查询词典 offset staff

This instruction contains an address specified by a 16-bit offset; it loads a 48-bit far pointer from that (16-bit segment and 32-bit offset), and calls that address.

这条指令包含一个16位偏移地址，从它载入了一个48位的远指针(16位段和32位段偏移)，然后调用这个地址。

Offset majority uses hectograph , black and white graph article turns first imprint to bouncier mackintosh roller canister , turn again imprint to paper , call offset print normally .

平版印刷绝大部分采用胶版印刷，印刷的图文先转印到比较有弹性的橡皮布辊筒上，再转印到纸上，通常称为胶印。

The design of the seam tracking sensor is the key work in the realization of the welding automatization. A novel touch photoelectric sensor for seam tracking was designed on the base of getting over the shortcoming of non-touch seam tracking sensor and using the principle of the photovoltaic translation. The idler pulley can touch the seam closely, then the sensor can realize the auto-tracking by the oriented function of the groove. If the offset of the idler pulley location appear, the sensor can change the offset to the voltage using the cell of the photovoltaic translation and the cell of signal processing.

焊缝跟踪传感器的设计是焊接自动化实现过程的重要环节，在此克服非接触式焊接跟踪传感器易受干扰的缺点，利用光电转化的原理，设计了一种新颖的接触式光电焊缝跟踪传感器，该传感器利用特制导轮与坡口紧密接触，依靠坡口的机械导向作用实现焊缝自动跟踪，当导轮位置发生偏移，利用光电转换单元以及信号处理单元，可将偏移位移转化为模拟电压量。

This kind of architecture, however, accompanies with some radio frequency imperfections such as the direct current offset, frequency offset, inphase/quadrature imbalance, and etc. In this thesis, it focuses on the topic of the RF impairment of frequency dependent I/Q imbalance.

但是，这种架构会一起伴随著一些射频的不完美效应，像是直流电偏移，频率偏移，以及I/Q不平衡效应等等…在这篇论文中，主要是研究频率相依的I/Q不平衡效应。

The input offset voltage is fixed for a particular amplifier, however the contribution due to input bias current is dependent on the circuit configuration used. For minimum offset voltage at the amplifier input without circuit adjustment the source resistance for both inputs should be equal.

对于一个给定的OP，输入失调电压就已经给定了，但是由输入失调电流所带来的失调电压与所采用的电路结构有关系为了减小输入偏置电流所带来的失调电压，应该使得使得同、反相输入端对地的直流电阻相等，使得由于偏置电流在输入电阻上压降所带来的失调电压相互抵消。

This system is designed based on SPCE 061A microcontroller to measure the close loop parameters of the amplifier. The system can measure the input offset voltage、the input offset current、the open loop AC differential mode voltage gain、the AC common mode rejection ratio and unit gain bandwidth,using the measure method of assistant amplifier. What is more, data printing is completed in this system.

摘要本系统是基于SPCE 061A 单片机的运算放大器闭环参数测试系统，该系统采用辅助运放测试方法，可对运放的输入失调电压、输入失调电流、交流差模开环电压增益和交流共模抑制比以及单位增益带宽进行测量，并具有将测试数据打印输出的功能。

This research design each intersection offset by relative offset, and derive a "the expected value of progressive intersection number model". This research is for the sake of improving the traditional bandwidth method which is unable to accord with progression demand of every intersection to assign the progression ability effectively, and know the vehicles' real progression ability in the arterial system.

