查询词典 osmotic pressure

That is made of colophony, bits of amber and sometimes copal are pressed together under heat and pressure to from single block.

即使松香、琥珀、比特有时是压在一起copal压力下单座和热量。

Sheet-fed business card printing and membership card create large pressure-sensitive color business card printing and membership card making products.

单张纸制卡和会员卡制作适合大面积的不干胶彩色制卡和会员卡制作品。

Close the valve, the need to open and close with the Coma Berenices two pieces of the sealing surface of the seal formed between certain specific pressure, while also overcoming the stem and the packing between the stem and the nut thread between the stem end bearing at and other friction parts of the friction, and therefore must apply the closing force and closing a certain moment, the valve in the open and close the process, the required hoisting hoisting force and moment of change, and its maximum is close to the final instant or open the initial transient.

关闭阀门时，需要使启闭件与发座两密封面间形成一定的密封比压，同时还要克服阀杆与填料之间、阀杆与螺母的螺纹之间、阀杆端部支承处及其他磨擦部位的摩擦力，因而必须施加一定的关闭力和关闭力矩，阀门在启闭过程中，所需要的启闭力和启闭力矩是变化的，其最大值是在关闭的最终瞬时或开启的最初瞬时。

Close the valve, the need to open and close with the Coma Berenices two pieces of the sealing surface of the seal formed between certain specific pressure, while also overcoming the stem and the packing between the stem and the nut thread Automatic Control Valves between the stem end bearing at and other friction parts of the friction, and therefore must apply the closing force and closing a certain moment, the valve in the open and close the process, the required hoisting hoisting force and moment of change, and its maximum is close to the final instant or open the initial transient.

关闭阀门时，需要使启闭件与发座两密封面间形成一定的密封比压，同时还要克服阀杆与填料之间、阀杆与螺母的螺纹之间、阀杆端部支承处及其他磨擦部位的摩擦力，因而必须施加一定的关闭力和关闭力矩，阀门在启闭过程中，所需要的启闭力和启闭力矩是变化的，其最大值是在关闭的最终瞬时或开启的最初瞬时。

Close discharge valve, the need to open and close with the Coma Berenices two pieces formed between the sealing suce sealing certain specific pressure, while also overcoming the stem and the packing between the stem and the nut thread between the stem end Department and other friction parts bearing friction, and must exert a certain degree of closing force and closing moments, PUMP CONTROL VALVE EN700X the valve in the open and close the process, the required hoisting hoisting force and torque is the change, Its maximum is in the closed or open end of the initial transient instantaneous.

关闭放料阀门时，需要使启闭件与发座两密封面间形成一定的密封比压，同时还要克服阀杆与填料之间、阀杆与螺母的螺纹之间、阀杆端部支承处及其他磨擦部位的摩擦力，因而必须施加一定的关闭力和关闭力矩，阀门在启闭过程中，所需要的启闭力和启闭力矩是变化的，其最大值是在关闭的最终瞬时或开启的最初瞬时。

The results show that the optimal design parameter combination is middle room volume (36.93 m3), 12 air change per hour, 5 Pa pressure differential and particle released at head region on the bed.

结果发现负压隔离病房微粒去除效果之最佳化参数组合为：中型体积(36.93 m3)、每小时换气12次(12 ACH)、负压值5 Pa，在靠近排气口头部位置进行释放之实验条件。

With the help of a new technique called accelerated-pressure shot peening which is the combination of common shot peening equipment with a pressurizing vessel,a nanocrystalline layer with ultrafine grains(average diameter 30 nm)was fabricated on the surface of 7050 aluminum alloy.

在普通喷丸设备上增加增压罐，采用增压喷丸方法在7050铝合金表面制备出平均直径约为30 nm的纳米晶层。

The combined effect of temperature and pressure is made out.

解决了温度和压强联合作用的分析问题。

We already know that, Combustible ice is a common product of low temperature and high pressure.

我们已经知道，可燃冰是低温与高压的共同产物。

The relationship between pressure and temperature of the combustion chamber and the performance of microthruster are also obtained.

对不同几何参数和热力参数下的微喷管的流场和温度场以及微喷管的性能进行了研究，得出了各个参数在微喷管设计中的设计原则，及与其性能之间的关系。

The Porsche Owner: But it's my car!

可，这是我的车呀。

LOX_83}{Oh, another bunch of wackos.

{LOX_83}{呃，又一群怪人。