查询词典 on the surface of

The effect of additive in CC grade diesel engine oil on the formation of lacquer on the surface of lacquer plate was studied by mirror reflectance infrared spectroscopy;the formation of lacquer on the lacquer plate has the correlation with formation of lacquer on banquette of Cat.

利用镜反射红外光谱法研究了CC级柴油机油中添加剂对成漆板板面漆膜组成的影响；考察了成漆板漆膜组成与Cat。

Results revealed that the large side insulation of the stator bar in slot is available for ultrasonic pulse-echo testing; Coupling transducer on the surface of a practical stator bar could minimize the influence on the measurements of velocity, contributing no destructivity of the ultrasonic testing for stator insulation; The simultaneity of same velocity and higher attenuation can be used to detect insulation delamination from conductors; Compared with the wide sides of the bars in slot, the short sides of the bars near the exit from slot and the end bars had a same velocity and a higher attenuation; The velocity might be exactly measured on the shot sides of the bars near the exit from slot and the end bars, while the attenuation might not, which were examined though filed tests; V min decreased greatly and V av decreased slightly with the service time of the bars.

在实验室对线棒多种结构处的主绝缘和不同运行年数(未老化、16、18 和23年)线棒的主绝缘进行了低频超声反射法检测试验，并进行了现场试验，发现(参见 Hao et al， IEEE DEI， to be published)，槽部线棒的宽面绝缘不受换位绝缘的影响，比窄面绝缘更适合超声测量；线棒表面平滑的半导体层减小了耦合剂对超声测量的影响，实现了无损性；波速不变而声衰减减小可以检测线棒出现绝缘与导体脱壳缺陷；出槽口和端部线棒的窄面绝缘与槽部线棒的宽面绝缘相比，声衰减大而波速一致；现场试验验证了波速不受绝缘结构和现场测试条件的影响，而声衰减受以上因素影响很大(参见 Hao et al，中国电机工程学报， Vol.23 No.4)； V min 随运行年数明显减小， V av 随运行年数慢慢越小。

There are more germs on your desk than on the surface of your toilet.

有更多的细菌对你的案头比对表面你的厕所。

Calculation results indicate that the total energy increases when oleic acid is on the surfaces of (001) and (100) of gibbsite respectively. This can explain that the stability of systems decrease when there is some oleic acid on the surface of gibbsite. The calculation results of equilibrium morphology and growth habit show that the volume of growth crystal is larger when some oleic acids with "horizontal" mode exist on the surfaces (001) and (100) of gibbsite.

计算结果表明：油酸接近氢氧化铝(001)和(100)表面时，体系总能量升高，说明油酸的存在可降低体系的稳定性；油酸在氢氧化铝(001)和(100)表面上时，油酸分子呈"卧"式时，长大后晶粒体积大于无杂质存在的情况，而油酸分子呈"立"式时，长大后体积小于无杂质时晶粒的体积。

The heat generation curves of seven rubber materials used in tires with the changes of temperature have been obtained by using Dynamic Mechanics Analysis technique on NETZSCH DMA242 instrument, knowing that the heat generation of every other rubber materials except inner liner rubber changes lightly alone with the temperature within 10℃～80℃. According to the Fourier law, the heat transfer coefficients of tire rubber are measured by stable method on self-made experiment instrument. The coefficients changes lineally within 20℃～80℃ and the relation formulas λ=λ〓+bt are given out attached with λ〓 and b. The specific heat of tire rubber are measured on Differential Scanning Calorimeter NETZSCH DSC204 and the relations with temperature are linear and the formula is c=c〓+bT, where c〓 and b gained from experiment result data are presented in the paper. The heat convection coefficients on the surface of rolling tire are measured according to the principle of heat-mass transfer analogy principle after simplifying rolling tire into rotating disk with straight movement on wind channel. The relation with rotation speed of disk is linear as h=5. 399+0.0258n and the relation with straight line speed of tire is linear too, h=

