查询词典 on the order of

Therefore, taking my stand on the common interest of China and the Allies, I shall firmly and completely oppose your order so long as you do not openly admit your error and countermand this wrong order.

因此，我站在中国和同盟国的共同利益的立场上，坚决地彻底地反对你的命令，直至你公开承认错误，并公开收回这个错误命令之时为止。

The socket of eye that returns accept to have physiology function as far as possible above all is lain between adipose, if adipose more, can excise appropriately, crimple the socket of eye is diaphragmatic, in order to eliminate " bursa bag appearance " the exterior, handle eye annulus v/LIT all over the ground flesh, increase flesh pulling force, in order to eliminate " spring month disease ".

此种术式，是通过结膜面的小切口，将形成膨陲外的眶隔脂肪部分切除，以消除眼袋。

In order to detect moving infrared dim and small target, a novel high-order cumulant projection algorithm was proposed.

为检测弱小红外运动目标，提出了一种基于高阶累积量投影的检测算法。

C the forward extension of cutter bar is short.In order to improve the order of straw lying in the windrow, the characteristics motion ofstraw in the course of traversing was analyzed. There are three modes for straw being thrownby star wheel.

通过试验的方法，对割台堵塞原因进行了分析，确定了输送链的前伸量过大、输送器的倾斜角度过小和底座高度过小这三个因素是割台堵塞的主要原因。

In chapter 1 ,on one hand ,we give some sufficient conditions for a finite group to be supersolvable and nilipotent by using the properties of π-supplemented subgroups;For example: Theorem 3 Let G be a group, 2 ∈π, if every subgroup of G of prime order is contained in SE, every cyclic subgroup of G of order 4 is π-supplemented in G, then G will be supersolvable.

在第一章中，一方面我们利用π-可补子群的性质给出了有限群为超可解群及幂零群的若干充分条件；例如：定理3设G是群，2∈π，如果G的每个素数阶子群包含在SE中，G的每个4阶循环子群在G中π-可补，则G为超可解群。

Theorem 7 Let G be a group, if every subgroup of G of prime order is contained in Z_∞,2 ∈π, every cyclic subgroup of G of order 4 is π-supplemented in G,then G will be nilpotent.

定理7设G是群，G的素数阶子群包含在Z_∞中，2∈π，如果G的每个4阶循环子群在G中π-可补，则G为幂零群。

Spatial white noise is considered first then the spatial colored noise. Two method based on 1st and 2nd order cyclic moments, CERA, and then 3rd order cyclic moment, MCERA, are proposed separately.

分白噪声及有色噪声两种情况，分别提出了基于一、二阶循环矩的CERA方法和基于三阶循环矩的MCERA方法。

This design takes the diesel cyclinder tank for the clamping and locating device of tank boring and designing the clamping regulations of arts and crafts of tank, we take two cylinders and one face to locate which can limit six free dgrees In order to reduce errors of tank during processing,we take standard and concurrent principle,unify principle,principle with each other for basis and selection of rough basis into order to make the orientation tight enough,it is required to insist in the principle of using the unrepeated coarse beach mark as possible as you can.

本设计以柴油机汽缸箱体为例，对箱体镗孔的夹紧和定位装置进行工艺分析和夹具的设计。在对此箱体的工艺规程采用两销一面对其进行定位以限制其六个自由度。为减少箱体在加工过程中的误差，我们考虑基准的重合原则，统一原则，互为基准原则以及粗基准的选择原则，为使定位稳定夹紧可靠，要求所选用的粗基准尽可能不重复使用原则。

In order to save the people, Jeanne d'Arc is needed; but in order to make people, what is needed is Mother Goose.

为了拯救国民，我们需要贞德，但是为了增加人口，我们也需要绮葛妮②妈妈。

The effect of tribology factors on bearing vibration is studied experimentally. AR model and WPT are used to processing the normal arid abnormal signals. The results are as follows:1. The vibration of ball bearings is caused by the tribology action of contact pairs of ball and ring races and has the essential of tribo-dynamics. Any factors affecting the tribology characteristics of contact pairs will affect vibration and noise of bearings consequently.2. Vibration characteristics of bearing keep almostly unchanged with the increasing of axial load expecting the increasing of nature frequencies. When radial load increasing with axial load unchanged, nature frequencies keep unchanged but some new vibration peaks appears in the spectrum.3. Vibration amplitudes are damped and nature frequency are enhanced with sufficient lubrication. Vibration and noise of bearings increase obviously and roar can happen and the contact surfaces scratch slightly under insufficient and unclean lubrication state. Bearing will be disabled in a few minutes without any lubrication.4. Bearing vibration is unstable under low speed. With the speed increasing, the vibration become stable and natural frequencies increase slightly but the amplitudes increase apparently.5. Bearing vibration can be excited only by some harmonics ofwaviness without lubrication and by all harmonics with lubrication based on the theoretical analysis.6. The nature frequencies of ball bearings decrease with the increasing sizes. When international clearance increasing, nature frequencies decrease in radial and increase in axial and angular and the amplitudes increase in radial and decrease in axial and angular. When the number of balls increasing, nature frequencies increase and amplitudes decrease. When the pitch diameter increasing, axial nature frequency increase and others nearly keep no change. When outer race groove curvature radius increasing, nature frequencies increase in radial and decrease in axial and angular and amplitudes keep no change in radial and increase in axial and angular. When inner race groove curvature radius increasing, nature frequencies decrease and amplitudes increase.7. The distortion in amplitude and frequency components of bearing vibration signals picked up by the present probe measurement method is founded and right conclusions cannot be achieved by the signals. When accelerometer is rigidly screwed with steel stud onto a flat outer surface of a ball bearing, vibration signal can be got without distortion and the reliability of research on bearing vibration is assured.8. AR model is suitable for large samples of bearing vibration signals, square root of length of samples can be used as the upper limitation of order determination and the FPE order selection criterion is effective. Many advantages of AR spectrum are founded over the classical based on FFT.9. Time-Frequency analysis is necessary for abnormal noise of ball bearings. WPT overcomes the principle shortcomings of STFT and proved to be a best tool to process the abnormal signals.

