查询词典 oxidation process

During the study of magnetite oxidation, a function for calculating the"equivalent osmosing thickness"of oxygen through the reacted product layer covered the unreacted part is put forward based on the oxidation process properties. It is this function that make the oxidation process model successful.

在球团矿内磁铁矿的氧化过程的研究中，作者针对磁铁矿粉氧化的特点，提出了磁铁矿颗粒表面生成的三氧化二铁产物层的当量扩散厚度的计算函数，将其引入全温度范围球团矿内磁铁矿的氧化过程模型，并获得成功。

The objectives of this paper were to investigate the simulation and design of continuous multiple-station rolling forming process for a U-Section Steel Bar by CAE software-DEFORMTM Due to the limitation of elements number using a short strip 120mm went through all the stations to simulate the real continuous rolling forming on factory The roller gap was fixed as 0 30mm roll speed was 20 rad/sec and progressive angles were all equal for each rolling process which were the formed angle divided by by the number of station Three rolling processes were selected with 6 9 and 12 stations respectively During simulation processes two cases occurred Case A the strip was through a single station Case B the strip across two stations Because the strip laterals side was stretched and twisted during the process The model of case B closer to the practical process than case A and the calculated stress and strain on the tip of U section for case A were lower than these for case B by up to 15% From the result of case B for each process the stress for 12-station process was smallest 9-station process second and 6-station process next Because less-station can save larger cost and forming time but the bigger stress and strain for 6-station caused wrinkles on lateral sides not found on 9-station and 12-station Therefore 9-station process was a more suitable design than 12-station process smaller stretched and twisted and stress The progressive angles for 12-station was 7 5?

本文主要是以DEFORMTM有限元素软体模拟U型钢片连续道次成型与单一道次成型以确认单一道次模拟的是否可取代连续道次模拟之研究。因DEFORMTM 软体对於网格元素上的限制故使用较短素材120mm通过所有的成型站以模拟工厂实际连续成形方法。辊轮间隙固定为0 3mm；辊轮转速为20 rad/sec；弯曲角度的方法为将成型角度平均除以成型站数。有三种辊轮成型方式被选择分别为6站，9站，与12站。在模拟的过程中有两种现象会产生 Case A，素材通过单一成型站。Case B，素材会通过两个成型站。因为在模拟过程中素材的两端会有拉应力与扭力。Case B的模拟比Case A像实际的制程，并计算应力与应变在U型断面的Tip部中可发现Case A比Case B低约15%。从Case B的每站的结果可以得知，12站的成型应力最小，9站次之，6站最后。

Interlayer oxidized zone can be divided accurately by Fe_2O_3, Fe_2O_3/FeO and U parameters. We can correct the field macroscopic color zoning by combining the macroscopic zoning and microscopic zoning. Univalent major elements components(Al_2O_3, SiO_2, K_2O, Na_2O) show remarkable activity at the process of interlayer oxidizing, their contents are variable and mingled in different zones and it can't be used in zoning. But we can speculate the developmental degree of interlayer oxidized zone and uranium mineralization according to the concentration trends and variation characteristics of sensitivity group, activity group and their ratios .(3)The comparatively steady elements such as lithiphile elements, sulfophile elements and high field strength elements change regularly at the process of interlayer oxidation except some radioactive elements. Trace elements and rare earth elements commonly enrich in thin rock clast such as mudstone, in which the enriched elements species are more than those in the whole rock, which indicate that the regeneration action in caulking matter are more deep than that in whole rock at the process of interlayer oxidation, and the reallocate intention of trace elements in main minerlized rock in Tuha basin are more intensive than that in Yili basin at the process of deposition ,diagenesis and later changes .

