查询词典 on the average

The results showed that length from flag leaf pulvinus to spike base has the largest coefficient of variance of 42.1% and 37.2% in both DS and WW environments, respectively, while the spikelet per spike has the smallest CV of 6.4% and 5.7%. Under different water regimes, spike number per plant, effective spikelet per spike and peduncle length contribute a lot to the stable grain yield. Genetic diversity indices of DTI were from 1.95 to 2.07, with an average value of 2.02. Based on the DTI of agronomic traits, all accessions could be clustered into seven groups, the first and third groups are not sensitive to the water regimes, and the second group is more suitable for planting in dryland.

结果表明：在雨养和灌溉条件下，穗叶距的变异系数最高，分别为42.1%和37.2%，单穗总小穗数的变异系数最低，为6.4%和5.7%；不同水分条件下，植株稳产性主要受单株穗数、有效小穗数及穗下节长的影响；性状耐旱指数的多样性指数在1.95到2.07之间变化，平均值为2.02；根据性状耐旱指数将供试材料分为7个类群，其中第I、第III类群材料表现为对水分条件不敏感，而第II类群材料更适于在干旱条件下种植。

Results the imaging manifestations of osteoid osteoma revealed a circular or oval radiolucency with different bone sclerosis around the nidus.the diameter ranged from 0.3cm to 1.6cm,with the average of 0.9cm.among 18 cases,only 14 cases showed nidus on plain film, all 15 cases with ct scanning showed nidus.the detection rate of nidus was 78％(14/18) for x-ray plain film and 100％(15/15) for ct, respectively.

结果 18例病灶均表现为一圆形或卵圆形的透亮区，直径0.3～1.6cm，平均0.9cm，其周围有不同程度的骨质硬化。18例x线平片仅14例显示瘤巢，15例行ct检查者均清楚显示瘤巢，x线和ct对瘤巢显示率分别为78％(14∕18)和100％(15∕15)。

The thinking of this method as follows:Firstly,using single evaluation methods to evaluate.If the evaluation results aren\'t same,the Spearman rank correlation coefficient is used to calculate the correlation among the results of single evaluation methods.Based on the results,the traditional combined evaluation methods are used to combine the results of the single evaluation method.If the results of the upper combined methods are not same. Here the combined method evaluation indexes,such as Spearman rank correlation coefficient,correlation degree,the max deviation,average deviation,are used to evaluate the upper four combined evaluation methods.The entropy method is used to calculate the weights,and then get the final evaluation result.

首先，采用单一综合评价方法进行评价，对于不一致的评价结果，通过Spearman等级相关系数验证各单一评价方法间是否具有相关性；(来源：4dbdABbbC论文网www.abclunwen.com)对存在相关性的单一评价方法采用组合评价法对其结果进行组合，若所得评价结果仍不一致，采用Spearman等级相关系数、关联度、最大偏差、平均偏差对组合评价方法的组合效果进行评价，最后运用熵权法对上述组合评价进一步组合得到最终评价结果。

Based on the data of 5 years in 1970s with duct present and those of December 1990, refractivity at height of 1 km, the average gradient of refractivity and surface refractivity are obtained by regression of the refractivity profiles to exponential models. And it is found that the constants in the exponential relation of refractivity of 1 km above ground and the mean vertical refractivity gradient in the first kilometer height with the surface value of refractivity are 110.6, 0.002 9 and -8.6, 0.004 7 respectively according the data of the 1970s?

对上世纪70年代中5年内波导出现的数据和1990年12月份的全部数据的研究表明：贴地波导出现时，它们的值及其和Ns指数关系的常数分别是110.6、0.002 9和-8.6、0.004 7，地面上1 km处的折射率N1k及地面上第一公里内的平均折射率梯度dN1和地面折射率Ns的相关性比没有波导出现的情况好；而这两者相比，前者的结果又比后者好。

The results show that dynamic softening is easy to occur in these ingots and flow stress becomes steady finally; the material constants of hot deformation are procedural parameters that stress-level coefficient α, strain rate sensibility exponent m and deformation activation energy Q are all increased with strain increasing, while stress exponent n is decreased gradually; the values α and m of the alloy homogenized are the biggest and the value n is the smallest, dynamic softening effect of the alloy is the most obvious, which can deform evenly; influence of strain on the value Q of the alloy homogenized is a little and the average value of Q is only 176.5kJ/mol, so the alloy is easy to deform; the alloy matrix shows the regular recrystallization grains when the strain is 50%; dislocation cell structure re-formed in the grains with increase of strain.

