查询词典 optimal process
- 与 optimal process 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The objectives of this paper were to investigate the simulation and design of continuous multiple-station rolling forming process for a U-Section Steel Bar by CAE software-DEFORMTM Due to the limitation of elements number using a short strip 120mm went through all the stations to simulate the real continuous rolling forming on factory The roller gap was fixed as 0 30mm roll speed was 20 rad/sec and progressive angles were all equal for each rolling process which were the formed angle divided by by the number of station Three rolling processes were selected with 6 9 and 12 stations respectively During simulation processes two cases occurred Case A the strip was through a single station Case B the strip across two stations Because the strip laterals side was stretched and twisted during the process The model of case B closer to the practical process than case A and the calculated stress and strain on the tip of U section for case A were lower than these for case B by up to 15% From the result of case B for each process the stress for 12-station process was smallest 9-station process second and 6-station process next Because less-station can save larger cost and forming time but the bigger stress and strain for 6-station caused wrinkles on lateral sides not found on 9-station and 12-station Therefore 9-station process was a more suitable design than 12-station process smaller stretched and twisted and stress The progressive angles for 12-station was 7 5?
本文主要是以DEFORMTM有限元素软体模拟U型钢片连续道次成型与单一道次成型以确认单一道次模拟的是否可取代连续道次模拟之研究。因DEFORMTM 软体对於网格元素上的限制故使用较短素材120mm通过所有的成型站以模拟工厂实际连续成形方法。辊轮间隙固定为0 3mm;辊轮转速为20 rad/sec;弯曲角度的方法为将成型角度平均除以成型站数。有三种辊轮成型方式被选择分别为6站,9站,与12站。在模拟的过程中有两种现象会产生 Case A,素材通过单一成型站。Case B,素材会通过两个成型站。因为在模拟过程中素材的两端会有拉应力与扭力。Case B的模拟比Case A像实际的制程,并计算应力与应变在U型断面的Tip部中可发现Case A比Case B低约15%。从Case B的每站的结果可以得知,12站的成型应力最小,9站次之,6站最后。
-
For the aim of saving energy and optimizing control of chilled systems, the performance of VWV systems and characteristics of control systems were analyzed based on the simulation. According to the characteristic of the monitored parameters and controlled variables in VWV systems, three online optimal control strategies were proposed and validated:(1) Optimal strategy for on/off control of chillers according to the ratio of secondary flow rate to primary flow rate.(2) Optimal strategy for the control of secondary pump according to value positions of auto-controlled AHU vales. And (3) Optimal strategy for supply chilled water temperature control of chillers according to valve positions of auto-controlled AHU valves and working status of secondary pump.
为达到节能和优化系统控制的目的,在楼宇空调水系统及其局部控制仿真分析的基础上,针对变流量系统监测点和可调参数较多的特点,提出并验证了3个实时优化控制方案:根据初级和二级冷谋水流量的比率,实时优化多台冷水机组的启/停控制;利用AHU自动控制水阀的阀位信息,实时优化二级水泵的控制;利用AHU自动控制水阀的阀位信息以及二级泵的工作状况,实时优化冷水机组出水温度的控制。
-
The left ventricular meets the optimal efficiency principle at systolic state,we utilize the differ-ential geometry and differentiable dynamics to analyse the model and inverts it to the linear space for optimal control theory solution of optimal efficiency of ejective blood-flow which meets the physiology of optimal efficiency.
结果 在左心室的收缩最优效率原则时候,可应用微分几何与微分动力学数学分析法,将模型转换为线性空间下最优控制理论求得射血流量。
-
The optimal temperature was 38℃, optimal rotating speed was 200 rmin^(-1), the optimal ratio of oil to water was 1:1, the optimal amount of lipase was 150 U^(-1), and the optimum time for concentrating PUFAs in glyceride was 24 h.
固定化脂肪酶富集鱼油中ω-3多不饱和脂肪酸甘油醋的最适条件是:温度38℃、油水比为1:1、加酶量为150U^(-1)、反应转速为200rmin^(-1)、最佳富集时间为24h。
-
Furthermore, buckling effect factors and their influence law are exploited. Finally, combining the character of piles foundation with high bridge piers with engineering practice, four optimal mathematic models are proposed and flow diagram of optimization analysis is fulfilled by the computer optimum program. A numerical example is analyzed to get optimal solution by using this program. Meanwhile based on the optimal model with buckling coefficient as the objective function, parameter variables are discussed about their effect rule toward the optimal value of objective function.
最后,针对高桥墩桩基础的特点,在基本优化模型的基础上,根据不同的目标函数建立了相应的优化模型,给出优化设计算法流程图,编制了相应的优化计算程序;并根据高桥墩桩基的工程实际设计了一个数值算例,采用本文编制的优化计算程序对该结构进行优化,得到了优化后的最优解;同时,采用高桥墩桩基屈曲系数作为目标函数的优化模型进行因素分析,初步探讨了参数变量对目标函数最优值的影响规律和程度。
-
The test established optimal conditions for producing pycnidium that optimal medium was corn powder,optimal temperature was 25-30℃,optimal pH was 7-8.UV irradiation induced the forming of pycnidium.
