查询词典 oxidation-reduction

Compared with that of 3Cr13 alloy, the oxidation resistance of the composites containing 5 vol.％TiC particle was improved greatly at 850℃, but the improvement was relatively limited at 950℃. But the oxidation resistance of 1Cr18Ni9 composites containing 5 vol.％ TiC particle was obviously improved at 950℃, and at 850℃ the improvement is not large. The TiC particle can improve the oxidation resistance mainly was by developing the oxidation selectiveness of the Cr element as to change the phase constitution of the oxidation film, to alleviate the production of the stress in the oxidation film and to improve the cohesive force of the oxidation film or matrix interface and the chemical combination of the oxidation film.

与3Cr13合金相比，含5％volTiC颗粒的复合材料在850℃的抗氧化性能得到大幅度提高，而在950℃复合材料的抗氧化性能提高作用却是有限的；与1Cr18Ni9合金相比，含5％volTiC颗粒的复合材料在850℃的抗氧化性能略有提高，而950℃复合材料的抗氧化性能提高却是明显的；TiC颗粒可以提高两种基体合金抗氧化性能，主要是通过促进Cr的选择性氧化，进而改变氧化膜的相组成、减缓氧化膜内应力的产生、增加氧化膜/基体界面凝聚力及提高氧化膜化学结合力而实现的。

With the raw material and the particle size of reducing agent narrowed, the percent reduction of strontia increases.(6) With the barbecuing pressure increasing, the percent reduction of strontia increases, after the certain value, the percent reduction of strontia decreases instead.(7) With reduction temperature increasing, the percent reduction of strontia increases.(8) The percent reduction of strontia is increasing with prolonging reduction time. In this experimental condition, it will become steady after 2.5h.

通过实验研究确定以SrCl_2-SrF_2-SrCO_3的纯锶盐体系作为电解质，实验中还采用了我们最新研制的熔盐电解监控仪对电解过程进行测量和系统的研究，得出以下结论：(1)增加电流强度，反电动势亦随之增加，而升高温度反电动势则有所降低；(2)随着电流密度的升高和电解时间的延长，电流效率逐渐增加，达到峰值后稳步下降；(3)延长电解时间，合金中锶的含量逐渐增加，最高可达18.1％；(4)开始电解后，反电动势逐渐增加，但向熔体中加入SrCO_3后，反电动势明显降低，因此认为在正常电解时是SrCO_3在分解。

In the paper,the transmission of designed roller oscillating tooth reduction gear adopts osci llating tooth gear drive without exception,one-stage reduction gear and two-stage reduction gear have joined through spline coupling band;The joining way of shock wave thellomble and oscillating tooth adopts the biserial bearing of without inner ring of needle bearing,and directly adopts bearing outer ring as shock wave thellomble;Center wheel of two-stage reduction gear and center wheel of two-stage reduction gear passes through taper thread,and center wheel is fixed;As soon as the flange of input end and center wheel of one-stage reduction gear,the flange of export end and center wheel of two-stage reduction gear makes monobloc structure.

本文预设的井下减速器的传动均采用活齿传动，一级减速器的输出轴和二级减速器的输入轴通过花键联轴套联接；激波环与活齿的毗连方式采用能蒙受较大载荷的无内圈双列滚针不锈钢管，且直接采用不锈钢管外圈作为激波环；一级减速器的中心轮和二级减速器的中心轮是通过锥螺纹毗连的，且中心轮固定；一级减速器的中心轮与输入端的法兰盘，二级减速器的中心轮与输出端的法兰盘均做成整体的结构。

In the paper,the transmission of designed roller oscillating tooth reduction gear adopts oscillating tooth gear drive without exception,one-stage reduction gear and two-stage reduction gear have joined through spline coupling band;The joining way of shock wave thimble and oscillating tooth adopts the biserial bearing of without inner ring of needle bearing,and directly adopts bearing outer ring as shock wave thimble;Center wheel of two-stage reduction gear and center wheel of two-stage reduction gear passes through taper thread,and center wheel is fixed;As soon as the flange of input end and center wheel of one-stage reduction gear,the flange of export end and center wheel of two-stage reduction gear makes monobloc structure.