结果表明：经不同处理的Al-1Mn-1Mg合金均易发生动态软化并最终呈现稳态流变特征；热变形材料常数是过程量，随应变量的增加，应力水平参数α、应变速率敏感性指数m和热变形激活能 Q 随之增大，而应力指数 n 则逐渐减小；均匀化退火后，铝合金的α和m值最大而n值最小，动态软化效果最明显且变形均匀，在该状态下，铝合金的 Q 值受变形量影响小，平均仅为176.5kJ/mol，易进行热变形；当应变量为0.7时，基体呈现规则的再结晶晶粒组织，随着应变量的增加，晶内重新形成了位错胞结构。

Through analysing, we found that the average P/E ratio of industry, ROE, expenses rate are the factors influencing function to be relatively remarkable to company P/E ratio; The relations between company P/E ratio and such indexes as ROE, etc are all negative relevant, it is opposite to analyse with the theory, this kind of conclusion that completely contradicts proves the development of the stock market of our country is still at very unripe stage, the phenomenon that the high-quality stock is underestimated is serious, the whole market has even turned around; P/E ratio and net assets factor are in close relations, this includes the price of evaluation on net assets, rentability of the net assets, etc.

其次是对公司市盈率影响因素的分析，本文考虑了21个可能的影响因素，通过分析发现行业平均市盈率、净资产收益率、费用率等因素是对公司市盈率影响作用相对显著的因素；净资产收益率等指标与公司市盈率都是负的相关关系，与理论分析相反，这种截然相反的结论说明我国股市的发展还处于很不成熟的阶段，优质股票被低估的现象严重，整个市场甚至倒了过来；市盈率与净资产因子的关系密切，这包括了净资产的收益性、净资产的成长性以及股市上对净资产的评估价格等。

At first, on the basis of the combination research methods of analytical theory, numerical simulation and experiment, the mathematical and physical model of certain-length rolling process have been established. Then according to the established model, the menstruation of rolling average friction coefficient is proposed; and then the certain-length rolling process and key parameters are determined.

采用理论研究、数值模拟和实验研究相结合的研究方法，建立定长轧制物理模型和数学模型；基于所建模型，提出了一种测定轧制平均摩擦系数的方法；确定了定长轧制工艺方法和关键参数；分析了影响制件轧制长度的因素；对关键参数进行了数值模拟。

Faced with getting from A to B, the average person will automatically set out on the best-known and apparently simplest route. The innovator will search for alternate courses, which may prove easier in the long run and are bound to be more interesting and challenging even if they lead to dead ends.

面对从A到B的问题，普通人会自动的选择简单的最为人知的路线，而创新者会寻找可以替代的路线，而这种发放被证明在长期来看可能是简单方便的，即使是不可行的死路一条，也是很有趣更有挑战意义的。

The creative approach begins with the proposition that nothing is as it appears. Innovators will not accept that there is only one way to do anything. Faced with getting from A to B, the average person will automatically set out on the best-known and apparently simplest route. The innovator will search for alternate courses, which may prove easier in the long run and are bound to be more interesting and challenging even if they lead to dead ends.

创造性方法始于这样一个主张：一切事行文思路：结论最后用一个比喻生动的总结了全文旨在说明的观点：有创造力的人与常人的主要区别在于他们对待事物的方法上，在这篇文章中，这两句准确的传达了作者的观点——文章的主旨，彼此遥相呼应。

Directional Brightness Temperature of 3D row crop canopy generated by the Clumped Architecture Model of Plants were calculated efficiently and accurately based on the Persistence of Vision Raytracer software. Clumping index, average leaf angle and leaf area index are main parameters of CLAMP model. By analyzing the sensitivity of these parameters to DBT, the changing rules of DBT were found.

利用POV-ray光线追踪方法，对植被真实结构模型生成的复杂行播场景下的方向亮温进行快速演算，并针对CLAMP模型中集聚指数，平均叶倾角和叶面积指数，对冠层方向亮温的影响做敏感性分析，得到在不同参数输入条件下DBT的一些规律。

By the time of its fall, most of the prisoners were writers who had written against the corruptions of the government.

到它被攻陷的时候，里面多数的犯人是写了反对政府贪污文章的作家。

The most obvious variation to ovum morphological character was that the color was changed from light green to sepiaceous in embryonic development, and all the ovums were almost hatched after 96h.

在胚胎发育过程中卵的形态特征最明显的变化是颜色从淡绿到深褐色，卵在发育96h后卵基本全部孵化。