根据化学蚀变参数PC值和分离迁移位等将常量元素组分分为敏感组分组、活动组分组、次活动组分组和惰性组分组，不同组分可分别用于讨论层间氧化带低温地球化学中不同问题；敏感组分(变价元素组分Fe_2O_3、FeO)和U在层间氧化带中迁移富集规律明显，Fe_2O_3／FeOFe~(3+／Fe~(2+)比值具分带判别能力，配合U含量对层间氧化带进行较准确的分带，可克服野外宏观颜色分带偏差：提出Fe~(3+)／Fe~(2+)分带判别值在不同盆地、不同地段不同，除受氧化作用控制外，流体酸碱度不同也是重要因素的观点，对找矿实践有实际指导意义；活动组分(Al_2O_3、SiO_2、K_2O、Na_2O)在层间氧化作用过程中具有较明显的活动性，其含量值变化跳跃，在不同分带相互交织，不具分带指示意义；但利用敏感组分、活动组分及其比值在层间氧化带中的变化特征可推测层间氧化带发育的完善程度及其含矿性；次活动组分组(CaO、MgO、MnO_2)含量低，变化规律性差；惰性组分组(TiO_2、P_2O_5)含量低，活动稳定，可用来反映沉积物源特征。

Of the first oxidation stage of biliverdin for the first time, and found that the intermediate reactions existed during the further oxidation process of the oxidized product of biliverdin, and proposed a ECECE mechanism for the whole oxidation reactions.

发现了胆绿素氧化反应产物再氧化的中间过程及胆黄素的氧化反应，均为首次报道。并提出了胆绿素氧化的ECECE反应机理。

Because of the chief equipment and technic are mostly imported from the abroad presently. It is necessary to lucubrate oxidation mechanism of calcium sulfite and the main influencing factors in the oxidation of calcium sulfite, which are valuable for accelerating the oxidation Rate, consummating academic basic of lime stone-gypsum FGD and optimizing technical process A simulate equipment has been designed based on the theory of geometrical comparability which is reduced scale in geometric proportion to the 300MW capacity.

目前我国的湿式石灰石–石膏法设备和技术均从国外引进，因此深入研究脱硫过程中亚硫酸钙的氧化机制和影响亚硫酸钙氧化的主要因素，对提高氧化速度、完善湿式石灰石–石膏法脱硫技术的理论基础、优化烟气脱硫工艺过程具有重要的价值。

Whatever the Zn/H_2O_2 ratio is, there is only chestnut bur-like structure appeared after thermal oxidation at 850℃for 8h. DSC-TG results showed that while the content of the ZnO film shell on the zinc nanoparticle surface is about 50.4%, the melting and oxidation processes happened almost at the same time during the thermal oxidation process and the bushiest ZnO nanoneedles can be formed.

DSC-TG分析结果表明，纳米锌粉表面保护膜质量占到颗粒质量的50.4%时，热处理阶段氧化过程和熔化过程几乎同时发生，生长的ZnO针状产物最为茂密；对于微米锌粉，H_2O_2预氧化处理对其热行为及其最后形貌生长都影响不大，热氧化阶段是其控制阶段。

After the research of anodic oxidation slag, we got the composition of the suspension electrolyte of zinc sulphate solution. 2 The results of electrode kinetic of anodic oxidation showed that the electron transfer during the process of electrochemical oxidation was 1, and the electrochemical mechanism was: ZnS=Zn~(2+)+S~-+e Zn~(2+)+2S~-=ZnS + S~0 3 The flow sheet which can produce zinc according to suspension electrolysis principle in industry was put forward. 4 Elemental sulfur in oxidizing slag was recovered by distillation.

