查询词典 open cover

5 Degree of valve opening and closing valves open and close the display plate ① degree of scale line should be cast in the gearbox cover or change the direction of the display after the disc casing, all for the ground wire brush on the phosphor scale to show striking;② direct needle plate material in the case of better management of available stainless steel, or steel plate for the painting, do not make use of aluminum skin;③ direct drive needle eye-catching, stable fixation, accurate adjustment when opening and closing after Rivets should be locked.

4.5 阀门启闭程度的显示盘①阀门启闭程度的刻度线，应铸造在变速箱盖上或转换方向后的显示盘的外壳上，一律面向地面，刻度线刷上荧光粉，以示醒目；②指示盘针的材质在管理较好的情况下可用不锈钢板，否则氧气专用阀、铜阀门为刷漆的钢板，切勿使用铝皮制作；③指示盘针醒目，固定牢靠，一旦启闭调节准确后，应以铆钉锁定。

Valves open and close the display of the degree plate① valve opening and closing degree of the scale line should be cast in the gearbox cover or change the direction of the Globe Valves display after the disc casing, all for the ground wire brush on the phosphor scale to show striking;② direct drive pin, the material in the case can be better managed stainless steel, or steel plate for the painting, do not use aluminum leather production;③ instruction set pin striking, stable fixation, once the opening and closing After accurate adjustment should be locked rivets.

阀门启闭程度的显示盘①阀门启闭程度的刻度线，应铸造在变速箱盖上或转换方向后的显示盘的外壳上，一律面向地面，刻度线刷上荧光粉，以示醒目；②指示盘针的材质在管理较好的情况下可用不锈钢板，否则为刷漆的钢板，切勿使用铝皮制作；③指示盘针醒目，固定牢靠，一旦启闭调节准确后，应以铆钉锁定。

The water from open area inset under the ice cover to form a warm water region under ice with the temperature greater than 1℃, which leads to ice melting. Obstructed by the Herald Shoal, the northward flow bypassed the shoal and formed a cold water region under ice behind the shoal with the temperature lower than -1℃.

开阔海域的水体向冰下扩展，表层水温在1℃以上，形成冰下暖水区，加速了海冰的融化；Herald浅滩阻挡了海水的流动形成绕流，其北部处于绕流的死角，表层水温在-1℃以下，形成冰下冷水区。

Key process for drying and frost cover, due to the different varieties, different drying methods: the production of persimmon in the roof or pad space Shop thatch layer structures will be placed on the open-air drying persimmons peeled.

关键工序为晾晒和捂霜，因品种不同，晾晒方法各异：制作柿饼是在房顶或场地铺一层苫垫物，将去皮柿子放上露天晾晒。

3 Open the regulator and the nozzle ring ring screw fixation screws; 1.3.4 release and remove the valve cover nut; 1.3.5 screw bolts with rings at the stem, from the valve assembly of the upper part of the body perpendicular to bring devices; when the upper part of unit from the valve body will be raised when the stem or any part not allowed to have any sway movements, any shaking could damage to the valve seat.

1.3.3 拆开调节环固定螺丝和喷咀环固定螺丝； 1.3.4 松开并拆下阀盖螺母； 1.3.5 用吊环螺栓拧在阀杆上，从阀体内垂直提起组装的上部装置；当从阀体内将上部装置提出来时，不允许阀杆或任何部件有任何的摇摆动作，任何摇动都可能损坏阀座。

Store opening and closing documents on transportation should be at the closing device, and also should do the following: a valve flap should be fixed in the open position b path ends with a foam board to plug in port, the port to be plugged with a boring cover, to dust, rust, clean and maintain the channel end of the formation; c cylinder parts to the appropriate protective packaging, shock and anti-collision; d valve should be placed on a smooth, pneumatic drive upwards, not with each other by the crowd.

存放月运输时启闭件应处于关闭装置，同时应做好以下工作： a 阀瓣应固定于开启位置 b 通径两端内口用泡沫板堵塞，端口须用闷盖塞紧，予以防尘、防锈，保持通道清洁和端面的平整； c 汽缸部位进行适当的包装防护、防震和防碰； d 阀门放置时应平稳，气动驱动装置朝上，不得相互受挤。

Of the first case, open the machine cover, fine-tuning of FBT Focus potentiometers can be troubleshooting.

对第一种情况，打开机盖，微调FBT中的聚焦电位器即可排除故障。

The open would with seperated surfaces, which must cover itself with large amounts of exposed granulation tissue.

表面裂开的开放伤口，其上面须覆盖大量暴露的肉芽组织。

The open would with separated surfaces, which must cover itself with large amounts of exposed granulation tissue

表面裂开的开放伤口，其上面须覆盖大量暴露的肉芽组织。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。