查询词典 paper joint

Only if the joint clearances are limited to within 0.02 mm can the displacement error of the paper-transferring grippers be controlled to within 0.1 mm.

运动副间隙只有严格控制在20μm以内，才能保证递纸牙运动轨迹偏差控制在100μm之内。

Numerical simulations of the mechanisms of the formations of the South China Sea cold and warm gyres under the joint effects of the wind stress and the coast lines are made in this paper by use of the Princeton University Ocean Model.

利用美国普林斯顿大学海洋模式对风应力和海岸线共同作用下的南海冷暖涡生成机制进行了数值模拟。

Grasping ability is a problem when the grasp posture of the robot is changing. This paper discusses grasping ability of the multifingered robot hand. Using screw theory and BP neural network optimize the joint angle of the finger, Seeking the best grasp posture that the multifingered robot hand can withstand the largest external wrench.

论文针对排爆机器人在作业时其姿态的不断变化对抓取爆炸物能力的影响，寻求有利于提高抓取能力的最优手指关节角，以及多指手在不同的姿态下能抓取爆炸物的最大重量，并得出抓取能力最差的位姿。

This paper deduces the calculation method and formula of bearing capacity of interference fit joint in plastic deformation according to the plastic theory and sets out the detailed calculating steps for computer programming.

根据塑性理论推导出在塑性变形状态下过盈配合联接承载能力的计算方法和计算公式。

L Servo motor and vacuum suck wind belt conveyer system control the joint of cardboard box and pass localization of paper, laminate error 0.5mm

l 伺服马达以及真空吸风皮带输送系统控制纸板内盒与过胶面纸的定位贴合，贴合误差±0.5mm

Stress concentration zones and the maximum value of thermal stress of the TiC cermet/iron joint brazed with Ag-Cu-Zn filler metal during cooling were studied in this paper.

本文研究了采用Ag-Cu-Zn钎料在1173K温度下钎焊TiC金属陶瓷与铸铁挺柱实际件时，在冷却过程中接头处的应力集中区和热应力最大值。

The gap element method is proposed in the paper for two kinds of problems, which include contact problem and gap joint problem. Elasticity contact problem falls into the category of unknown boundary value problems. It follows that the contact area and contact conditions or states can never be determined without special mathematical analysis, which is a very difficult work. The boundary conditions of the contact surfaces are deduced.

文中给出了间隙元法在空间可动部件接触问题中的应用，推导了其几何边界条件和力学边界条件，利用虚功原理推导了含间隙元弹性接触问题的有限元方程式，给出了其数值解法的迭代步骤，并指出了利用间隙单元进行分析的特点。

Furthermore, the paper proposed a new algorithm of joint power and rate control for the single cell CDMA system. The algorithm not only considers the quality of the channel and the limitation of total load, but also the traffic priority. So the model is more accurate to the practical system. In the algorithm, the user rate can be changed dynamically during the calling period.

对于单小区综合业务CDMA系统，本文提出了一种新的单小区联合功率、速率控制算法，它不仅考虑了信道质量的好坏、系统总负载限制，而且是基于业务优先级区分的，其模型更接近于实际系统，另外，在此算法中，用户速率在呼叫过程是可以动态改变的。

In this paper, linear accelerometer is used to sense the rotatory joint acceleration and a model is given to describe the sensed open loop resonance, and design criteria for stable and functional control law are also proposed.

摘要以利用线加速度传感器实际测量转动关节的加速度为基础，分析了机器人关节加速度反馈控制的开环模型，以及影响其闭环稳定性的主要因素；提出了闭环控制策略的设计准则。

The jump tool traces on joint surface after the removal of bead seriously affects the quality of tube, so this paper try to realize formation mechanism from varied standpoints.

另外焊珠刮除时接合面上还遗留的跳动刀痕对於管材之品质也有严重的影响，本研究亦尝试从各个不同之角度探求其形成的机构。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。