查询词典 numerical strength

Because the strength of springwood was very low, the strength of board which included more springwood was low. The main reason why there was no difference in wet compressing shear strength between quarter-sawn board and flat-sawn board was that quarter-sawn board had a lot of pits on radial cell wall and in flat-sawn board xylary rays were transversely cut and left a lot of pores which provided a kind of tunnels for water.

造成柞木径切板的反复煮沸压缩剪切强度与弦切板的反复煮沸压缩剪切强度没有显著性差别的主要原因是柞木细胞壁径面上的纹孔很多，而弦面上的木射线在经刨削后是横断的，留下许多孔隙，这使得弦径向均有成为水分通道的孔隙，造成柞木径切板的反复煮沸压缩剪切强度与弦切板没有显著性差别。

This paper discussed the influences of different cement, Inorganic Filler and the defoaming agent on the tensile strength and elongation at break of coating film;The influence of various of polymer-cement ratio (mass ratio of pure polymer to cement) and coating times on the tensile strength and elongation at break of coating film were researched;This paper also discussed the water Resistant Performance, watertightnessand the adhesion strength of wet subbase of coating film.

本文研究了不同种类的水泥、无机填料及消泡剂对涂膜拉伸强度和断裂伸长率的影响；研究了不同聚灰比(聚合物干量和水泥的质量之比)、不同的涂覆层数对涂膜拉伸强度和断裂伸长率的影响；讨论了涂膜的耐水性、不透水性、潮湿基面的粘接强度等防水性能。

The comparative investigation of the characteristics of deformation and AE were conducted and the results are presented as followed: 1. The characteristics of rock AE are correlated to the strength, joints, cracks, and the size and hardness of crystalline grain. 2. The sequence of AE can be divided into four phases: beginning phase, tempestuousness phase, drop phase and dreariness phase. The loss and the duration of the phases are correlated to the rock character and flaws in the rock. 3. The AE rate characteristics are not almost concordant with the AE energy rate. 4. Besides the homogeneity, the strength of rock contributes the activity of AE. The higher the strength is, the lower the activity is. 5. There is a dreariness phase before the failure of most kinds of rock. 6. Whether the precursor is obvious is correlated to rock the character, and the precursor of AE rate is more apparent than the precursor of AE energy rate comparatively.

通过对比研究这六种不同岩石的变形和声发射特征发现，岩石声发射受到岩石强度、节理裂隙和晶粒软硬大小等的影响；岩石声发射过程存在初始区、剧烈区、下降区和沉寂区，各个阶段是否存在及持续时间与岩石强度、内部缺陷等有关；岩石的声发射事件率特征与能量率特征并不完全一致；岩石的声发射活性除了受其均匀性影响外，还受到岩石的强度影响，强度越小，声发射活性越强；大多数岩石破坏前存在一声发射沉寂区；岩石的破坏前兆是否明显跟岩性有关，相比较而言，岩石破坏时的声发射率前兆比声发射能量率前兆更为明显一些。

The results shows that in the binary system, with the increase of reactive powder, the viscosity and relative degree of compaction of fresh paste increased whenas the fludity decreased; the strength of PRC of C+UPFA+SF is high than that of the C+UPFA and C+SF, and the strength of RPC related to the cementitious materials' relative degree of compaction and fluidity as in C+UPFA+SF system, when the relative degree of compaction was 0.699 and the fluidity was 182mm, the 7d compression strength of RPC was 150.4MPa.

实验结果表明：(1)双掺硅灰和超细粉煤灰，随活性粉末掺量的增加，新拌浆体的黏度增加，流动性下降，相对密实度提高；(2)双掺硅灰和超细粉煤灰的RPC强度远高于单掺硅灰时的强度；(3)RPC强度与体系中胶凝材料的相对密实度和流动度有关，复掺硅灰和超细粉煤灰，当密实度为0.669，流动度为182mm时，其RPC的7d抗压强度高达150.4MPa。

The following was studied in this paper:(1) The adhesive strength of polyvinyl alcohol with different degree of polymerization and different degree of alcoholysis (2) The adhesive strength of polyvinyl acetals with different acetalization degree (3) Effects of polyvinyl acetate on adhesive strength of white glue when PVA or polyvinyl acetals was used as its protective colloid.