论文采用动态力学分析技术，使用NETZSCH DMA 242型实验仪，获得了轮胎用七种胶料的生热率随温度变化曲线，确知除内衬层胶以外，其它各种胶料在一般胎温范围内（10℃～80℃）的生热率随温度变化不大；轮胎胶料的导热系数根据傅立叶定律的基本原理，采用稳态法在自行搭建的实验台上进行测试，结果表明，材料的导热系数在20℃～80℃的温度范围内随温度呈线性变化，论文给出了各种材料导热系数的线性变化的关系式λ=λ〓+bt及其λ〓和b的值；轮胎胶料的比热运用差式扫描量热原理，在NETZSCH DSC204型DSC实验仪上进行测试，结果表明，胶料的比热随温度的变化呈线性变化，其关系可用c=c〓+bT表示，文中给出了根据实验数据拟合的c〓、b的值；对轮胎表面的对流换热系数的测定，本文先将滚动的轮胎简化为有直线运动的旋转圆盘，而后采用萘升华热质比拟技术，在风洞中测量了滚动轮胎表面的对流换热系数，结果表明，圆盘表面对流换热系数与转速呈线性关系，即h=5.399+0.0258n，轮胎表面对流换热系数与其直线运动的速度呈线性关系，即h=

The anastomosing occurred between the pleural superficial and the subpleural vascular networks on the capillary level or the precapillary level. The honeycomb vascular networks were also various in size and form at a low magnification. The venule connected with the pulmonary capillary networks directly at a high magnification. The single capillary networks were found in the alveolar septa. The longitudinal crests and dense round imprints of endothelial nuclei and the clear circular constrictions were found on the surface of the larger vessel in the lung parenchyma. The round imprints of endothelial nuclei also occurred on the subpleural venule and capillary.

胸膜面浅层的微血管与胸膜下微血管之间形成毛细血管水平或毛细血管前水平的吻合；低倍镜下肺实质内微血管网也呈现大小不等、形态各异的蜂窝状结构；高倍镜下肺泡毛细血管与微静脉之间联系紧密；在肺泡隔内毛细血管网成单层分布；肺实质内管径较大的微血管表面可以见到纵行的嵴状结构和密集的内皮细胞核的压痕，以及明显的环形缩窄；胸膜下微静脉和毛细血管表面可见圆形内皮细胞核的压痕。

SPR technique combined with the methods of material spreading onto the surface of gold developed in this work, including the polymer spreading by centrifugation and lipid spreading by LB technique, provided us a very sensitive tool for the real-time, dynamic and in-situ study of protein adsorption on the surface of biomaterials.

表面等离激元技术与本文采用的在金膜上铺展高分子材料的离心铺膜法和LB技术等样品制备技术相结合，为生物材料表面对蛋白质吸附特性的实时、动态、原位研究提供了一种新的高灵敏度的方法，并可能发展成为一种材料生物相容性的测试和评价的新方法。

SPR technique combined with the methods of material spreading onto the surface of gold developed in this work, including the polymer spreading by centrifugation and lipid spreading by LB technique, provided us a very sensitive tool for the real-time, dynamic and in-situ study of protein adsorption on the surface of biomaterials.

表面等离激元技术与本文采用的在金膜上铺展高分子材料的离心铺膜法和LB技术等样品制备技术相结合，为生物材料表面对蛋白质偏瘫吸附特性的实时、动态、原位祛斑研究提供了一种新的高灵敏度的方法，并腹泻可能发展成为一种材料生物相容性的测试瘦身和评价的新方法。

The surfaces of the silicon spiral are coated with highly conformal copper by electroless plating to reduce the resistive loss in the conductor,with thin nickel film plated on the surface of the copper layer for final surface passivation.

采用一种硅玻璃键合-深刻蚀成型释放工艺并结合无电镀技术制作该电感，形成厚约40μm的硅螺线，在硅螺线表面镀有高保形厚铜镀层，在铜镀层表面镀有起钝化保护作用的薄镍镀层。

Lifting the company as a result of non-lifting experience of similar models, the need for carefully lifting program to explore and experiment, with the result that the project had of hoisting the delay is better than the original plan. May 17, in the lifting process of lifting equipment as a result of failure, leading to the surface of leaves and fairing minor injury, and the remaining components of injury does not appear, at present the company in accordance with the guidance of manufacturers fairing on the surface of leaves and damage has been repaired, to ensure that follow-up after repair will not affect the work of lifting and running power.

由于吊装公司无同类机型的吊装经验，需对吊装方案进行谨慎探索和试验，致使项目吊装较原计划有所延迟。5月17日，在吊装过程中由于吊装设备出现故障，导致叶片和整流罩表层出现轻微损伤，其余部件未出现损伤，目前公司按照生产厂商的指导对叶片和整流罩表层的损伤已修复完毕，以确保修复后不会影响后续吊装及运转发电工作。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。