查询词典 overall error

A measuring system which mainly consists of a high precision motorized translation stage of one dimension, POINT GREY Flea2-14S3 CCD camera and LED light source was designed and constructed. Based on a detailed analysis for experiment results, the periodic changing law of system error of LED facula centroid location in this measuring system was found. The results indicate that based on Flea2-l4S3 CCD camera, the random error of facula centroid location is about 0.018 pixels, the system error is about 0.06 pixels, and the total error is about 0.063 pixels (1/15 pixels). According to the total error above, this CCD imager can be widely used in many measuring systems which count on facula centroid subpixel detection.

利用高精度一维电动平移台、POINT GREY Flea2-14S3 CCD相机和LED光源构建了测试系统，对测试结果进行研究和讨论，发现了测试系统LED光斑质心定位系统误差的周期性变化规律，计算得到了基于Flea2-14S3 CCD相机的光斑质心定位随机误差为0.018pixels，系统误差为0.06pixels，总体误差为0.063pixels（约1/15pixels），能够应用于以光斑质心检测为手段的测量系统中。

It is pointed out that the error of indication E0 for the calibrated test length which are measured when the offset length between the ram axis and the stylus tip is zero shall neither exceed the maximum permissible error MPEE0 nor exceed 1/3 of the probe error,that the repeatability of E0 shall neither exceed the maximum permissible error MPE Rnor exceed the repeatability error of the probe,and that if the measuring data is rejected in acceptance and reverification,measurement must be carried at least 5 times at the same position for reducing the possibility of misjudgement.

提出探测轴探针针头零偏置长度的校准测试长度的示值误差E0应不超过最大允许校准测试长度的示值误差MPEE0，且不应超过测头误差的1/3；E0的重复性误差R不应超过最大允许重复性误差MPER，且不应超过测头的重复性误差。建议验收校准测量数据超差剔除后，必须在相应位置重复测量5次以上，以减小误判的可能性。

Check method of residual error was used to judge data error, as if sum of front K residual error was unlikeness with sum of back n-K residual error in measure row, it shown that exist linear system error in measure row.

使用残余误差校核法，若测量列中前K个残余误差之和与后个残余误差之和不相等，则测量列存在线性系统误差。

The measurement accuracy of the photoelectric theodolite is decided based on measurement requirement of the ballistic trajectory. Two simple equations were derived mathematically, one expression for positioning error of the ballistic trajectory, angle error of the photoelectric theodolite, ranging error, target slant range and height when one instrument is used, another expression for positioning error of the ballistic trajectory, angel error of the photoelectric theodolite, target slant range and intersection angle when two symmetrical intersection instruments are used.

通过数学解析的方法，推导建立了2个简洁的公式：1）单站定位体制下弹道点位精度和光电经纬仪测角、测距精度以及目标斜距、高角之间的数学表达式；2）对称交会测量体制下弹道点位精度和光电经纬仪测角精度以及目标斜距、交会角之间的数学表达式。

The conditions to measure accurately and the principles to select parameters of the multi— probes EST method are proposed, and the theoretical research, computer imitation and the experiment on a machine tool prove that these principles and suggestion are necessary and effective. The influence of the initial value errors of the probes, the installation error of the probes system, and the remaining error caused by the radical error motion are analyzed quantitively on the measurement accuracy of the multi—probes EST method. The influence of the error caused by the probe's axes which is not in a plane and the perpendicularity error of the plane which the probe's axes is in to the stational axis are discussed on the measurement results.

结合理论分析，对这些EST方法进行了计算机仿真分析和研究，重点研究了这些方法的应用条件和误差分离精度，所得出的结论是：三测头法EST基本上能实现各项误差的完全分离，适于在位测量使用；二测头法在恰当地选择测头安装角的条件下，可以得到较高测量精度，适于大型零件圆度、圆柱度、径向圆跳动和全跳动的在位测量；对置两测头时域法可以在一定程度上改善单测头法测量精度，但对随机径向误差无能为力；对置两测头频域法存在严重的谐波损失。

A commutation error is then considered in addition to the conventional residual error to generate the innovative residual error. Such an error is applied into cost functions to derive finite impulse response and infinite impulse response filter-based adaptive algorithms for ANC applications, referred to as FxRLS/CE and FuRLS/FRE+CE algorithms, respectively. Convergence analyses based on Lyapunov stability criteria for time-varying discrete-time systems can be carried out for the FxLMS/CE, FxRLS/CE and FuRLS/ FRE+CE algorithms to ensure stability. Computer simulations and experiments demonstrate that the innovative residual error-based adaptive algorithms can free the restriction of the slow-adaptation assumption in the conventional ANC approaches.

