查询词典 optimum system

So an optimum reboiler initial charge exists for a column when q0.7,which was checked and proved by experiments with toluene-ethyl benzene system.

本文采用甲苯-乙苯二元物系对分批精馏过程的最佳投料量进行了实验验证，实验结果与模拟结果吻合较好。

So, to obtain the needed tactical target, an optimum design on this new weapon system's interior ballistics must be done.

因此，必须对这种新结构金属风暴武器系统的内弹道进行优化设计，才能达到所需的战术指标。

In this work, GC-MS, ICP-OES, UV-Visible Spectrophotometry were employed to determine the trace concentrations of the above six hazardous substances, and a standard method system for screening primarily, extraction, qualitative and quantitative analyses of the six substances was established and their factors were analyzed. By evaluating the relative standard deviation, recovery, repeatability, limit of detection, linear relation etc., the optimum parameters were given and thus the precision of analysis was equal to or higher than the IEC 62321 standard, meeting the requirement of RoHS.

针对中国电子电气业在遵守RoHS符合性实践中存在的诸多问题，本文采用GC-MS，ICP-OES，UV-Visible分光光度法等，对我国南方和香港地区各类电子电气产品中六种有害物质进行痕量分析，建立了一套标准的六种有害物质初步筛选、萃取、定性、定量分析方法，并对此方法体系的影响因素进行分析，对其相对标准偏差、回复率、再现率、检出限、线性关系等进行评估，得出了优化测试参数，在此条件下其检测的精密度达到或高于国际IEC 62321标准，满足RoHS测试要求。

Filter paper and lindane can be degraded effectively by the complex microbial system during pH 7~9 which also was the optimum condition of cellulose degrading, and in the condition of pH 10, lindane was degraded 49.62%, much more than that of cellulose.

在纤维素降解最佳的pH值7～9范围内，也同样有利于林丹的降解，而在纤维素降解较少的pH值为10的条件下，林丹的降解率高达49.6％。

Filter paper and lindane can be degraded effectively by the complex microbial system during pH 7～9 which also was the optimum condition of cellulose degrading, and in the condition of pH 10, the degradation ratio of lindane reached 49.62%, much more than that of cellulose.

在纤维素降解最佳的pH值7～9范围内，也同样有利于林丹的降解，而在纤维素降解较少的pH值为10的条件下，林丹的降解率仍高达49.6%。

It also Introduces three optimum techniques for the machine model;manually removing redundant information;carrying out optimization with some softwares and algorithm and according to the change of link motion coordinate and angle,puts forward the change of link s coordinate realized by coordinate system nesting,and the change of link s angle realized by relative to driving link s ...

研究了手工清除冗余信息、利用软件优化和利用算法优化三种模型优化技术。根据机构的运动就是坐标和角度的变化，提出了坐标系统嵌套实现构件坐标的变化，用相对于原动件的角度关系实现角度变化的仿真方法。为工程技术人员解决此类问题提供了一种参考途径。

This paper presents an efficient approach of designing a special dome and its aberration corrector, using the method of Wassermann-Wolf differential equations to generate the optimum contour of the corrector through a macro in CODE V. This corrector reduces spherical aberration and coma which are introduced by the dome and improves the imaging quality of the system.

本文提出了一种有效的特殊整流罩及其像差校正器的设计方法，运用Wassermann-Wolf微分方程组的原理，通过在CODE V中编译宏程序曲面拟合的方法得到校正器最佳面形，从而可以校正整流罩引入的球差、彗差，使系统成像质量得到较大的改善。

The paper analyses material transportation problem and give the solvable methods; analyses delivery vehicle route problem, and then construct its corresponding mathematical model and present a heuristic algorithm based on C—W algorithm; analyses the optimum scheduling problem of trucks, and then construct its corresponding mathematical model and put forward a new algorithm; analyses the Postal Transportation Problem which will perhaps be used in supply chain of manufacturing system, and then construct its corresponding mathematical model and present an approximation algorithm.

分析了制造系统供应链中供需平衡、供需不平衡、有转运等各种情况下的物资调运问题，给出了求解方法；分析了制造系统供应链配送作业中的配送车辆路线问题，建立了相应的数学模型，提出了一种基于C-W算法的启发式算法，该算法较好地解决了有时间约束的配送问题；分析了制造系统供应链中的货运卡车优化调度问题，建立了相应的数学模型，提出了一种基于表上作业法的求解算法；分析了制造系统供应链中有潜在利用价值的邮政运输方式问题，在详细描述了该问题的基础上，建立了相应的数学模型，提出了一种近似求解算法，该算法较好地解决了邮政运输方式这样的多种物流、多种运输方式，有严格时限和众多外部约束的特大型、复杂、并行的交连系统的计划调度问题。

At last, The optimum method of minimizing the files'length of virtual scene is put forward, which will raise the scene's creating speed and make the logistics sorting system virtual scene lay out easier and smoother.

文章最后提出了减小虚拟场景文件长度的优化方法，提高了场景渲染速度，使物流分拣系统虚拟场景展示更加流畅。

On the basis of FEM and modal analysis of the bracket system, a reasonable optimum model is built, which considers manufacturing constraints and mode control.

在保证结构质量不增加的前提下，利用拓扑优化技术实现了发动机排气系统固有频率的优化设计。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。