查询词典 optimum value

Result The optimum temperatures and pH were 55,55,50℃ and 2.0,7.5,7.5 resp. in tarn for protease, the optimum temperatures were all 40 ℃ and the optimum pH were 4.0,7.0,7.0 reap. for amylase in stomach, intestine and hepatopancreas of A. rostrate.

结果］美洲鳗胃、肠和肝胰脏蛋白酶的最适温度和最适pH值分别为55、55、50℃和2.0、7.5、7.5，美洲鳗胃、肠和肝胰脏淀粉酶的最适温度均为40℃，最适pH值分别为4.0、7.0、7.0。

A case of cotton climate factor ,the author adopted seven evaluation index including boundary temperature, thermal requirement ,temperature intensity requirement, extreme temperature,optimum temperature , optimum rain and optimum sunshining hours ,then evaluated the basic information and meteorological factors.

以棉花气象指标为例，采用全生育期界限温度、积温需求、温度强度需求、极端气温、最适气温、最适降水和最适日照评价指标，进行基础评价和气象单要素评价，并通过调用GIS匹配出该作物在全国范围内的适宜生长区和不适宜生长区。

It has wider pH ranges and higher temperature stability. The P6 LiP-catalyzed veratryl alcohol oxidase activity showed that the optimum pH at 25℃ was 4.0. The effect of temperature on enzyme activity was examined from 35℃ to 65℃ at optimum pH 4.0, with the optimum temperature at 45℃.

以藜芦醇为底物，在25℃，pH3.0的琥珀酸钠缓冲液中与底物反应时的K_m值为0.565mmol／L，Vmax为0.088mmol mg~(-1) protein min~(-1)；具有较宽的pH范围和温度稳定性，最适pH为4.0，最适温度为45℃。

The effects of every main factors on extraction ratio are discussed, and the optimum conditions of extraction effective components from zizyphus jujuba are determined with the orthogonal test. Optimum conditions are obtained by using a new method of H2O2-decoloring in alkalescent condition, and effects of correlation factors on decoloring ratio are discussed. The yield ratio of polysaccharide is above 5.26% under these optimum conditions.

首先研究了不同提取过程中各因素对多糖提取率的影响，结合正交实验确定了微波最佳提取工艺条件；然后采用双氧水弱碱性条件下脱色新工艺，并对脱色各影响因素对多糖脱色率的影响进行了讨论，最终得出最优脱色条件，使多糖得率达到5.26％以上。

The research on the tissue culture and cell suspension culture showed that thesuitable culture medium for inducing bud was MS supplemented with 1.5mg/L 6-BAand 0.1mg/L NAA, and for the generation-continuing multiplication was MSsupplemented with 1.5mg/L 6-BA and 0.2mg/L NAA. The rooting medium was1/2MS supplemented with 0.5mg/L IBA and the rooting rate was 45.0%. Plantletsurvival after transfer to sand was 52.5%.The induction rate of calli was66.7%～86.6% and the optimum medium was MS medium with 0.5mg/L 6-BA and2.0mg/L 2,4-D. The calli became smallest partical size, friable and had gooddispersion ability after 3 times successive transfer culture, the optimum medium wasMS medium with 0.2mg/L 6-BA and 2.0mg/L 2,4-D. Culturing these particles on sixkinds of MS liquid media with different hormone contents, the optimum medium wasselected basing on he change of the density of single-cell, the density of cellaggrefate and the mass of cell.

对蒜头果进行的组织培养与细胞悬浮培养研究结果表明：MS+6-BA1.5mg／L+NAA0.1mg／L+蔗糖3％激素组合能够较好地诱导芽的初始分化和增殖，适宜的芽苗继代增殖培养基为MS+6-BA1.5mg／L+NAA0.2mg／L+蔗糖3％；采用1／2MS+IBA0.5mg／L+蔗糖3％为生根培养基，生根率为45.0％；移栽到河沙的生根苗成活率为52.5％；愈伤组织诱导率为66.7％～86.6％，其中以MS+6-BA0.5mg／L+2，4-D2.0mg／L+蔗糖3％的培养基最佳，其诱导出的愈伤组织具有较强的增殖能力和较好的脆散结构，最佳继代培养基为MS+6-BA0.2mg／L+2，4-D2.0mg／L+蔗糖3％，且培养基中的6-BA与2，4-D浓度的比值越小，愈伤组织生长越快，结构越脆散，增殖率越高；将继代后的愈伤组织转入6种含不同激素浓度组合的MS液体培养基中进行振荡培养，在综合分析各培养基的单细胞密度，细胞团块密度，细胞生物量增长率等指标后，初步筛选出MS+6-BA0.2mg／L+2，4-D2.0mg／L培养基为较好的液体培养基。