本文主要研究以下内容：(1)不同聚合度、醇解度聚乙烯醇溶液粘接强度；(2)不同缩醛度的聚乙烯醇缩醛溶液的粘接强度；(3)聚乙烯醇或聚乙烯醇缩甲醛为保护胶体时，聚醋酸乙烯酯乳液的粘接强度，以及研究白乳胶改性物，制备高粘度和高粘接强度的白乳胶。

The compatibility between the modified LLDPE and nylon 66 was well and modified LLDPE showed batterer compatibilization and toughening effect. The notched impact strength, tensile strength and bending strength of nylon 66/modified LLDPE composites increased by about 130%, 30% and 27% compared with those of nylon 66/LLDPE composites.

辐照改性LLDPE与尼龙66之间的相容性好，辐照改性LLDPE对尼龙66具有较好的增容增韧作用。

Properties determined by mechanical testing, such as yield strength, ductility, ultimate tensile strength, hardness, bendability, impact strength, etc.

由机械试验决定的特性，如屈服强度、延展度、极限抗张强度、硬度、弯曲性、冲击强度等。

The cuspidine is all long known as the main factor leading to the low strength o the sinter bearing fluorine, But with the fluorine decreasing by a wide margin, the strength of the sinter bearingfluorine get lower. So, the first work is to fine out the reason to cause the strength low.

含氟烧结矿中的枪晶石一直被认为是制约包钢烧结矿强度的主要因素，但随着含氟量的大幅度降低，烧结矿的强度却进一步恶化，因此，弄清影响低氟烧结矿强度的原因是提高烧结矿强度的前提和基础。

The transverse longitudinal paper is paper long-due to the fiber bonding ability and fiber strength of coaction, has better resistance to tear strength not easily torn, tore his face appears ragged denticular, while the vertical longitudinal paper that only short-fibre bonding strength, easy to tear, students'rooms surface.

纵向纸的横向即纸张的长边方向由于纤维间结合力和纤维强度的共同作用，有较好的耐撕裂性能，不易撕裂，撕裂面会出现参差不齐的锯齿状；而纵向纸的纵向即短边方向只有纤维结合力，易撕裂，撕裂面较整齐。

Detector the gas strength which examines the sensor transforms the electrical signal, passes commits a footfault the cable to transmit the controller, the gas strength is higher, the electrical signal is stronger, when the gas strength achieves or surpasses the alarm point which the warning controller establishes, the alarm apparatus send out the alarm, and may start the solenoid valve, the exhaust fan substandard association equipment, removes the hidden danger automatically.

探测器将传感器检测到的浓度转换成电信号，通过线缆传输到控制器，浓度越高，电信号越强，当浓度达到或超过报警控制器设置的报警点时，报警器发出报警信号，并可启动电磁阀、排气扇等外联设备，自动排除隐患。

Finally it offers the analysis of the fault-tolerance system as well as its test verification.

这样，运行于空间环境中的系统的设计目标就是在保证系统实时性

However, it is still difficult to find out the real reason of the increase of the keratinized gingiva during the orthodontic extrusion whether it is due to the proliferation of the gingival tissue or to its elastic nature, that is because the proliferation of the fibroblasts as well as the connective tissue changes in volume and the intra-fibers spaces were all immeasurable in most of the studies.

然而，仍然难以找到真正的原因增加的角化牙龈在正畸挤压它是否是由于扩散的牙龈组织或其弹性性质，这是因为增殖的成纤维细胞以及作为结缔组织的变化量和内部纤维空格都是不可估量的，大多数的研究。