查询词典 overwhelming force

The Failure model of slopes can be classified into 2 kinds, toppling model and sliding model. The force distribution of each model is analyzed in oblique coordinate system, and the equation to calculate the forces are derived. Many external forces, such as earthquake force, water pressure, bursting force, bolting force and etc., can be easily considered in these equations.

分析了倾倒模式和滑动模式两种岩质边坡的破坏型式，对其受力情况进行了分析，并利用刚体平衡理论，给出了在斜角坐标系下推力计算方程，该方程可以方便地考虑任意方向的地震力作用，还可以考虑水压力、锚固力、建筑物外荷载和其它人工作用力。

The results show that, with the expansion cone angle remaining unchanged, the sizing length of expansion cone does not have much effect on the residual stress of casing after expansion, but it has much effect on the expansion force required by tube expansion. The expansion cone angle has no effect on the maximum residual stress of casing, but it has remarkable effect on expansion force. When the radial component force of expansion force is greater than the material's tensile strength, the damage to the material will arise.

研究结果表明，在膨胀锥锥角保持不变的情况下，膨胀锥定径长对膨胀后套管的残余应力没有太大影响，但对套管膨胀所需要的膨胀力有较大影响；膨胀锥锥角对套管最大残余应力没有影响，但对膨胀力的影响十分明显，当膨胀力的径向分力大于材料的抗拉强度时，材料将发生破坏。

Applications;Cap gauges;Checks;Connectors;Contact pins;Design;Designations;Dimensions;Electric contacts;Electric lamps;Electrical engineering;Gauges;General lighting service lamps;Go-gauges;IEC;IEC cap gauges;IEC gauges;IEC holder gauges;IEC lamp caps;IEC lampholders;Illumination engineering;Insertion force;Inspection;Lamp caps;Lampholder gauges;Lampholders;Lamps;Lighting plants;Lighting systems;Measuring instruments;Minimum retention force;Motor vehicles;Multilingual;Non-interchangeability;Not-go gauges;Recordings;Replaceability;Retention force;Safety;Safety engineering;Testing;Tolerances;Use;Withdrawal force

中文主题词国际电工委员会；最小的保持力；非互换性；电灯；连接器；灯头量规；IEC灯头量规；IEC灯座；使用；应用；检验；检验；量规；安全工程；尺寸；记录；电气工程；照明系统；测量仪器；多语种的；照明工程；安全；IEC灯头；机动车；名称与符号；设计；灯座量规；照明设备；可置换性；普通照明灯；公差；过端量规；触针；灯座；IEC量规；保持力；拔出力；灯；IEC灯座量规；不过端量规；试验；电触点；插入力；灯头

The force of potential sliding body is determined using the FISH program of 3DEC based on Limited Equilibrium Method. And the sliding force and resistance force of potential sliding body are obtained by the resolution of acquired body force along the potential sliding plane. Thus the varied factor of safety of the slope under seismic loads is obtained.

借鉴块体极限平衡分析思想，并考虑了地震动荷载的全时程特征，利用3DEC中FISH语言编程求出了潜在滑体的受力并将其沿潜在滑面分解求得潜在滑体的下滑力和抗滑力，从而求出了地震荷载作用下边坡的动安全系数历时曲线。

The thesis consists of six chapters. In the first, the technologies of atomic force microscopy and of the measurement elasticity of biomolecules were introduced. In the second, the validity of VSPFM was confirmed by lift mode atomic force microscopy. In this chapter, the height of DNA was measured by lift mode atomic force microscopy, which demonstrated that the method of height measurement of biomolecules by VSPFM was correct and established the foundation of the method of measurement elasticity of biomolecules by vibrating mode scanning polarization force microscopy. In the third chapter, detailed work has been illustrated on the foundation of the method of measurement elasticity of biomolecules by VSPFM. And the compressive elasticity of DNA was measured. In fourth and fifth chapters, the method was applied in the measurement elasticity of proteins. Two proteins elasticity, fibre-like protein α-synuclein and global protein IgG, were measured by VSPFM, through which the method wound its way to the application of biomolecules. In last chapter, the final part of the thesis was a summary. A conclusion of the thesis and a self-comment on my work as a PhD candidate have been made, and expectation about the further works has been addressed.