理论分析和试验研究表明： 1球轴承振动是钢球—滚道接触副中的各种摩擦学作用引起的，具有摩擦动力学的本质，任何对接触副的摩擦学特性有影响的因素都将对球轴承的振动和噪声特性产生影响； 2中心轴向载荷作用下，载荷增大使球轴承的固有振动频率升高，载荷越大同样的载荷增幅引起的频率升幅减小，足够大的中心轴向载荷作用下载荷的变化对球轴承振动的频率特性不会产生明显的影响； 3轴向和径向联合载荷作用下，径向载荷不大时球轴承振动的固有频率基本不变，但是可能引起变刚度激励的非线性振动，出现新的频峰，过大的径向载荷将使部分钢球脱离接触，使球轴承的振动和噪声呈现不稳定状态； 4润滑对球轴承的振动和噪声特性有重要的影响，良好的润滑对振动有明显的抑制作用，润滑不充分时，振动和噪声的水平会有明显增高，一定条件下还会激发接触副中的谐振，发出啸声，造成接触表面的伤害，无润滑干接触时，短时的运转就会损伤接触副表面，使振动和噪声迅速增大，并随时可能引发严重的磨损和卡滞失效；接触副润滑良好时，油膜的"刚化效应"使球轴承振动的固有频率有所提高，润滑剂中含有弥散性污浊时，振动的幅度总体升高，但弥散性污浊不会改变球轴承振动的频率特性；浙江大学博士学位论文：球轴承振动的研究 5低速时，球轴承振动的基本特征呈现不稳定状态，随着转速的提高，球轴承振动的频率特性趋于稳定，固有频率频峰升高； 6理论分析表明，干接触时钢球和滚道表面波纹度的某些谐波分量能激励球轴承的振动，振动的幅值与谐波幅值成正比，实际球轴承中钢球的分布不可能完全均匀，波纹度的激励作用会随时发生；润滑接触的分析表明，波纹度的任意谐波分量均能激励球轴承的振动； 7球轴承的几何和结构参数分析表明，球轴承尺寸越大，径向、轴向和角振动的固有频率越低；钢球中心圆直径增大，球轴承的径向和轴向振动的固有频率基本不变，角振动的固有频率有所上升，振动的幅频特性基本不变；径向游隙加大使球轴承的径向振动固有频率降低，轴向和角振动的固有频率有所升高，径向振动幅频特性的幅值升高，而轴向和角向降低；钢球的数量增多使球轴承振动的固有频率上升，幅频特性的幅值下降，径向振动的幅值下降最为明显；外圈沟曲率半径系数增大使球轴承径向振动的固有频率升高，轴向和角振动的固有频率降低，径向幅频特性基本不变，轴向和角向幅频特性幅值升高；内圈沟曲率半径系数增大使径向、轴向和角振动固有频率均下降，振动幅频特性的幅值均有升高； 8试验对比表明，传感器采用探针式安装时，由于探针接触副接触特性的影响，钡(量得到的球轴承振动信号有失真，采用专门设计和制作的试验球轴承，以固定式安装加速度计，首次测量得到了球轴承振动的真实信号，通过对振动信号的分析，验证了球轴承振动的理论模型； 9)基于时间序列分析的AR模型适用于大样本球轴承振动信号的分析，以样本长度的均方根值作定阶上界，FPE做判阶准则，给出的AR谱光滑，频率分辨率高，是球轴承振动分析的简便而可靠的手段； 10以时频域分析的小波包变换分析球轴承异音信号能够比较好地定位和聚焦异音发生的时间，时间间隔，频率范围，同样是球轴承振动分析的可靠的手段，可用作球轴承故障诊断技术。

The dissecting of samples in group2 were difficult. The root of pulmonary artery and ascending aorta failed to be unfolded because fibrous tissue was tough, right and left fibrous trigone were too firm to be solved by hand. Cardiac muscle fibers couldn't be stripped along myofibrillar trajectory since they were prone to break because of their friability.

组2的心脏解剖困难，表现为纤维组织坚韧，游离肺动脉非常困难；徒手无法松解左、右纤维三角，肺动脉和主动脉根部的游离非常困难；心肌纤维坚硬、质脆，解剖时容易断离成碎块，无法沿纤维走行方向剥离。

We have battled against the odds in a province that has become increasingly violent.

我们对在一个争夺日益激烈省的可能性。