查询词典 out of contact

Not long after finding the above named relics of human workmanship, and engaged in our usual visits to the Ashley Bed, a bone was found projecting from the bluff, immediately in contact with the surface of the stony stratum (the Phosphate-rocks); we pulled it out, and behold a human bone!

发现上述的人类手艺遗物之后不久，我们如常拜访Ashley Bed，发现一根骨头从断崖突出，与地层表面相连；我们将之拉出，看到一根人骨！

A finite element modeling and analysis of the assembly of a breech mechanism in locking condition was carried out with special finite element techniques such as contact element, gap element and spring element.

利用接触元、间隙元和弹簧元特殊单元，对某大口径火炮的炮尾-闩体-曲臂机构进行了闭锁状态下装配体有限元建模和分析。

Rotational modes are independent of the transverse support stiffnesses of the carrier, ring gear, and sun gear. Translation modes are similarly independent of the rotational support stiffnesses. Large contact ratio do not mean lower mesh force. If either the number of sun or ring gear is not multiple of planet gear, system will run effectively, with lower impaction of tooth mesh in and out.

研究表明：扭转支撑刚度的变化影响系统的转动模态，径向支撑刚度的变化影响系统的位移模态；齿轮间重合度大并不等于轮齿间的受力情况好；行星轮与内齿圈齿数不为行星轮个数的整数被时，轮齿的啮入、啮出对系统的冲击小，系统的效率高。

The elastic contact between steel liner and surrounding concrete as well as the softening of concrete and damage under tension were considered. The analysis results of concrete damage in different parts surrounding the spiral case and vertical displacement of turbine and generator foundations were obtained. In addition, based on the damage analysis of concrete the flexibility check for stay ring was also carried out.

数值计算模型考虑了钢衬和外围混凝土之间的摩擦接触、混凝土材料的拉伸软化和损伤特性，对外围混凝土的损伤指标及分布、各钢部件应力、结构位移等进行了分析研究，并在蜗壳外围混凝土发生损伤的情况下对座环柔度进行了复核。

The question of ruined earth pressure cell in test is solved,and the contact pressure between soil and pile is found out by the numerical simulation and distributing law of earth pressure.

通过数值模拟，解决试验中土压力盒损坏的问题，得到地震动激励下桩–土接触压力峰值的数据，并由此分析桩–土接触压力的大小及其分布规律，提出桩基上的支盘是基础减振的主要构件，并承受动荷载，减轻地震波对上部结构的冲击力，同时消耗上部结构反馈给基础的振动能量。承台和桩基两侧的土压力时程曲线呈反向关系，说明基础在同一时间一侧受压，另一侧受拉。

According to 3D analysis, it is known that shear transfer between rings are carried out by three ways. First is friction between ring joint faces; Second is dowel effect of circumferential bolts; Third is contact-hold effect of tongue-and-groove.

从三维分析可知，错缝拼装衬砌的环间剪切力传递主要通过三个途径实现，一是环缝处两个环面之间的摩擦；二是纵向连接螺栓的销栓作用；三是环缝凹凸榫的接触咬合作用。

The experimental research was carried out about process of SO2 removal in flue gas using white lime slurry atomization , and with the method of non-contact on-line measuring for SO2 concentration in riser.

应用非接触在线测量SO2浓度装置，研究了提升管内熟石灰浆液雾化时SO2脱除过程。

Then check the small antirotary counter-connected downtime of failure, heart-throbbing "" given and magnetic field with the hands turn drawer small motor rotor axis, the rotation were found jammed or deastringency todaya functionalbuffering be electrocircuit reasons, check the growth rate in the relay 2KJ tramsformer, the normally closed contact of the sighting of a tramsformer loosting, screw did not tighten, and pull-out, I found the head on the oxidi.

再查抄小电机在停机后不侧转不到位的障碍，拉不开&给不退与磁场&抽屉，用手转不静小电机的转子轴，未发掘卡住或转不静阻涩的本体，外明是电路的来因所致，查抄增速继电器2KJ的常不开触不面接线，发掘有一根接线松不静，螺丝不有拧不松，且不不收入后发掘线头上有氧化层。

Kinematic and dynamic calculations are carried out, and the features of intake and outtake valve train are got. Especially, the area of fullness ratio of the valve lift curve, cam to tappet contact stress, lubrication coefficient and the features of valve seating are analyzed.

在此基础上分析了配气机构进排气部分的工作特性，着重从气门升程曲线的丰满系数、凸轮与平面挺柱间接触应力，凸轮与平面挺柱间润滑效果以及气门落座特性等方面进行了分析。

In order to solve the problems of which the spiral bevel gear of Oerlikon type is necessary to out and modify repeatedly, a new method was developed to predict the contact pattern and greatly reduce the cost for manufacturing by means of building a tooth

摘要为解决奥利康锥齿轮加工过程中需要反复试切、修正的问题，根据奥利康SKM2机床建立了加工延伸外摆线齿锥齿轮和准双曲面齿轮的齿面接触分析模型，提出了一种可预测齿面接触质量、降低设计加工成本的新方法。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。