本论文共分为六章，第一章，引言部分主要介绍了原子力显微镜技术及生物大分子弹性测量技术；第二章主要是VSPFM方法的正确性论证，介绍抬高模式原理，利用抬高模式原子力显微镜对DNA的高度进行测量，论证振动模式扫描极化力显微镜测量生物大分子的高度的正确性以及准确性，从而为振动模式扫描极化力显微镜测量生物大分子的弹性方法的建立奠定基础；第三章以脱氧核糖核酸为例详细介绍了振动模式极化力显微镜测量生物大分子弹性的方法的建立，对DNA的压弹性进行了初步的测量和分析；第四章和第五章介绍了振动模式扫描极化力显微镜在蛋白质弹性测量中的应用：α-synuclein和IgG分别是纤维状蛋白和球状颗粒蛋白，通过振动模式扫描极化力显微镜测量这两种蛋白质的弹性，摸索振动模式扫描极化力显微镜在蛋白质弹性测量中的应用；第六章对全文进行了总结，在对论文的工作进行归纳和自我评价之后，还对进一步的工作进行了展望。

Through making diagrams using matlab program ,first we must know submits the shearing force coefficientα_s, the space characteristic Tg, stiffness concern a modulusβ, biggest shearing force coefficientα_.Then we can get shaking tier of base shearing force modulusαand shaking tier of displacement across D, which will define structure basis shearing force F_ and verify if structure displacement D satisfy standard structure request displacement . Therefore, the designer can estimate the earthquake reaction of the composite base isolation structure directly.

通过matlab编程，制作图表，在给定屈服剪力系数α_s，场地特征周期T_g ，刚度关系系数β，最大剪力系数α_情况下，可得到隔震层基底剪力系数α和隔震层位移D，从而确定结构基底剪力F_，并验证结构位移D是否满足规范结构要求位移，设计人员可以直接估算出复合隔震结构的地震反应。

Slide a book across a table and watch it slide to a rest position. The book in motion on the table top does not come to a rest position because of the absence of a force; rather it is the presence of a force - that force being the force of friction - which brings the book to a rest position.

伽利略用二个底部相连的斜面做实验，在实验中他观察小球由一个斜面滚上另一个斜面的高度，如果斜面是光滑的，小球滚上另一个斜面的高度和原来的高度几近相等。

From the basic formula of coulomb force and ampere force,together with the concept of electric stress tensor , the mathematic formula of electric force and magnetic force is deduced in this article.

从库仑力和安培力的基本公式出发，引用电应力张量和磁应力张量的概念，导出计算电场力和磁场力的简单数学表示式。

This test indicates that using bicortical screws in the first and third hole of the proximal end of the LISS is the best way for treating distal femur fractures AO/33-A3, it can not only reach the best balance and it create the biggest force to resist torsional force, but also decrease the shearing force, torsional force so as to prevent hardware failure.

采用LISS钢板治疗股骨远端33-A3型骨折时，骨折近端螺钉第1、3孔双皮质固定在钢板、螺钉的固定平衡性及对抗扭转拔出方面明显优于其他各试验组，能够有效地降低钢板、螺钉与骨质之间的剪切力和扭转力，从而防止螺钉、钢板早期松动脱落。

It showed that the flow regime and the forces were closely related to each other.Calculation indicated that the interfacial tension force, static pressure force, viscous drag force and dynamic lift force were the main forces acting on the droplets. The formation process of the droplet was studied.

在一定条件下计算了液滴所受的力，结果表明，表面张力引起的力、液滴内外静压差产生的力、平行于膜表面的流动曳力和运动浮力是主要的力；在此基础上，探讨了液滴的形成过程。

Objective To study the effect of chitosan in the prevention of fibrous scar formation in the epidural space after laminectomy.

目的 观察选择性脊神经后根切除术椎板切除后硬膜外几种防瘢痕粘连物质的作用并探讨其机制。

On his way to the lift, he looked back to us or was it me his eyes pointing?

当他要进电梯时，他回头看我们（或者说是我，他的眼光？