本文中也定义一交换误差并且加入到传统残留误差行形成新残留误差来改善适应性演算法的收敛速度，使用新残留误差推导出了有限脉冲响应滤波器与无限脉冲响应滤波器之适应演算法的新适应性演算法分别为： FxLMS/CE、 FxRLS/CE 和 FuRLS/FRE+CE 演算法，并且以离散时间的 Lyapunov 稳定性准则来证明演算法的收敛性，电脑模拟与实验也显示新演算法免除以往滤波器的参数必须缓慢更新的条件。

In order to evaluate aiming error of missile on the warship or on the submarine, including the error of warship position, the error of reference azimuth and the error of transfer measurement given by the navigation system, and try to divided them from the general error, it is highly important that we estimate and evaluate missile system of mobile bedding launching.

为了评估从舰船／潜艇上发射导弹的瞄准误差，包括舰船导航系统给定的船位误差、基准方位误差及其传递测量误差，并试图把它们从总的瞄准误差中分离出来，这对于动基座发射导弹武器的瞄准精度的评价极为重要。

Using the a hand-hold GPS and wireless transmitting unit to rapidly locate the fire and determine the rate of fire spread, which also offered an indispensable way of verifying the speed of forest fire appealing. Discussing the representation and Computing Method of the simulate calculation error based on the thorough investigation of the sources of simulate calculation error. Pointing out that the speed and directional error are the root of forest fire appealing simulates error. Thus increasing the parameter of error correction is an effect way of reducing systematicsimulationerrors.

4提出了一种利用手持GPS和无线传输设备来快速测定火场位置和林火实际蔓延速度的方法，为林火蔓延模拟速度验证提供了必要的手段；对林火蔓延模拟误差的来源进行了全面分析，探讨了林火蔓延误差的表现形式和计算方法，指出了林火蔓延速度误差和蔓延方向误差是林火蔓延误差产生的根源，提出了通过增加系统误差修正参数来减少系统模拟误差的有效方法。

The monotony and extremum theory of function are applied to prove the geometrical characteristic of error hand for 2D linear segment uncertainty ε(subscript σ) model in theory. The result shows that the error hand has the geometrical shape of "larger ends and smaller middle" or "one end larger and the other smaller". The minimum width and its exact position of the error hand are calculated too. It is proved that the minimum width position of the error hand is near the end with the smaller mean square error.

运用函数单调性和极值理论，从理论上证明ε模型的误差带的几何特征；得到线元误差带不仅具有&两端大、中同小&，而且也可能具有&一端大、一端小&的几何形状；给出了误差带的最小带宽及其位置；论证了误差带的最小误差带宽的位置靠近中误差较小的一端。

This paper stands in the railroad surmounts the type development and the railroad reforms the experiment site the angle, auxiliary industry changed the system the overall plan to the Chengdu Railroad Bureau host auxiliary separation to conduct the research, has profited from some foreign enterprises industry success reforms experiences, from the railroad bureau host auxiliary industry overall situation, the host auxiliary separation overall mentality and the target programming,"three kind of properties" the overall situation and mixed the principle, the auxiliary industry separation changes the system the bare bone, the experiment site enterprise implements the plan, straightens out the property right to relate several aspects to make the multianalysis elaboration.

对成都铁路局辅业改制分流工作提出了一些看法和实施意见。本文采用了实证研究与案例分析、定性分析与定量分析并重的研究方法，做到了系统与局部相结合、理论与实践相结合、经验与分析相结合，把实证的、规范的、对策的研究结合起来，体现了理论与实践相结合的原则。各种研究经验和取得成效对成都铁路局运输主业和辅业的发展具有很大的指导意义。

Objective To study the effect of chitosan in the prevention of fibrous scar formation in the epidural space after laminectomy.

目的 观察选择性脊神经后根切除术椎板切除后硬膜外几种防瘢痕粘连物质的作用并探讨其机制。

On his way to the lift, he looked back to us or was it me his eyes pointing?

当他要进电梯时，他回头看我们（或者说是我，他的眼光？