查询词典 noise-power-ratio

Under spraying humidification state, the parameters of JYPW-1 spraying axial fans for textile enterprises such as flow, total pressure, efficiency, shaft power and acoustic power level changing with water-air ratio were tested, and the performance parameter curve changing with water-air ratio was obtained. The approximate formula of its pneumatic performance in different water-air ratio condition were deduced which can be referenced for of selection and project application.

在喷雾加湿工况下，对纺织空调系统所用的JYPW-1型喷雾轴流通风机的流量、全压、全压效率、轴功率和比A声级噪声等性能参数随喷淋水气比的变化进行了测试，得到了喷雾风机性能参数随水气比变化的曲线，并整理出喷雾风机在不同水气比时，其气动性能的近似计算公式，可供喷雾风机选型和工程应用时参考。

Power parts: motor 0.8 kilowatts,(the most energy-efficient textile machinery) Use of floor type, in the past motor installed in the wall due to power large central power-particularly prone to vibration force, causing a long time in different parts of the rack screws loose, resulting in glitches and instability caused by take-wai (3) Weft parts: the reference to a high-speed rapier looms used Chuanjian round, narrow tracks, narrow sword belt, reducing machine noise, so that the warp to reduce significantly reduced contact surface the warp yarn breakage improved product quality and quantity; and reducing machine noise below 70 decibels more than the requirements of the State Environmental Protection 100 decibels.

动力部分：电机0.8千瓦，采用落地式，以往电机装在墙板中部开机时由于动力较大特别容易产生振动力，时间长造成了机架各部位螺丝松动，产生小故障且造成接纬不稳定（3）引纬部分：引用了高速剑杆机采用的传剑轮，窄轨道，窄剑带，降低了整机噪音，使经纱接触面减少明显减少了经纱断头提高了产品质量和数量；且降低了整机噪音70分贝以下超过国家环保100分贝的要求。

With the same noise level, white noise has the most striking effect. And the effect of noise is weakened with the increase of power spectral exponent a.

在同一噪声水平下，白噪声的影响最为显著，随功率谱指数α的增大，其影响逐渐减弱；随着噪声水平的增加，1/f噪声对计算混沌动力系统最大Lyapunov指数的影响越显著。

The measurement system error model analysis is introduced into power system real time network state analysis as an important part for the first time, which can improve on the state estimation quality and provide the capability to monitor the operation of the measurement system; 2. The theory and algorithm of the on-line estimation and update of measurement noise variance based on the relation between the residual variance and noise variance. The statistic properties of the sample variance are discussed and the relation between the estimation precision and sample size under given confidence level is derived; 3. The theory and algorithm of detection and identification of measurement bias are presented, which is based on the relation between residual mean and noise mean. The statistic properties of sample mean are discussed and the relation between estimation precision and sample size is derived; 4. The Givens orthogonal transformation algorithm is selected to be the essential algorithm of state estimation, the fast orthogonal transformation algorithm with damp factor and the algorithm which can handle the zero injection measurements efficiently are presented; 5. The quantity analysis theory of bad data detectivity and identifibility are presented, which describes the relation between the elements in matrix W〓 and bad data amplitude and can provide the theory base for measurement system design and valuation.

一、首次将量测系统误差模型分析做为一个环节引入电力系统实时网络状态分析中，为EMS系统增加了实时监视系统运行、修正量测系统误差模型的新功能，进一步发挥了实时网络状态分析应用软件的潜力；二、首次提出了应用样本方差在线估计与修正量测系统误差方差的基本理论，讨论了样本方差的统计性质和概率分布，推导出了样本容量、估计精度和置信度之间的关系，给出了在线估计与修正量测系统误差方差的算法；三、首次提出了应用样本均值在线检测与辨识量测偏差的基本理论，讨论了样本均值的统计性质，推导了样本容量、估计精度和置信度之间的基本关系，给出了在线检测与辨识量测偏差的算法；四、在状态估计算法设计中，以Givens变换算法做为基本算法，提出了快速正交变换阻尼因子法和可以有效地处理零注入量测的混合法，并对实时应用中的一些问题进行了讨论；五、提出了不良数据可检测性与可辨识性的定量分析理论，揭示了描述量测系统配置、网络结构与参数的残差灵敏度矩阵中的元素与不良数据的幅值在可检测、可辨识能力上的定量关系，为量测系统配置设计与评价提供了理论基础；六、综合国内外最新研究成果，采用自适应自回归预测技术和稀疏矢量技术，构造了较完善的不良数据检测与辨识算法。

AR model is applied to identify the noise source for enigne. Through the results of noise signal process, it shows that it is practical and credible to use AR model to study engine noise. Through the theoretical analysis, according to the specific engine structure, the SEA equation is formulized. The method of SEA sensitivity is brought forward on the basis of the sound power function.

从理论分析入手，结合具体的发动机产品结构，建立了结构噪声分析的统计能量方程，提出了基于声功率函数的统计能量灵敏度分析方法，把发动机的外在表现和内在因素直接联系起来，分析了系统主要参数对系统声功率的影响程度，得出了一些实用性的定性结论。

It transfers the slip power to mechanical power and then feed the power back to the shaft of the motor, or directly feeds the slip power to the alternating current net, so as to ensure the speed regulation a higher performance and higher power utilization ratio.