本文的创新点是： 1提出了以硫酸锌溶液为基础的悬浮电解液体系；通过对阳极氧化渣进行系统的分析研究，得出了硫化锌矿物的悬浮电解的电解液组成； 2通过阳极氧化电极过程动力学分析得到，电化学氧化过程中电子转移数为1，电化学机理为： ZnS=Zn~(2+)+S~-+e Zn~(2+)+2S~-=ZnS+S~0 3提出了工业上利用悬浮电解原理生产金属锌的工艺流程； 4对氧化渣中的元素硫采用蒸馏法原理进行回收。

Meanwhile, the concentration of Pb,Zn and other heavy metals is rather high in the oxidation zone and decreasesdownward to levels that are unbelievably low for Pb-Zn mine tailings. Theseobservations suggest that heavy metals should be re-immobilized by secondaryminerals, rather than primary minerals, in the oxidation zone, and could be leachedout from suboxic environment due to low rate oxidative dissolution which preventsthe precipitation of secondary minerals in significant amount. Thus, cover scenarioswhich establish a suboxic environment beneath the cover layer might not always beeffective in preventing heavy metal release from mine tailings.Sequential extraction studies indicate that, in addition to heavy metal leaching,oxidation of the mine tailings increased the mobility of residual Zn, and Cu, while Pb remains immobile due to the formation of anglesite (PbSO4). Using the seven-step extraction technique developed by Dold (J. Geochem. Explor., 2003, 80: 55-68), galena dissolves in significant amount at step 2 most probably due to the strong complexing of Pb2+ by acetate, while other metal sulfides dissolve at step 6, which suggest that this extraction technique could not be used to evaluate the mobility of lead in natural environment

重金属含量均低于新鲜尾矿，但以硬化层中的含量最高(Pb、Zn含量分别为0.47%和0.93%)，往下大幅度降低，表明尾矿风化过程中形成的次生矿物对Pb、Zn等重金属元素有较强的固定作用，而次氧化带的淋溶作用造成了金属元素的大量流失；(4)与新鲜尾矿相比，硬化层中铅的可迁移性大大降低，硬化层之下尾矿样品中铅的可迁移性也不同程度降低，这是由于硫化物氧化产生的硫酸根与尾矿中的铅反应形成铅矾(PbSO_4)的缘故；(5)氧化作用使尾矿中的zn、Cu等重金属的可迁移性不同程度地增大，其中对锌的可迁移性影响最大，铜的可迁移性与铁比较相似，铅则容易与硫化物氧化形成的SO_4~(2-)反应形成铅矾(PbSO_4)；(6)为了减少尾矿污染和修复矿山环境，人们提出了各种不同的尾矿覆盖方案，本文的研究结果表明，这些方法不一定能够有效地阻滞污染元素的迁移。

To study the performance of inorganic composite catalyst for the SPC oxidation of p-methyl anisole, Cu2-Co2-KBr is used as catalyst of sodium percarbonate oxidation for p-methyl anisole synthesized by paracresol methylating. Effect of reaction conditions, such as the factors of catalyst composition, catalyst quantity, solvent, reaction temperature and time on oxidation of p-methyl anisole, is investigated.

研究了无机复合催化剂催化SPC氧化对甲基苯甲醚的反应性能：以Cu2-Co2-KBr为催化剂，利用过碳酸钠氧化对甲酚甲基化产物对甲基苯甲醚，系统研究了催化剂组成比例、催化剂用量、溶剂、反应温度、反应时间等因素对反应的影响。

Results: Oxidation resistance effect of 0.10% loquat leaf flavanone was close to that of 0.05% tertiary butylhydroquinone, indicating the loquat 1eaf flavanone had obviously oxidation resistance effect to the fat with quantitative relationship. Antiscorbutic acid and the loquat leaf flavanone has the coordination oxidation resistance effect.

结果：0.10%枇杷叶黄酮的抗氧化效果和0.05%叔丁基对苯二酚相近，表明枇杷叶黄酮对油脂的抗氧化效果明显，且作用呈一定的量效关系，抗坏血酸与枇杷叶黄酮有协同抗氧化效应。

Salt is good, but if the salt becomes flat and tasteless, with what do you season it?

14：33 盐本是好的，盐若失了味，可用什么叫它再咸呢？

He reiterated that the PLA is an army of the people under the leadership of the Communist Party of China.

他重申，人民解放军是在中国共产党领导下的人民军队。