查询词典 outside length

The parameters include waveguide width: 8μm, titanium film thickness:50~60nm, index change: 0.006, diffusion temperature: 1050 and diffusion time: 9~10 hours.Designed and produced a 2 X 2 coupler Optical switch and a 1 X 2 digital optical switch. The coupler optical switch was produced by AP reversal structure, with the main parameters such as total length of switch: 30mm, waveguides center distance: Hum, interaction length: 17mm, and at 17V with a crosstalk of -18dB. The digital optical switch was produced by asymmetry electrode Y branch structure. The main parameters of this switch such as switch length: 25mm, the angle of Y branch: 0=0.1? center distance at branch end: 30μm, the center distance of electrons: 12μm, and at 27V with a crosstalk of 18dB.

设计并制作了2×2耦合型光开关和1×2数字开关，其中耦合型开关主要采用的反转Δβ定向耦合器开关，开关长度约30mm，波导宽度8μm，波导间距14μm，耦合区长度17mm，电极主要采用三电极结构，最终测得对TE模开关电压＜-15，消光比≈18dB；数字开关采用非对称电极Y分叉数子开关结构，利用BPM软件模拟了其开关特性并优化了器件参数，制作中采用的主要参数为：开关长度约25mm，Y分叉角θ=0.1°，Y分叉末端波导间距30μm，电极间距12μm，最终测得开关电压27V，消光比≈18dB。

The database consists of nodimensional data of load carring capacities, maximum pressures and their positions, flow factors, and power loss factors by solving full 2D Reynolds equation including oil feed features of 360°, 180°partial groove, and single oil hole, corresponding to a series of power law index, length/diameter, groove width/length, hole diameter/length, hole diameter/bearing diameter, eccentricity, angle between the attitude angle line and centre line of oil groove/hole, rotary, squezze, and oil feed pressure factors.

数据库中的数据通过求解全二维Reynolds方程和热平衡方程获得。数据库由对应于360°全油槽，180°半油槽和单孔的三类轴承的一系列的幂率指数，宽径比、槽宽／轴瓦宽、油孔直径／轴瓦宽、油孔直径／轴承直径、偏心率、偏位线与油槽中心线之间的夹角、挤压因子、旋转因子、进油压力因子的一系列的轴承无量纲的特性参数组成：油膜承载力、最大油膜压力及位置、流量系数和消耗功系数。

Heart malformation, such as PTA, DORV, VSD and aortic arch malformation, were detected when neural crest were taken out before they migrated into 3, 4, 6 pharyngeal gland. Interestingly, the types of malformation were related with the length of neural crest destroyed; PTA was detected if the length exceeds two somites, while DORV would be detected if the length less than two somites. These results indicate that CNCCs are very important to the conotruncal development.

研究发现，如果在迁移之前切除散发到第3、4、6咽弓的神经嵴细胞，就会出现永存动脉干、主动脉骑跨、右室双出口、主动脉弓畸型和室间隔缺损等心血管畸形，且切除的长度与畸形的种类相关，如切除长度大于两个体节可产生永存动脉干，切除长度小于两个体节则产生右室双流出道，由此可见，心脏神经嵴细胞对于心脏圆锥部的发育意义重大。

Growth of cultured winged pearl oyster, Pteria penguin was studied in 20 months in Li'an Lagoon, Hainan, south China. The growth parameters of maximum diagonal length, shell length, hinge length and total weight were measured monthly and described using y=y(subscript ∞)/superscript (1+e-k+d sin (2п/365.25).

对海南黎安港的企鹅珍珠贝养殖群体的生长进行了20个月的观察，每月测量其壳高、最大对角线长、绞合线长和总重四个生长指标，并用模型y=y/1+e(上标-k+d sin (2п/365.25)分别拟合这四个指标的生长曲线。

In this article , the application of PLC in straightening and cutting the steel bar with regular length is introduced, measuring the length by high speed counter in PLC, cutting the bar by servo working-bench with pneumatic clamp and setting the length and showing quantity of the bar straightened, shutting down without bar or in malfunction.

介绍了PLC在钢筋定长矫直切断中的应用，提出利用PLC的高速计数器进行测长，气动夹具随动剪切，用显示装置完成长度设置、产量设置和产量显示，实现无料与故障自动停

The tree diameter at breast height and crown length can be used to predict the size and location of mean knot diameter in a whorl.A linear mixed model expressed as function of tree and knot variables such as HK、RKD、KD and DBH was used to predict sound knot length,and a log-linear mixed model using RKD and DBH as variables was used to describe loose knot length.4.A knot has four development phases:from the birth of a branch to its growth cessation,from growth cessation to death,form death to occlusion and form birth to occlusion.The numbers of annual rings in four periods,as well as the stem width of respective zones were used as dependent variables predicted by models expressed as function of tree variables and knot attributes.5.Using the data of diameter out side bark of 15 relative heights along the step,the best taper equation for Larix olgensis was established.