它可以把转差率转变为机械功率反馈回电动机机械轴上，或把转差功率反馈至交流电网中，使得具有良好的调速性能和较好的功率利用性。

In the long run, Taiwanese companies benefit from ERP system. In China, the financial performance becomes worse in the first year. The gross ratio, total asset turnover ratio and receivable turnover ratio improve in the third year. Among others, total asset turnover ratio improves significantly in the forth year.

本研究认为可能是大陆企业在微观方面实施ERP系统的基础条件不足，且大陆企业大多只购入ERP系统中的财务会计模块，较难充分发挥ERP原有功能和效果，导致ERP对于大陆企业的财务绩效表现并不如预期那样令人满意。

The main component of ramie glial was pectin, hemicellulose and lignin; The single factor on degumming of ramie test was respectively analyzed with a high vigorous of pectinase KDN and TZ-888 compound enzyme （mainly xylanase and mannanase on the pH value, bath ratio, dosage of enzyme, metal ions, temperature and time.The orthogonal test of L9（34 were done by bath ratio, dosage of enzyme, temperature and time. The results showed that the best compages of KDN pectinase on degumming was 1∶12 of bath ratio,pH 8.6,1 mmol/L Mg2+,300 IU/g of KDN pectinase,35℃、6 h;the best compages of TZ-888 compound enzyme on degumming was 1∶18 of bath ratio,pH 4.0,1 mmol/L Ca2+, 500 IU/g of TZ-888 compound enzyme,45 ℃,6 h.

摘 要：本研究根据苎麻胶质的主要成分为果胶、半纤维素和木质素，用高活性的KDN果胶酶和TZ-888复合酶（主要是木聚糖酶和甘露聚糖酶）从pH值、浴比、酶用量、金属离子、温度、脱胶时间等方面进行单因素试验，然后选取影响显著的浴比、酶用量、温度，时间进行四因素三水平的脱胶试验，结果表明鲜麻采用KDN果胶酶脱胶最佳组合为浴比1：18，pH 8.6， 1 mmoL/L Mg2+，酶用量300 IU/g，温度35 ℃、时间6 h时处理，TZ-888复合酶脱胶最佳组为浴比1：12，pH 4.0， 1 mmoL/L Ca2+，酶用量500 IU/g，温度45 ℃，时间6 h进行脱胶为优化的试验条件。

The main component of ramie glial was pectin, hemicellulose and lignin; The single factor on degumming of ramie test was respectively analyzed with a high vigorous of pectinase KDN and TZ-888 compound enzyme （mainly xylanase and mannanase on the pH value, bath ratio, dosage of enzyme, metal ions, temperature and time.The orthogonal test of L9（34 were done by bath ratio, dosage of enzyme, temperature and time. The results showed that the best compages of KDN pectinase on dry ramie degumming was 1∶12 of bath ratio,pH 8.6,1 mmol/L Mg2+,20 IU/g of KDN pectinase,4℃、4h;the best compages of TZ-888 compound enzyme on degumming was 1∶18 of bath ratio,pH 4.0,1 mmol/L Ca2+, 300 IU/g of TZ-888 compound enzyme,40 ℃,5 h.

摘 要：本研究根据苎麻胶质的主要成分为果胶、半纤维素和木质素，用高活性的KDN果胶酶和TZ-888复合酶（主要是木聚糖酶和甘露聚糖酶）从pH值、浴比、酶用量、金属离子、温度、脱胶时间等方面进行单因素试验，然后选取影响显著的浴比、酶用量、温度，时间进行四因素三水平的脱胶试验，结果表明干苎麻采用KDN果胶酶脱胶最佳组合为浴比1：12，pH 8.6， 1 mmoL/L Mg2+，酶用量200 IU/g，温度45 ℃、时间4 h时处理，TZ-888复合酶脱胶最佳组为浴比1：18，pH 4.0， 1 mmoL/L Ca2+，酶用量300 IU/g，温度40 ℃，时间5h进行脱胶为优化的试验条件。

The results showed that the decompound ratio of molybdenum disulfide and ratio of sulfur fixation could reach 99.5% and 92% respectively when the reactant ratio n(MnO_2)/n(MoS_2) was 3, reaction temperature was 450℃ and 550℃, reaction time was all 2h, and air flow was 15-20ml/min. The calcine were leached by sulfuric acid when the temperature was 30℃, and the leaching ratio of molybdenum and manganese could reach 99% and 92% respectively.

结果表明，将辉钼矿(MoS_2)和二氧化锰(MnO_2)按摩尔比1：3的比例混合均匀，在管式炉中依次在温度为450℃和550℃下分别焙烧2小时，鼓风量为15-20ml/min，此条件下MoS_2的分解率可达99.5%以上，固硫率可以达92%。

Vishnu entered a dark fourth dimensional dream that did not support his field or continued life.

毗瑟挐进入了一个第四密度的黑暗梦想，那里并不支持他的能量场或继续生命。

Leaders and decision-making persons use it to collect the data, including the information of unit work, handing in fee, oweing fee, prepaying fee,changing and afterpaying and account transfering of joining-insurance employee, and account paying of all kinds of insurances from hospitalization insurance institutions.The collected data is picked up, organized, switched and showed to user.

该子系统主要面向各级领导、决策分析人员；从各个医疗保险经办机构和定点医疗机构采集数据，包括在各个医疗保险经办机构处理的单位办公信息，单位缴费、欠费、预缴费信息，参保职工变更信息，参保职工增减变动信息，参保职工补缴信息，参保职工帐户划拨信息：包括各定点医疗机构处理的各险种帐户支出信息，各险种的统筹金支付信息等；将采集的数据提取，组织和转换，然后展示给用户。