查询词典 paraffine

By 16S rRNA. When it was cultured in MMSW substrate, adding MWFO and SWFO as the carbon source, it could produce crude biodemulsifier of 4 g/L and 3.5 g/L respectively. Compared with biodemulsifier produced by paraffine as the carbon source, both of them could achieve higher demulsification ratio in breaking W/O and O/W model emulsion.

的一株破乳剂产生菌，在以废弃油脂MWFO、SWFO为碳源培养下，得到的生物破乳剂的粗重为4 g/L、3.5 g/L；对于W/O、O/W模型乳状液的破乳效果均可超过以液体石蜡产生的破乳剂，且以SWFO废弃油脂培养得到的生物破乳剂可以同时应用于两种模型乳状液的使用。

Finally, based on the above research results, applying the visualization object-oriented programming technology VB language and "Anticipate Paraffin Deposition 2.0" which aims to predict the oil paraffine card by means of the indicator diagram, the paper realizes a highly effective diagnosis of oil pumping well.

最后，在理论研究成果的基础上，采用可视化面向对象编程技术VB语言和数据库技术开发了利用示功图预防油井蜡卡软件《Anticipate Paraffin Deposition 2.0》，实现抽油井高效诊断；成功应用于长庆油田部分油井的定性分析和定量诊断，取得了较好的效果。

The optimal production conditions are as follows: liquid paraffine warm-up temperature 80℃,reaction temperature 80~100℃,chlorine flow rate 80~100m3\h,reacting time 5.5~6.5h, adding 0.03% catalyst , 0.3% additive and 0.15% stabilizer .

确定了最佳的工艺条件：液蜡预热温度80℃，反应温度80~100℃，氯气流量80~100m3\h，催化剂用量0.03%，添加剂A用量0.3%，反应时间5.5~6.5h，稳定剂用量0.15%。

According to the evaluate and the sift through light paraffine isomerization catalyst,It showsthat preparated Pt-SO_4~(2-)/ZrO_2-Al_2O_3 catalyst achieved superior activity under the condition thatthe calcination temperature is 650°C、 concengtration of SO_4~(2-) is 0.5mol/L、 the content ofAl_2O_3 is 30% and content of Pt is 5%.

通过对轻质烷烃异构化催化剂的评价与筛选，表明所制备的 Pt-SO_4~(2-)/ZrO_2-Al_2O_3 催化剂在焙烧温度为 650°C 、SO_4~(2-)浓度为 0.5mol/L、第二金属氧化物组分 Al_2O_3含量为 30%，金属 Pt 含量为 0.3%时，该催化剂用于异构化反应效果最佳。

The stability of LEM served in magnesium ion extraction under the circumstance of WPA is studied. Taking N205 as surfactant, sulfonic acid as carrier, liquid paraffine as membrane intensifier, kerosene as membrane solvent and hydrochloric acid as well as sodium chloride as aqueous internal phase.

研究了以N205为表面活性剂，磺酸基络合剂为流动载体，液体石蜡为膜增强剂，磺化煤油为膜溶剂，盐酸加氯化钠为内水相的乳状液膜在湿法磷酸体系中捕获镁离子时的稳定性。

Thermoplastic etching is 7building, paraffine, bitumen, stearic acid, and prepared by adding a small amount of ofmaize-erosibility-erosibility powder create ink, print by thermal print, press the design pattern, squeegee the ink to the glass surface, forming a anti-erodibility film.

热塑性蚀刻丝印，是将石蜡、沥青、硬脂酸等所配制的粘合剂，加入少量的抗蚀粉调制成抗蚀印料，通过热印丝网版，按设计图样，把印料刮印至玻璃表面，形成抗蚀膜的。

The optimal production conditions are as follows: liquid paraffine warm-up temperature 80℃,reaction temperature 80~100℃,chlorine flow rate 80~100m3/h,reacting time 5.5~6.5h, adding 0.03% catalyst , 0.3% additive and 0.15% stabilizer.

对低正构烷烃液体石蜡生产合格的氯化石蜡提出内稳定设想，确定了最佳的工艺条件：液蜡预热温度80℃，反应温度80~100℃，氯气流量80~100m3/h，催化剂用量0.03%，添加剂A用量0.3%，反应时间5.5~6.5h，稳定剂用量0.15%。

Add the extracted liquid and superficial anaesthetic dyclonine to basal composition including zinc oxygenate,vaseline and paraffine and all compositions were mixed to be preparation wuhuangyihao.

选取中药五倍子、生大黄、三七和甘草，制备提取药物成分浓缩液，与氧化锌、羊毛脂、凡士林和石蜡油组成的基质混合并加入达克罗宁制备成品。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。