由於群组划分后各子系统路口时差以「绝对时差」进行设计，将无法直接进行相异周期之群组间路口时差最佳化求解，本研究遂以「相对时差」进行各路口间时差设定，并推导一「续进路口数期望值」模式，以改善传统绿灯带宽法无法依据各路口续进方向之交通需求量，有效分配各路口双向续进能力，且无法由绿灯带宽得知系统内车辆真实的续进能力之问题。

Presents the design of longitudinal control for ASTOVL lift-fan aircraft, a multi-variable, strong-coupling, complicated nonlinear system to make the system nonlinear offset and decouple, and the method used for linear system in designing the system to gain expectant flying qualities and the combination of aerodynamic control surfaces with thrust vectors to delay the control surfaces getting into saturation, and the minimum N-norm generalized inverse theorem of weighted generalized inverse adopted to apportion the moments commands, which make the control surfaces gain appropriate deflection and the simulation results to verify the dynamic inverse control laws designed really make the system nonlinear offset and decouple; when one command is given, only this output will response, and others do not response; when all commands are given together, the responses will be just the linear superpose of the response of each command, therefore the operation of the pilot will be simplified greatly.

摘 要： ASTOVL升力风扇飞机是多变量、强耦合、复杂的非线性系统，采用非线性动态逆理论设计控制律以实现系统的非线性对消及解耦，然后，采用线性系统的设计方法对系统进行设计，以使系统获得期望的飞行品质。同时，考虑到ASTOVL升力风扇飞机是由气动舵面和推力矢量融合作用的，为了延缓各舵面进入饱和的时间，采用加权广义逆中的极小N-范数广义逆定理分配力矩指令，从而使各舵面达到适当的偏转角。并将所设计的控制律进行了仿真，结果验证了所设计的动态逆控制律使系统实现了非线性对消和解耦，单个指令作用时，只有该项响应，其余不受影响；所有指令作用时，其结果就等于单个指令作用时的线性叠加，这样使驾驶员的操纵大大简化而易于控制，从而大大降低了飞行事故率。

The output waveform may be offset with respect to ground if the inverting input of the threshold detector, A1, is offset with respect to ground.

如果阈值检测器A1的反相输入端对地有一个偏置电压，那么输出波形也将带有一个对地的偏置。

S1 is then changed to position 1. The voltage stored on C1 is inserted between the output and inverting input of the amplifier and the output of the amplifier changes by VIN to maintain the amplifier input at the input offset voltage. The output then changes from (VOS + IbiasR2) to (VIN + IbiasR2) as S1 is changed from position 2 to position 1. Amplifier bias current is supplied through R2 from the output of the amplifier or from C2 when S1 is in position 2 and position 1 respectively. R3 serves to reduce the offset at the amplifier output if the amplifier must have maximum linear range or if it is desired to DC couple the amplifier.

接着 S1 拨到位置 1，使 C1 的电压加在放大器的输出端和反相输入端之间，(由于电容端电压不能突变，所以)输出端的电压将产生大小等于 VIN 的变化，使放大器输入端维持输入失调电压，即当开关 S1 从位置 2 拨到位置 1 时，输出端电压将从(VOS + IbiasR2)变为(VIN + IbiasR2)。S1 处于位置 2 时，放大器的偏置电流是由输出端经电阻 R2 提供的，当 S1 转向位置 1 时则由 C2 提供。R3 的作用是降低输出失调电压，如果要求放大器具有最大的线性范围，或者采用直流耦合，就应该使用该电容。

You can snipe the second and third union leaders from this position.

您可以鹬第二和第三工会领袖从这一立场出发。

Aiming at the currently shortage of XML streams quality detecting, this paper proposes a new forecasting method of XML streams quality by least squares support vector machines, which is used the method of XML keys' vector matrix as windows, and vector product wavelet transform to multilevel decompose and refactor the XML streams series, that can fulfill real-time checking demand of XML quality, and ensure constraint, consist- ency and integrality. For even more adapting net load, it proposes a control strategy by weight and adaptive adjustment to ensure XML streams quality.

针对当前XML数据流质量检测存在的不足，提出构建XML键的矢量矩阵作为窗口，利用矢量积小波变换多级分解与重构XML数据流，再结合最小二乘支持向量机对XML数据流质量进行预测的一种方法，满足XML数据流质量重构时实时检测的要求，保证XML数据的约束性、一致性与完整性；为了更好的适应网络负载，采取加权与自适应窗口调整等调度策略充分保证XML数据流的质量检测。