最适合草茎点霉SYAU-06菌株形成分生孢子器的培养基为玉米粉培养基;最适温度为25-30℃,最适pH为7-8,而且光照有利于产孢,适量的紫外线照射可诱导分生孢子器的形成。
-
This paper analysised and researched some existing algebra feature extraction method such as KL transformation, singular value decomposition、 Fisher linear discriminant and optimal discriminant transformation. On the base of this、we expound a method which named uncorrelated optimal discriminant transformation to accomplish the face recognition.Uncorrelated optimal discriminant transformation is a improvement of Fisher linear discriminant and optimal discriminant transformation.
本文对一些现有的代数特征提取方法如KL变换、奇异值分解、Fisher线性鉴别以及最佳鉴别变换做了分析和研究,在此基础上我们提出使用具有统计不相关最佳鉴别变换的投影方法来进行人脸识别,它是由Fisher线性鉴别和最佳鉴别变换改进、完善而来的。
-
It suggests that thepace of proceeding reform should be discretionally adjusted according to social acceptance. The best way is to stick reform intentions to the optimal social acceptance. But the optimal social acceptance also varies with economic growth rate and macroeconomic environment. In searching for the optimal socialacceptance, gradual proceeding is better than radical one. It concludes that the higher growth rate and better macroeconomic environment is, the lower optimal social acceptance is acquired, and the stronger intension can we engage.
作者认为,改革推进的快慢应根据社会的可承受程度&相机抉择&,最好是将改革力度控制在最优的社会可承受程度上不变;改革的最优社会可承受程度也不是一成不变的,它因经济发展速度和其他宏观环境的不同而有所不同,在&寻找&改革的社会最优可承受程度的过程中,&渐进&的改革方式好于&激进&的方式;经济发展速度越快,宏观环境越好,改革所要求的最优社会可承受程度越低,改革的力度就可以越大,经济发展有助于改革的推进。
-
To our knowledge, reverse phase of high performance liquid chromatography was firstly developed to analyze the metabolites of 7-tocopherol with ideal results. Meanwhile, Gas chromatography/Mass chromatography were used to analyze the structures of unknown metabolites of 7-tocopherol and a main unknown metabolite was identified as a side chain ω- hydroxylate of 7-tocopherol.The kinetic results of of 7-tocopherol reacted in the S9 of male SD-rat liver showed that the optimal time was 45 min; the optimal concentration of S9 5 mg/ml; the optimal concentration of NADPH 1 mM; and the optimal concentration of 7-tocopherol 8 μg/ml. The result of γ-tocopherol metabolized in the S9 of male SD-rat was the best; male Brazil turtle better; and male cobia worst.
本试验首次确立了γ-生育酚代谢物的RP-HPLC分析方法,结果理想且重现性好;用GC/MS对γ-生育酚的未知代谢物结构进行分析,判断其中一种主要的代谢物为γ-生育酚侧链初级羟基化代谢物;γ-生育酚在雄性SD-大鼠肝S9的代谢动力学表明,本实验条件下代谢反应的最佳时间为45min,S9浓度为5mg/ml,NADPH浓度为1mM,γ-生育酚浓度为8μg/ml;发现γ-生育酚在雄性SD-大鼠肝S9中代谢最高,雄性巴西龟次之,雄性军曹鱼最低。
-
Using this model three competence-deficient pneumococci, which was identified by PCR and transformation experiment, were constructed. It is found different strain has different bacterial optimal density for being induced into competence. The optimal density for strains 1, 2 and 22 was 0.1, 0.08and 0.07 respectively. The optimal condition for transformation is c plus y culture at pH8.0. In c plus y culture at pH6.8, which restrained pneumococci forming transformation naturally, pneumococci could be induced to form transformation by CSP.It is concluded that we could induce different S.pneumoniae by CSP into competence in their optimal density in laboratory. 2. It was discussed the relationship between pneumococcal transformation formation and its opportunistic pathogenesis. Comparing their virulence with that of parental strains by challenging mice intraperitoneally and adhering to ECV-304 cell respectively.
结果表明不同肺炎链球菌株的转化最适菌密度不同,1、2和22号菌株的最适转化密度分别为0.1、0.08和0.07;用于转化的CTM培养基最适为pH 8.0的C+Y培养基;在自然转化下不能诱导转化发生的pH 6.8的C+Y培养基中,使用CSP诱导,也能促使细菌发生转化,只是转化效率较低;结论:实验室条件下,不同细菌在一定菌密度时可利用CSP诱导肺炎链球菌成为感受态发生转化。2、为探讨肺炎链球菌转化对毒力表达的影响,本研究分别通过体外粘附人脐静脉血管内皮细胞ECV-304和体内小鼠毒力实验观察1、2和22号肺炎链球菌和其转化缺陷菌株1t、2t和22t毒力的差异。
- 相关中文对照歌词
- Part Of The Process
- Illumination
- A Process So Familiar
- Process
- X-Static Process
- Made In Belfast
- Everyday Robots
- I Love You
- Context
- Thought Process
- 推荐网络例句
-
In the days of sailing vessels the crew were afraid they would be becalmed on the ocean.
在使用帆船的时代,船员们担心他们会因为无风而无法在海洋上航行。
-
As long as foreign donors pay the PA's salary bill, few expect a new intifada.
只要外国继续为巴权力机构的薪水买单,希望发动新暴动的人便寥寥无几。
-
Speak with contempt of none,form slave to king,the meanest bee,and will use,a sting.
别用 言词贬低任何人,无论国王还是奴隶。最卑戝的蜜蜂也会用它的毒针蜇人。