查询词典 odd-jobman

This, I profess, is the true explanation of what has happened these 30-odd years.

这一点，我认为是解释中国三十年来的发展的重心所在。

Methods Through odd factor and orthogonal experiment and electrophoresis analysis the influence trends of neutral proteinase and transglutaminase were studied.

通过单因素和正交实验以及电泳分析，研究了中性蛋白酶和TG对SPI的影响趋势。

In some ways, the navel is an odd region to attract our prurient desire.

就某些方面而言，肚脐是吸引我们性欲的一个区域。

In some ways, the navel is an odd region to attract our prurient gaze.

在某种程度上，肚脐是人身上一个吸引众人淫欲目光的奇特部位。

There was always, in her conversation, the same odd mixture of audacity and puerility .

她的谈吐非常奇特，总是那么既大胆放肆同时又天真无邪。

Namely every time when pulse comes, odd a machine P3.7 SP all can give out buzzer of connective of the place that cite a base clew sound, such, hear this clew news the 2nd times when the user when, show number shows pulsometer of 1 minute to had been finished.

即每次脉冲到来时，单片机P3.7引脚所连贯的蜂鸣器SP均会发出提醒音，如许，当用户第二次听到这个提醒音时，就剖明1分钟的脉搏计数显示已经实现。

The decimal 7 requires an odd number of holes (in columns 1.2. and 3), so no parity hole is needed The parity cheek helps to ensure that the tape punch mechanism has perforated a complete hole in all required position in the tape reader counts an even number of holes, then a signal is issued that a parity error has occurred

小数7条要求是单数洞（栏1.2和3），所以无奇偶洞是需要有均等的脸颊帮助，以确保该磁带冲床机制已穿孔一个完整的大洞，所有需要的位置在磁带读者计数一次偶数洞，然后把信号发出一个奇偶错误

An extra hole is punched in column 5,hence making the total an odd number.

额外洞是打了，在第5栏，因此，使总单数。

The man and the voice in his head form an odd quadrangle with Murray and Reeser.

"该名男子及声音在他的头部形成一个多四合院与美利和里泽"。

At first, the principle of algebraic quadratic congruence mapping is analysed, and then limitation of odd-even protection and shift computation are added to the mapping of interleaver.

首先分析算术二次同余映射的原理，然后在此基础上对交织器的映射关系加以保奇偶序限制和移位运算，从而得到两个改进型的算术映射交织算法。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。