查询词典 numerical method

In this paper,based on the characteristic of the tridiagonal matrix,the method of hypothetical coefficient is used for the numerical solution of tridiagonal system of linear equations,this method will be compared with the LU resolving

文章将根据3对角矩阵的特征，用待定系数法求解3对角线性方程组的数值解，并与常用的LU分解法从理论分析和数据实验两方面进行比较，结果表明，两者的时间复杂性前者稍差，而精度两者则相当，最

The natural frequency can be calculated using the numerical value method for the equation and a facility method to solve the natural frequency of chain structures is obtained.

建立了随机性结构参数的链式机械系统动力特性分析模型，利用Monte Carlo数值模拟方法获得系统的特征值随机变量的数字特征。

The method using microcomputer to draw the phase graph of autonomous system on plane of ordinarily differential equation is studied,first a large number of data of orbit are obtained by an appropriate method of numerical calculation from known initial condition,then computer draw the curve of orbit on screen by these data.

研究利用微机绘制常微分方程平面自治系统相图的方法，首先用一种合适的数值算法由已知的初始条件得到轨线的大量数据，再利用这些数据在计算机屏幕上画出轨线的图形。

On the basic of above job a mathematical model of simulation turbulent flow with free surface is established and triumphantly applied to numerical computation on 2D spillway and 3D spillway with frusta of brake.The material job and main conclusion are as follows:(1)A simple boundary orthogonalization procedure independence grids generation method is put forward on the base of algebraic grid generation method; Data structure and computational model on interface are established aiming at blocks of structured grids.

本文针对粘流场数值模拟技术的研究现状和发展动态作了比较全面的回顾与展望，重点研究了网格生成技术、数值求解技术、湍流模型技术和动边界模拟技术，在此基础上建立了模拟自由面湍流场的数学模型，并成功地应用到二维溢流坝和带闸墩的三维溢流坝过坝水流的数值计算。

To obtain more detailed and accurate temperature distribution inside large size hydrostatic bearing, a simulation method was present, combined with a given example of prevalent applied large size hydrostatic bearing in heavy equipment. It consisted of three dimensional numerical model and boundary condition of hydrostatic sliding way and hydrostatic sliding way inside 3-D flow. The model equations were solved by the Finite Volume Method and by selecting segregated solver of FLUENT according to CFD principle. The more accurate results of temperature rise distribution on periodic surface are obtained. The effect of partial important parameters on temperature distribution was analyzed.

为了能够数值模拟出较详细和较准确的大尺寸静压轴承内部流体的温升分布，以重型装备中所广泛应用的大尺寸静压轴承为研究对象，建立了模拟静压轴承本体及轴承内部三维流动的数学模型及边界条件；利用计算流体动力学原理，采用有限体积法并选取FLUENT中的分离式求解器进行求解，得出了轴承周期端面较准确的不对称温度分布，并分析了部分重要参数对温度分布的影响。

The comparison between two methods of calculating the saturation parameters-the Air-gap Permeance Analysis method and the Field Numerical Analysis method-is given here.

本文还探讨了用气隙磁导分析法和磁场数值分析法考虑饱和影响的参数计算方法，并通过实际计算比较了两种方法的特点。

A three-dimensional model of rotor was built based on ANSYS, and analyzed with hexahedral SWEEP mesh method. Furthermore, a numerical simulation for Polyoxymethylene rotor's intensity and stiffness was carried out by using quasi-dynamic model method, and the stress and strain data of the rotor at six operating points were derived.

基于ANSYS有限元软件，建立了转子三维模型，并对其进行了六面体SWEEP网格划分；采用准动态模拟方法对非金属材料的聚甲醛转子强度、刚度进行数值模拟计算，得到了6个工况点中转子应力及变形数据。

The Predictor Corrector Primary Dual Interior Point Method is used to solve the OPF model. The effectiveness of load shedding is confirmed using the Q-V mode analysis method, which can be applied to compute eigenvalues of a reduced Jacobian matrix. The numerical results of 2 IEEE standard test systems demonstrate that the proposed OPF model is very effective since it automatically identifies the weak buses and circuits and calculates minimum load shedding.

论文采用了预测-校正原对偶内点法求解该模型，并通过Q-V模态分析研究切负荷前后系统降阶雅可比矩阵的特征值变化情况，评估切负荷控制措施的有效性。2个IEEE标准试验系统的仿真结果表明，该模型直接针对系统薄弱环节，自动辩识切负荷节点和最小切负荷量，具有很好的效果。

Basing on the variation principle of solid-fluid coupled problem,on the situation of the tank being full filled,the essential method and principle have been found by using the numerical approximation of finite element method.

在罐车满载的情况下，根据固液耦合问题的广义变分原理，使用有限元的近似数值计算方法，找到解决满载罐车液固耦合振动问题的基本方法和原理，建立铁路罐车的固液耦合问题的动力学控制方程，并通过算例验证液体对罐车耦合振动的影响，得到在工程上所需要的分析结果。

The relaxation method is a numerical calculation method to solve two boundaries problem.

松弛方法是解两点边值问题的一种数值计算方法。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。