种不随时间变化的新型变参信道。

The method controls a whole operation process mainly through a PC, wherein the PC transmits a preset polarity parameter and an electric testing parameter to a PCI control module, and a light test parameter to a light test module, while the PCI control module transmits corresponding parameter signal to a polarity detection module and an electric test module; moreover, a fixture is started to carry out parameter testing, and then the data tested by the fixture is transmitted to the PC.

本发明主要是通过PC机来控制整个操作过程，其中PC机把预设极性参数、电测试参数传输给PCI控制模块，和由PC机把光测试参数传输给光测试模块，而PCI控制模块再把相应的参数信号传输给极性检测模块和电测试模块，并启动夹具进行参数测试，再把由夹具测试所得数据传输给PC机。

This algorithm incorporates the variation of quantize parameter into the mode decision, so as to adapt to various bit rate conditions.

算法设计过程中，充分考虑Quantize Parameter对模式选择的影响，从而可以适用于不同码率的环境。

First make the subjects give either right or wrong responses to the same question with different b value. When estimating the abilities of the subjects with the use of one-parameter or two-parameter Logistic model, it is found that there exists two kinds of unfits.(2) Estimate the abilities of the subjects after introducing c parameter on the basis of the two-parameter model. The first unfit can be rectified. However, the second unfit still exists and the third unfit appears.(3) Then estimate again after introducing y parameter. It is discovered that the second unfit is rectified, but the first unfit still exists and the fourth unfit appears.(4) Form Logistic four-parameter model by introducing c parameter and y parameter at the same time and estimate one more time. This model makes all kinds of unfits, including the first, second, third and fourth unfits, rectified.

1设计这批被试分别做对或做错一道b值不同的试题，用Logistic单、双参数模型对被试进行能力估计时，发现被试能力估计存在着两类失拟现象；(2)在双参数模型基础上增加c参数，对被试进行能力估计，发现c参数能有效纠正第一失拟现象，然而仍然存在第二失拟现象，同时还存在第三失拟现象；(3)在双参数模型基础上增加γ参数，再对被试进行能力估计，发现γ参数能有效纠正第二失拟现象，而仍然存在第一失拟现象，同时还存在第四失拟现象；(4)同时增加c、γ参数形成Logistic四参数模型，再对被试进行能力估计，这时该模型对各类失拟现象，包括第一、第二、第三、第四失拟现象都具有良好拟合能力。

The harm extent of Dendrolimus tabulaeformis and D. spectabilis were analyzed by fourteen forest factors, from which four significant ones were selected: crown density, altitude, average diameter at breast height and MLP. MLP is a new parameter suggested in this paper. It is better than diversity index to the harm extent, and it can indicate some information on not only the under story plant species diversity but the forest environment. Using the four key factors a multiphase linear regression model was made for risk analysis of the harm extent of pine caterpillar.

该文首次提出了林下植物喜湿度参数MLP(Moisture-Loving Parameter)，并用包括MLP在内的14个林分因子与松毛虫危害程度进行逐步回归分析，从中筛选出主林层郁闭度、海拔高度、油松平均胸径和林下植物喜湿度参数4个关键因子，与松毛虫危害程度之间均呈显著的负相关关系，并进一步用这4个因子与松毛虫危害程度建立多元线性回归模型，该模型可对松毛虫危害程度进行风险评估。

On this basic, we use intelligent decision technology based on case reasoning to NC cutting parameter decision and analysis. According the characters of NC cutting parameter decision, we take decision based on NC techniques rule, cutting case matching based on similar degree and cutting parameter correcting based on rules to design and realize system. Combining many field technologies, it makes a unique method to resolve NC cutting parameter problem. This design pattern is a new thinking for NC cutting parameter process.

在此基础上，本文将基于实例推理的智能决策技术用于数控切削参数的决策分析，根据切削参数决策判断过程的特点，分别按照基于规则的切削加工方案决策—基于相似度的切削参数实例匹配—基于规则的切削参数实例修正的设计思路进行了系统设计和实现，多个领域的技术紧密结合，形成解决切削参数难题的独特方法，开辟了数控切削参数处理的新思路。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。