节子平均直径可以用以胸径，冠幅和节子高度为参数的舒马克生长方程来预测，用树木胸径和冠长可对每轮节子平均直径的最大值及位置进行预测；健全节长度可用以节子着生高度、相对直径、节子直径以及树木胸径为参数的线性混合模型来预测，疏松节长度采用节子相对直径和胸径为自变量的可转化为线性模型的自然对数模型来预测；4、节子有四个生长发育时期：从枝条形成到生长停止BC从生长停止到死亡(CD从死亡到包藏DO从形成到包藏

With analysing the the fatigue mechanism, the general mode of interply fatigue damage propagation is denoted by delamination length and crack density. Based on the power-law, the relationship between number of cycles and delamination length and crack density are established. The specimen is modeled as an equivalent six-ply material system. Starting with the analysis of interply stress, the interply shear stress under cyclic loading is calculated by using nonlinear three-demension FEA. According to the stage regularity of fatigue damage propagation, such models as average strain, effective modulus, ratio of delamination length and crack density, experimental relationship between crack density and effective modulus, are proposed by introducing subsection coefficient.

通过对疲劳机理的分析，确定了以脱层长度和裂纹密度表示的层间疲劳损伤演化的一般模式，利用指数法则建立了脱层长度和裂纹密度随疲劳循环周次变化的关系；从层间应力分析入手，以等效六层的材料模型对循环载荷下的层间剪切应力进行了三维非线性有限元分析；根据疲劳损伤扩展的阶段性，引入分段系数，分别建立了平均应变与载荷循环周次的分段线性模拟模型、有效刚度随载荷循环周次的变化关系模型、裂纹密度变化和脱层长度变化关系随载荷循环周次变化的分段线性模型以及疲劳裂纹密度和有效刚度关系的经验模型。

Results The length between posterior superior iliac spine and greater trochanter of femur was (15.2±1.35) cm for man and (11.5±0.72) cm for woman; the length between posterior superior iliac spine and ischial tuberosity was (13.3±0.87) cm in man and (10.3±0.49) cm in woman; the length between greater trochanter of femur and ischial tuberosity was (8.3±0.83) cm in man and (5.5±0.61) cm in woman; the surface projection where the superior gluteal artery, superior gluteal veins and superior gluteal nerve permeate the suprapitiform foramen was below the point 0～6.8 mm between 2/5 superior and middle trunk from posterior superior iliac spine to greater trochanter of femur; the surface projection where the inferior gluteal artery, inferior gluteal veins and inferior gluteal nerve permeate the infrapiriform foramen was at the point between 2/5 inferior and middle trunk from posterior superior iliac spine to ischial tuberosity; the surface projection where sciatic nerve permeate the infrapiriform foramen was at the point between 3/5 lateral and middle trunk from ischial tuberosity to greater trochanter of femur.

结果臀三角各边的长度分别为：髂后上棘转子间距，男(15.2±1.35) cm，女(11.5±0.72) cm；髂后上棘结节间距，男(13.3±0.87) cm，女(10.3±0.49) cm；转子结节间距，男(8.3±0.83) cm，女(5.5±0.61) cm。臀上动脉、静脉、神经出入梨状肌上孔的体表投影在髂后上棘与大转子连线中、上2/5交界处向下0～6.8 mm内；臀下动脉、静脉、神经出入梨状肌下孔处的体表投影在髂后上棘与坐骨结节连线中、下2/5处；坐骨神经出梨状肌下孔处的体表投影在坐骨结节与大转子连线中外3/5处。

Winter wheat varieties were used as materials, their coleoptile length, seedling length and main radicle length of wheat seedlings were investigated under different concentrations of PEG-6000 osmotic solution simulated drought stress, and their relations with the yield components and drought tolerance under rainfed and rainout shelters were further analyzed.

以6个抗旱性不同的冬小麦品种为材料，通过不同浓度的PEC-6000渗透溶液模拟干旱胁迫处理，研究了小麦苗期的胚芽鞘长度、苗高、主胚根长等性状，并与其在大田及防雨棚控水条件下的产量构成和抗旱性的关系进行分析。

The camera length of electron diffraction in transmisson electron microscopy is one of the main technical parameters in designing electron microscope and the electron diffraction analysis to microcrystal sample. According to Bragg law, the formula of calculating TEM electron diffraction camera length is derived from the research on the ray path of electron diffraction images in TEM and the comparison on electron diffraction with ordinary electronic diffractometer. The difference of physical significance of electron diffraction camera length between TEM and ordinary electronic diffractometer is discussed.

透射式电子显微镜(Transmisson Electron Microcopy， TEM)中的电子衍射相机长度，是电子显微镜设计和对微晶体样品进行电子衍射分析的主要技术参数之一依据布拉格定律，经对TEM中电子衍射成像光路的探讨与研究，并通过TEM与普通电子衍射仪的电子衍射的对比分析，导出了TEM电子衍射相机长度的精确计算公式，阐述了TEM和普通电子衍射仪的电子衍射相机长度所表征的物理意义的区别。

The Porsche Owner: But it's my car!

可，这是我的车呀。

LOX_83}{Oh, another bunch of wackos.

{LOX_83}{呃，又一群怪人。