查询词典 on-line output

Main technical specification and inspection condition: Main sound track output≥10W, Input resistance≥47KΩ, Frequency20Hz～20KHz, Load resistance8Ω, Total wave distortion≤1%, Ultra bass channel output≥20W, Frequency≤100Hz,uses the transistor and giving up field effect tube and electron tube and reduction transistor and so on carries on the discussion.

其主要技术指标及考核条件为：主声道的输出功率≥10W，输入电阻≥47KΩ，频率响应20Hz～20KHz，负载电阻8Ω，总波失真≤1%，超低音通道输出功率≥20W，频率响应≤100Hz，，同时采用全晶体管的设计。

The systemic experiments are done on the relationship between the output power and the cavity parameters such as the radius of the curved mirror, the reflectivity of the output mirror, the length of the two arms and so on.

本文为进一步将其做成新型、高效、低噪声再生放大器提供了必要的依据。标签激光技术再生放大飞秒激光大焦斑折叠腔 laser technique regenerative amplifier femtosecond laser large beam size folded cavity

Vertically put the KAS detector on the upper part of the transmitter cover, turn EAS detector power supply switch on, EAS detector displays radio frequency output center frequency is: 8.2±0.05MHz; Adjust R15 (counterclockwise decrease, clockwise increase) can change radio frequency output center frequency.

把 EAS 检测仪垂直放置于发射机壳上部，按动 EAS 检测仪电源开关， EAS 检测仪显示射频输出中心频率为：8.2±0.05MHz ；调节 R15（反时针减少、顺时针增大）可改变射频输出中心频率。

Main features:- Hole spacing 2.25mm-operating voltage: 4.5 V to 24 V-switching offset compensation at 62Hz under - over-voltage Protection - VDD-pin Reverse voltage protection - Short circuit protection open-drain output is hot off - working magnetic field range: DC to 10kHz-output goes low with magnetic south pole contacts marked on the package side, while the higher magnetic flux density and area of S1, As S2-all temperature and supply voltage range magnetic parameters on-chip temperature compensation circuitry of the minimum drift - EMC meet DIN40839.

主要特点：–霍尔片间距2.25mm–工作电压： 4.5 V 至 24 V–开关偏移补偿在62Hz下–过电压保护– VDD-pin反向电压保护–短路保护漏极开路输出被热关断–工作磁场范围：直流到10kHz–输出变低用磁场南极接触封装上有标记边，而更高磁通量密度面积S1，如同S2–全温度和供电电压范围下磁参数的片上温度补偿电路的最小漂移– EMC适应DIN40839。

The study methods: Based on digital printing and offset printing technology principle, the basic parameters having effect on the ink-jet printing output quality were analyzed. And the mathematics models between the ink quantity and the solid density, and the relation between the gamma and printing contrast were established. The relation among the output dot area coverage, the original dot area coverage and the dot-gain percent was analyzed. And the mathematics models of printing characteristics curves and dot-gain curves were established. The factors influencing the dot-gain were analyzed, and then the dot-gain compensation function was acquired. All the models were verified by the method of regression analysis. And the precisions of the models were obtained by the correlation coefficient and multiple correlation coefficients.

研究方法：根据数码印刷以及胶版印刷的工艺原理，分析了影响喷墨印刷输出质量的基本参数，建立墨量与样张实地密度、γ与相对反差的数学模型；分析输出网点面积率、标定网点面积率以及网点扩大率三者之间的关系，建立网点扩大曲线和印刷阶调复制曲线的数学模型，并对网点扩大的影响因素进行了分析，导出了网点扩大补偿函数；运用回归分析方法分析模型，并用相关系数和复相关系数检验回归模型的显著性；使用灰平衡方程，结合回归法得出灰平衡控制曲线。

A class of fast-scale bifurcations appearing around the maximum value of the input voltage is discovered for the first time by experiment. Then the influence of the fast-scale bifurcations on the performance of the PFC converters is discussed. Whether the fast-scale bifurcations will appear and how wide the bifurcation region depend on the characteristics of the current loop output. Therefore, the main factors that affect the current loop output are analyzed, including the current loop parameters, inductance, and root-mean-square value of the input voltage.

通过实验，该文首次发现了一类在输入电压最大值附近发生的快时标分岔；详细讨论了快时标分岔对PFC变换器性能的影响；由于电流环输出的特点决定了变换器是否会出现快时标分岔以及分岔区域的大小，该文分析了影响电流环输出的主要因素，包括电流环参数、电感值和输入电压有效值。

As for the establishment of stochastic input-output models and the derivation of related theories, there are three points to be mentioned: firstly, the theoretical basis on which the ultimate requirements must comply with the index movement is given; secondly, the output control model is offered, which is based on the idea that the ultimate requirement is an index stochastic variable.

在随机投入产出模型的建立和相关理论的导出方面。一是给出了最终需求量服从指数分布的理论依据；二是提出了基于最终需求为指数型随机变量的产出量的控制模型。

Meanwhile,from the angle of strontium hydroxide ′ s market supply-and-demand and related influencing factors,such as capacity,output,and supply and demand situation of the major strontium hydroxide manufacturers in the world,were introduced based on the analysis and comparison on large amounts of data and information,and future production capacity,output,and market of strontium hydroxide were analyzed and forecasted.

同时从氢氧化锶市场供给、氢氧化锶市场需求及影响市场供求因素角度出发，通过大量数据、资料的分析及对比，对全球范围内的氢氧化锶主要生产企业产能、产量及供应与需求情况进行了介绍，并对氢氧化锶的未来产能产量及市场进行了分析与预测。

Throught adaptive algorithm of network, the system constantly revise right values distribute so as to meet goal. Distribute the heuristic knowledge and the experience knowledge to network interconnection and right value.?The reasoning machine carries on reasoning according to the knowledge that involve in knowledge base and fact that users offer.?Through front computation of nerve network, the output port obtains the output vector.?The explanation module of ES is explained to user.At last, this paper has realized grab hydraulic system based on ANNES intelligent diagnosis, it has proven this fault diagnosis method feasibility.

ANNES的工作过程是：①首先建立知识库；②学习系统获取知识时，它只要求专家提供范例及相应的解，通过神经网络学习算法对样本进行学习，经过网络内部自适应算法不断修改权值分布以达到要求，把专家求解实际问题的启发式知识和经验分布到网络的互连及权值分布上；③推理机根据知识库中的知识和用户提供的事实进行推理；④通过神经网络的前向计算，在输出端获得输出矢量：⑤经专家系

Taking the sediment discharge of the Lijin Hydrometric Station as input, increment of area and migration of shoreline of the present subdelta as output, by using the model of linear control system which is individual input and individual output, the author built the dynamic prediction model on the development and evolution of the present subdelta, and then predicted its development and evolution, and analyzed the influences of sediment discharge of the river on its development and evolution.

首先，以黄河利津站的来沙量为输入、现行黄河亚三角洲的面积和岸线增长为输出，采用单输入、单输出的线性控制系统模型建立了现行黄河亚三角洲发育演变的动态预测模型；然后，利用该模型对现行黄河亚三角洲的发育演变进行了预测，并据此分析了黄河来沙量对黄河亚三角洲的发育演变影响。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。