With the object of optimum bearing capacity and optimum working conditions, and under meeting reliability and certain conditions, the mathematical model of hydrodynamic lubricant radial journal bearing was established for reliability optimum design.

在满足可靠性及其他要求的条件下，以获得最佳承载能力与工作状态为目标，建立了流体动压润滑向心滑动轴承的可靠性优化设计数学模型，并列举了计算示例。

With rice cultivars Yangdao 6and Wuyujing 3 as test materials, the effects of relatively high temperature (RHT, mean temperature 30 ℃) at grain-filling stage on the starch viscosity profile and magnesium and potassium contents of rice grain were studied in a phytotron. Four temperature treatments were installed, i.e., RHT at whole GFS, RHT at early GFS and optimum temperature at later GFS, optimum temperature at early GFS and RHT at later GFS, and optimum temperature (CK, mean temperature 23 ℃) at whole GFS.

选用武育粳3号和扬稻6号两个水稻品种，利用人工气候室在水稻灌浆结实期进行控温试验，设置全结实期相对高温、结实前期相对高温、结实后期相对高温、全结实期适温（对照，日均温23℃）对照4个处理，探讨结实期不同时段相对高温（日均温度30℃）对稻米淀粉粘滞性谱和Mg、K等元素含量的影响。

Results: The ratio of Lactobacillus bulgaricus and Streptococcus thermophillus is 1:1. The optimum formula of the expanded fermentation is: tomato and carrot juice 3:7, glucose 2%, NFM 4%, and vaccination 3%. The optimum formula of the fermented liquid is: tomato and carrot juice 3:7, fermentation temperature 41℃, fermentation time 24h, and the amount of vaccination 3%. The optimum formula of fermented beverage is: sucrose 5%, citric acid 0.02%, CMC 0.2% and xanthic gluc 0.03%.

结果：用保加利亚乳杆菌和嗜热链球菌按1：1比例作为菌种；种子扩大液的最佳配方：番茄、胡萝卜混合汁配比3：7，2%葡萄糖，2%脱脂乳，3%接种量；发酵液最佳配方：番茄、胡萝卜混合汁配比3：7，发酵温度41℃，发酵时间24h，接种量3%；发酵饮料调配最佳配方；发酵原液中添加蔗糖5%，柠檬酸0.02%，耐酸羧甲基纤维素钠0.2%，黄原胶0.03%。

According to the model, the deflection and main pre-brace parameters are illustrated with the Jinsong station of the tenth line in Beijing. It demonstrates that the curve shape of theoretical result, computing result and the on-set measure result are uniform in the main and the change law is similar; that the circumferential space of pipe-roof has a optimum value while satisfying the pre-brace function; that the relation between diameter of steel pipe and flexibility of barrel vault meets negative exponential function. And the diameter of steel pipe has a optimum value.

依据该模型，以北京地铁10号线劲松车站管棚支护为例，着重对管棚的挠度和主要支护参数进行的分析表明：理论结果与计算结果和现场量测结果的曲线形状基本相同，变化规律相似；在满足预支护作用的同时，存在相对较优的管棚环向间距；钢管直径与管棚挠度之间符合负指数函数关系，管径存在最佳值。

The key to the optimization of reactive power operation is to get optimum value or satisfying quasi optimum value.

无功运行优化问题的关键在于获得最优解或较好的次优解。

The witness also told the jury at the Royal Courts of Justice in London that he saw a paparazzo fighting with a member of the public who was trying to stop him taking pictures in the minutes before the emergency services arrived.

他还告诉在伦敦皇家法庭的陪审团，在急救服务到来之前，他当时看见一个狗仔队正和一群阻止他拍照的人打架。

The entire N／C program on a tape is made up of an accumulation of these successive data blocks.

纸带上的整个数控程序由这些连续数据单元连接而成。