查询词典 on the air

Plastic materialsCan simply be put into the Hot—air hopper dryer and the moisture on the surface or inside the plastic regrinds is driven out with the use ofhot air.

简 介：采用欧、美、日技术设计制造xH系列料斗干燥机，可与各类塑料成型机配套使用。

Plastic materialsCan simply be put into the Hot—air hopper dryer and the moisture on the surface or inside the plastic regrinds is driven out with the use ofhot air.

简 介：采用欧、美、日技术设计制造xH系列料斗乾燥机，可与各类塑胶成型机配套使用。

On the basis of analyzing the thermodynamic properties and cycle performance of pure refrigerants, the paper optimizes their concentration while screening NARMs used in wide variable-temperature heat source. The practical applications of NARMs, such as R22/R123, R123/R125 etc., are studied in geothermal heat pump, seawater heat pump, air dehumidification system and dual-evaporator domestic refrigerator. The results show that the NARMs can match the limitation of a pinch point at the air-side exit of heat exchanger, reduce the unreasonable heat transfer temperature difference, and improve the COP of system. The above conclusion is proved by measuring the cycle performance of R12, MP39 and R11/R22 in a two-evaporator experimental system.

其次，本文在工质热物性和变工况循环性能分析基础上，筛选和优化了适应外部大变温热源约束条件的非共沸混合工质及其浓度配比；讨论了相变温差较大的非共沸混合工质（如R22/R123、R123/R125等）在地热源供热热泵、海水源供热热泵、双门冰箱和热泵空气除湿的应用，计算分析表明制冷与热泵系统采用相变温差较大的非共沸混合工质有利于弱化传热过程的&窄点&的约束，减小传热过程中的不合理温差，提高系统COP值；通过建立双蒸发温度循环系统试验装置，对R12、R22/R11和R22/R152a/R124循环性能进行实验研究，结果与理论分析一致。

In the dynamic experiment of wet air oxidation of phenol with pelletized Ru/ZrO2-CeO2, phenol and COD reduction was maintained at 96% during 110 h of reaction. The concentration of the main intermediates was small. In the experiment of catalytic wet air oxidation of phenol, the leaching concentration of active species was small. There were small amounts of carbonaceous deposits on the surface of the used catalysts, and the carbonaceous deposits can be completely oxidized at 300℃.

在110h的催化湿式氧化苯酚反应中，苯酚和COD的去除率维持在96%左右，反应过程中活性组分的溶出浓度很小，催化剂表面有少量的积炭，但积炭在300℃能够被完全氧化。

R12 on the ozone layer due to the destruction of the requirements of the developed countries for environmental protection from 1996 to start using refrigerant R134a Automotive Air-conditioning and the construction of air-conditioning at home in a similar, it is often installed in the compressor engine, and with a belt drive, the condenser installed in the car in front of the radiator, and evaporator in the car inside, and work out from the evaporator of low pressure gaseous refrigerant flows through a high-pressure high-temperature gas compressor After cooling condenser cooling tube cooling into the low-temperature high-pressure liquid, through the desiccant dryers and storage of buffer, and then to a more stable flow of pressure and flow expansion valve, the final expenditure and the flow of relief evaporator.

由于R12对大气臭氧层的破坏，出于环保的要求发达国家从1996年开始改用R134a做制冷剂汽车空调的构造和家用的分体空调类似，它的压缩机往往是安装在发动机上，并用皮带驱动，冷凝器安装在汽车散热器的前方，而蒸发器在车里面，工作时从蒸发器出来的低压气态致冷剂流经压缩机变成高压高温气体，经过冷凝器散热管降温冷却变成高压低温的液体，再经过贮液干燥器除湿与缓冲，然后以较稳定的压力和流量流向膨胀阀，经节流和降压最后流向蒸发器。

This project is used the air turbine to cool to recover the waste rubber to make superior rubber powder. The powder can be used for tire, tube belt, rubber industry and building material and so on. This method not only can eliminate the air pollution but also can raise the quality of the product and can reduce the capital of the product.

本项目正是利用空气涡轮制冷方法回收废旧橡胶制取精细橡胶粉，可应用于轮胎、管带、橡胶工业和建筑材料等，该方法不仅能消除大气污染，提高产品性能，还可以降低产品成本。

Mark a point on the steering wheel cover that is longitudinally and transversely, as measured along the surface of the steering wheel cover, within ±6 mm (±0.2 in) of the point that is defined by the intersection of the steering wheel cover and a line between the volumetric center of the smallest volume that can encompass the folded undeployed air bag and the volumetric center of the static fully inflated air bag.

S26.2.2 在方向盘面上划一点作记号，这个点是在沿方向盘的表面测量而确定的。这个点的位置由方向盘表面和能装下未充气折叠气囊最小空间的中心与静止状态下充分冲气气囊的空间中心之间的一条线所交叉的那个点来确定。前面的那个记号点在这个交叉点的纵横±6 mm (±0.2 in)处。

The thermal boundary condition of the cast iron cooling stave with surface alloyed steel pipe was used for numerical simulation of temperature field and commercial software ANSYS and the method of coupling heat-structure were used to calculate thermal deformation of steel pipe at high temperature,and analyze the influence of air gap and thermal deformation on the life of cooling stave.The optimal size of air gap and hot load to guarantee long life of cast iron cooling stave were obtained.

根据合金化管铸铁冷却壁热态试验数据确定了合金化管铸铁冷却壁温度场数值模拟的边界条件，利用ANSYS软件、采用热-结构耦合的方法计算了高温状态下合金化管铸铁冷却壁内钢质冷却水管的变形，分析了气隙层和水管热变形对合金化管铸铁冷却壁寿命的影响，得出保证合金化管铸铁冷却壁长寿的最佳气隙层厚度和相应的最佳使用热负荷。

To obtain more uniform temperature distribution and relative lowest temperature over cross section of the rotor, on the basis of test data of a given example of a 150MW turbo generator with air coolant, numerical solution of two dimensional modelling equations of air turbulent flow and heat transfer in and between cooling duct and rotor were carried by the Finite Volume Method at condition of varying configuration parameters of sub slot, the number of winding's cooling ducts and center distance of them, and the diameter of slot wedge.

为了能够得到转子截面较均匀并且最高温度值较低的优化温度分布，文中在150MW空冷汽轮发电机转子实验研究基础上，改变副槽的几何形状、径向通风沟的条数及间距、槽楔出风口直径等几何量，采用有限体积法求解转子本体及通风道内空气的传热及紊流流动等二维离散方程组。

We analyzed the air gun signals in the 185Km-long seismic line. And the records showed that the air gun signal is full of seismic phase information. Based on these phases, we developed the P-wave velocity model for this area and find an obvious low-velocity layer, which is coherent to what people obtained from other geophysical methods in this area.

我们分析了气枪激发信号在长185km测线上的记录，拾取包含的丰富震相信息(如Pg，Pn，PmP等)，并在此基础上反演了该地区的P波速度模型，模型结果显示该地区存在明显的低速层，这与在该地区进行的其他地球物理探测结果一致。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。