查询词典 paper-mache

As a result of a single copper paper products for it both coating is different: positive posive 20 grams (referred to as the coated surface), and reverse-engineered, posive only 1 gram (commonly known as uncoated surface) can be described as one side of a single copper-coated paper, the other side of the paper fibers, and fiber and coatings for water expansion coefficient of uniformity: fiber expands, and Coatings expands small.

由于单铜纸品的特殊要求，它两面的涂布量是不同的：正面涂20克左右，而反面只涂1克，可以说单铜纸的一面是涂料，另一面是纸纤维，而纤维和涂料对于水的膨胀系数不同：纤维的膨胀率大，而涂料的膨胀率小。

Korean paper craft community "Just Paper" and "One Piece Paper" are no exception to this.

韩纸工艺社区&只要书&和&海贼王纸&，没有例外。

The production of graphite seal, Huatai Paper of this seal is not used for four years to solve the paper on the replacement of vacuum roller machine under frequent maintenance shutdown One major problem, Events specializing in the production of arc-shaped roller, homogenate roller, roller curtain coating, calendering roll, chrome-plated copper guide roll, squeeze roll, rollers, plastic surface sizing roller, roller and other V-type roll, the production of steam-driven corrector, the electric device Tensioner, Manual Tensioner, watermark roller and packet network maintenance, the production of steam pad headbox, wind pressure cage, following paper machine technology, variety renovation, improve speed and assist users to develop products to help users to engage in equipment selection.

生产石墨密封条，此密封条华泰纸业用之四年未换，解决了造纸业上更换真空辊频繁维修下机停产一大难题，专业生产活动弧形辊，匀浆辊、门帘涂布辊、压光辊、镀铜镀铬导辊、压榨辊、托辊、施胶胶面辊、伏辊等各种辊类，生产汽动校正器、电动涨紧器、手动涨紧，水印辊及包网维修，生产汽垫式流浆箱，风压式网箱，承接纸机技术改造、品种翻新、提高车速，并协助用户一起开拓产品，帮助用户从事设备选型。

In order to maintain the blade of the sword cutter, extended service life, once the best cut-paper no more than 40 mm thick, and cutter on paper pressure should also be appropriate, and generally soft paper need pressure larger, harder materials require relatively little pressure.

为了保持刀片的锋利，延长切纸机的使用寿命，一次裁切的纸张最好不要超过40mm厚，而且切纸机对纸张的压力也应适当，一般较软的纸需要的压力大一些，较硬的材料需要的压力相对要小一些。

In the cutter in use and in order to maintain the blade of the sword cutter, extended service life, once the best cut-paper thickness should not exceed 40 mm, and cutter on paper pressure should also be appropriate, and generally soft paper need pressure larger, harder materials require relatively little pressure.

在切纸机使用中，为了保持刀片的锋利，延长切纸机的使用寿命，一次裁切的纸张厚度最好不要超过40mm，而且切纸机对纸张的压力也应适当，一般较软的纸需要的压力大一些，较硬的材料需要的压力相对要小一些。

Bathroom Tissue /Toilet Paper Roll, Jumbo roll Toilet Paper, N folded Hand towel, Multifold, V/ Single Fold, Kitchen Towel / Hand Towel, Hand Roll, Center feed Hand Roll, Dinner Napkin, Dispenser Napkin, Luncheon Napkin Pocket Tissue, wallet Tissue, Facial Tissue, and all kinds of Tissue Paper products.

威得利实业有限公司是一家主要从事生活用纸的开发、生产与销售的企业，销售网络遍布全球二十多个国家。公司产品以小卷纸巾、大卷纸巾、擦手纸巾、盒装抽纸巾、广告荷包纸巾、手帕纸巾、盘纸、西餐巾为『详细信息

The design of the dry-dock falling gate"s structure is researched, and integrates the disquisitions and analysis on the dynamic characteristics about dock gate, in order to make the cabin design more visualizing.(2) The emphasis of this paper is the influence of the water hole and gas hole in the tidal cabin and the influence of the drain of the air-operated cabin.(3) In this paper, the building method of the dry-dock falling gate"s parametric model is studied and the dynamic analysis is accomplished in ADAMS, furthermore, the rising-and-falling angle curve is drawn while the dry dock gate is rising and falling.(4) The paper is based on the apprehension of the past theories and researches about air-operated dry-dock falling gate, and is explicated by hydraulic rationales and rising-and-falling mechanical principles. This software is developed by inner programming language in ADAMS and VC. This design could shorten design cycle.

1研究了气控式干船坞卧倒门的结构设计，整合对卧倒门在海水中运动中的动力特性研究，使卧倒门的设计，特别使其舱格设计更具可视化；(2)重点讨论潮汐舱水孔气孔对卧倒门水上运动的影响，空气操作舱充排水对卧倒门运动的影响；(3)研究了气控式干船坞卧倒门仿真模型的参数化方法和过程，并在ADAMS中完成了系统的动力学分析，绘制出了卧倒门在起卧过程中的运动特性曲线；(4)通过对已有的气控式干船坞卧倒门的实验成果和成形理论的解读，在理解其起浮和卧倒机理基础上，应用VC和ADAMS二次开发语言进行设计软件开发，定制了友好的用户化中文人机交互界面，使设计人员可以方便快捷地对卧倒门门进行设计开发，缩短了设计周期。

This paper introduces the application of the computer monitor and control technique in the drive control system of paper machine, and puts forward a scheme of the master system and the slave system, the scheme and structure of hardware, key circuit used the slave system are discussed, the software system fit to the drive control system of paper machine is designed . In allusion to request of system,design the configure software and human-machine interface of the master system.

文中介绍了计算机监控技术在纸机传动控制系统的应用概况，提出了在纸机传动控制系统中上位机系统和下位机系统的设计方案，并对下位机系统的硬件方案、结构以及关键电路进行了分析，设计了符合纸机传动控制需要的软件系统，针对控制系统的要求，设计了上位机系统的组态软件和画面。

When embossing district zhaiyanzhen rubberand drum RADIUS plus the paper thickness is greater than the radius of embossing drum cylinder, paper margin rubber drum circle distance greater than the RADIUS for the imprint of the rollers, paper for the cylinder body relative to the surface of the cylinder of nano-imprint lithography drum slide forward, imprinted deformation and dot gain no significant adverse effects.

当不抬印区某处的橡皮滚筒半径加上纸薄不小于不抬印滚筒筒体半径时，纸张背背距橡皮滚筒圆心的间隔不小于不抬印滚筒筒体半径，纸张背背不绝不差于不抬印滚筒筒体暗地上后滑不静，这不差痕迹变形及网不背增不小无澄辉不良感化。

This paper puts forward a new Difference Group Query based on two query points, the methods in GNN query which define several query points in a MBR are not suitable for the specific Difference Group Query in our paper. In this paper, based on the algorithm in YFK-CNN, we use the definition of hyperbola, divide the query space into several sections to delete the unsuitable space, furthermore, we develop several asymptotes from the definition of hyperbola, simplify the hyperbola based filter strategy in the search space.

文章提出了一种基于2个查询点的差值聚合查询，基于单查询点的YPK-CNN，利用双曲线性质把查询空间分成几大部分，在此基础上计算出双曲线的渐近线以简化删减条件，直接删减掉不符合条件的搜索空间。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。