本文设计的井下减速器的传动均采用活齿传动，一级减速器的输出轴和二级减速器的输入轴通过花键联轴套联接；激波环与活齿的连接方式采用能承受较大载荷的无内圈双列滚针中国财经圈，中国财经圈，且直接采用进口中国财经圈外圈作为激波环；一级减速器的中心轮和二级减速器的中心轮是通过锥螺纹连接的，且中心轮固定；一级减速器的中心轮与输入端的法兰盘，二级减速器的中心轮与输出端的法兰盘均做成整体的结构。

If by means of a prereduction MRI or after neurologic deterioration during closed reduction, the surgeon becomes aware of a fragment of disc material displaced into the spinal canal, then an anterior discectomy, open reduction, fusion, and plating becomes necessary.2,7,9 In approximately half of the cases, a closed reduction will be successful in reducing the dislocation before surgery.50 In the majority of the others, an intraoperative reduction performed after the discectomy and decompression will achieve anatomic reduction.9,51 For those patients in whom an anterior discectomy and decompression have not been successful in reducing the dislocation, then a supplemental posterior open reduction should be performed.52

假如借助MRI检查，或在闭合复位过程中神经症状进一步加重，外科医生意识到有椎间盘碎片突入了椎管，此时就需要前路椎间盘切除减压、开放复位和固定融合。大约有一半的病例手术以前能够通过闭合复位来成功的将脱位复原，剩下的病例则需要在术中将椎间盘切除减压来达到解剖复位。假如有病人经过前方的椎间盘切除和减压后仍然不能成功的还原脱位，则需要再行后方的开放复位术。

The four methods, air oxidation, DMSO/H_2O oxidation, potassium ferricyanide oxidation, Cu~(2+) oxidation and H_2O_2 oxidation, were used to promote the formation of disulfide bond in octreotide at different concentrations.

分别采用空气氧化法、铁氰化钾氧化法、DMSO氧化法、Cu~(2+)氧化法和双氧水氧化法对不同浓度的还原型奥曲肽进行了氧化实验。

The iron pyrites formation and the curing product's oxidation caused the oil quality combustion principle to the storage tank to carry on the theoretical analysis, the temperature tendency change rule and the influence iron pyrites oxidation tendentious factor carried on the system and the thorough experimental study to the iron pyrites oxidation process, in the union petroleum processing and the storage and transport process actual situation carries on the analysis and the discussion to the oxidation rate influencing factor, under the plan dissimilar condition the curing product oxidation heating curve.

对储罐中硫铁化物的形成和硫化产物的氧化引起油品燃烧的原理进行了理论分析，对硫铁化物氧化过程中温度的动态变化规律和影响硫铁化物氧化倾向性的因素进行系统而又深入的实验研究，结合石油加工和储运过程中的实际情况对氧化速度影响因素进行分析和讨论，绘制不同条件下硫化产物氧化升温曲线。

To assess the thermal contribution from oxidation reaction, the standard formation enthalpes of all reactants and products were used to calculate the oxidation enthalpies. It could be found that all oxidation reactions were exothermic. And oxidation played a more important role during the toluene trinitration at high temperature, because the reaction temperature of toluene trinitration is the higher than mononitration and dinitration, and the temperature coefficient of oxidation is higher than that of trinitration too.

为了考察不同阶段氧化副反应对反应放热的贡献，用反应物和产物的标准生成焓推得氧化反应的理论反应热，计算结果表明，各段硝化的氧化副反应均为放热反应，其中三段硝化反应由于反应温度最高，氧化反应的温度系数比硝化反应高，故氧化副反应对三段硝化影响最大。

Less severe inner oxidation of the bond coat of the irradiated TBCs is observed in many locations, where less oxidation products extended into the bond coat, and about 12 wt.% less oxygen in the thermal growth oxide than that of the as-deposited TBCs after cyclic oxidation at 1050 °C X1 h. The observation results are consistent with the result that the oxidation rate of the irradiated TBCs is lower than that of the as-deposited TBCs from the cyclic oxidation curves at 1050 °C X1 h.

在1050℃×1h循环氧化条件下，经HIPIB辐照热障涂层与原始样相比，仅有少数区域观察到比较严重的氧化和少部分氧化物伸入到粘结层内，形成TGO的氧质量百分比含量约低12%，与其氧化动力学曲线反映的经辐照样粘结层氧化速率低于原始样结果一致。

The mechanics of the oxidation-reduction method and the reduction kinetics characteristic of tungsten trioxide were studied.The oxidation-reduction method in this article is a quite new processs for preparing ultrfme tungsten powder.

本实验所采用的氧化—还原法是一种全新的工艺，是先将三氧化钨还原成钨粉，然后在空气中氧化成三氧化钨后再次还原，如此反复进行多次，则可得超细钨粉。

Green function defined inphase space differs from one in coordinate space by its struc-ture which exhibits nonlocatity in coordinates and oscillatorybehavior with respect to momenta.

在相空间中定义的Green函数不同于通常坐标空间的Green函数，在结构上显示出对坐标的高度非局域性，而对动量则显示出振荡行为。

The upper front part of a saddle;a saddlebow.

前鞍桥马鞍前面的上部分；前鞍桥