查询词典 nitric oxide

After coating the solutions on the substrates, the precursor films will go through a heat treatment to pyrolyze the polymer and form solid films, In this paper, we show some representative oxide and nitride films grown by PAD, including simple oxide/nitride such as TiO2, GaN, A1N and complex oxide/nitride such asTiO3 and Ti(subscript 1-x)AlN.

该文介绍了使用该方法制备的一些具有代表性的氧化物和氮化物薄膜，包括简单氧化物／氮化物，如TiO2、GaN和AlN等，复杂氧化物／氮化物如（Ba，SrTiO3、Ti(下标 1-x)AlN等。

When the concentration of zinc nitrite is lower than 0.1 M,(002) is the prior face for zinc oxide. As the concentration raise, the other kinds of crystal face would appear. Among those data,(002) grows the best when the concentration of zinc nitrite is 0.06 M. We add lactic acid and citric acid respectively; there is an carboxyl group on the lactic acid and three carboxyl groups on the citric acid. The monodentate of lactic acid helps the growth of zinc oxide, compared to the tridentate of citric acid which can only produce zinc oxide film under very low concentration, but the growth of (002) face is not that stable as adding the lactic acid and zinc will electrodeposit to substrate.

实验中，当硝酸锌浓度低於0.1 M 时，氧化锌以(002)面为优选位相，当浓度提高，其他晶面将会出现，当硝酸锌为0.06 M，(002)晶面成长最佳，分别加入乳酸和柠檬酸，乳酸结构上有一羧基团而柠檬酸有三个羧基团，单芽基的乳酸有助於氧化锌成长，对照於三芽基的柠檬酸，则必须在极低的浓度下才能制备氧化锌薄膜，但(002)面成长却没有添加乳酸来的稳定而金属锌也会电沉积到基板上。

The presence of BaO affected the TPR performance of Co/SiO2, and Ba loading of 2% increased the reduction degree of Co/SiO2 at the moderate temperature (450℃). The difference of the TPR performance between unpromoted and promoted catalyst samples could be ascribed to the induction of the reduction of BaO, and the interactions between barium oxide and silica, barium oxide and cobalt oxide.

研究结果表明，氧化钡明显地影响Co/SiO2的还原性能；添加2%氧化钡提高了Co/SiO2在中温(450℃)条件下的还原度；氧化钡的还原对Co/SiO2还原的诱导、氧化钡与氧化硅及与氧化钴之间的相互作用是导致Co/SiO2还原性能变化的原因。

In the course of selecting oxide additives material in the nickel-ferric spinel based inert anode, both the solubility in the cryolite molted salt of oxide additives and the whole thermodynamics action in electrolyte of oxide additives are discussed in this article, thus to have a comparatively reasonable selection of the nickel-ferric spinel based inert anode material.

在选择镍铁尖晶石基惰性阳极材料氧化物添加剂过程中，不仅探讨了氧化物添加剂在冰晶石熔盐中的溶解度，而且还探讨了氧化物添加剂在电解液中的整个热力学行为，从而对镍铁尖晶石基惰性阳极材料做出了较为合理的选择。

The coated article includes a glass substrate, a coating of an antimony doped tin oxide deposited on and adhering to the glass substrate and a coating of fluorine doped tin oxide deposited on and adhering to the surface of the coating of antimony doped tin oxide.

该涂敷制品包括玻璃底板、沉积和附着于该玻璃底板的锑掺杂的氧化锡涂层和沉积和附着于该锑掺杂的氧化锡涂层表面上的氟掺杂的氧化锡涂层。

In ZnO varistors with antimony oxide, zinc antimony spinel produced during sintering process results a higher non-linearity and stability. The non ohmic property can also be enhanced by adding cobalt oxide or magnate oxide, but their effects are different, Co is more effective compared with Mn.

材料中添加Sb〓O〓时，烧结过程中生成的〓尖晶石相大大提高了材料的非线性和工作稳定性，Co〓O〓和MnO〓的加入有效增强了压敏电阻的非线性特性，而Co〓增强非线性特性的效果则更加显著。

This paper describes the process for producing commercial beryllium oxide from non-beryl beryllium ore,especially the method for producing commercial beryllium oxide from high-fluorine beryllium ore and presents production situation of Shuikoushan commercial beryllium oxide.

叙述了非绿柱石铍矿生产工业氧化铍的工艺，特别是高氟铍矿生产工业氧化铍的方法，介绍了水口山工业氧化铍的生产状况。

Additionally, the nanodots were measured by EFM, and the experiment indicated that the charge of chromium oxide is negative. As the height of chromium oxide increases , negative charge of chromium oxide increases.

此外，我们用静电力显微镜观察铬氧化点的静电荷分布情形，发现在铬氧化点内的静电荷为负电荷，并且随著铬氧化点高度的增加而变多。

The outer layer consists of iron oxide and the inner layer chromium and iron oxide. The central point at hindering effect of the surface on the permeatin of hydrogen isotopes is the reduction of this oxide layer.

不锈钢表面对氢同位素透过的阻碍作用实质是该氧化层所发生的还原反应；其还原反应的程度主要依赖于与氢同位素作用的温度条件，并能够从功函数的变化中明显地反映出来。

The effect of the tool composition on the friction and wear behavior was investigated,and the morphologies of the rake face and rear face of the tool cutting the steel in air and nitrogen were observed on a scanning electron microscope. It was found that the Al_2O_3/TiB_2 tool was dominated by adhesive and abrasive wear in low speed dry cutting; while in high speed dry cutting,the tool was characterized by oxidation wear. An oxide layer of TiO_2 was formed by way of the oxidation of the reinforcing agent TiB_2 at a very much high cutting temperature, which contributed to greatly reducing the friction coefficient and increasing the antiwear life of the tool.Such a friction-reducing and antiwear behavior of the oxide layer was enhanced with increasing content of TiB_2 in the tool composite. However,the tool showed a relatively poorer wear resistance in N_2 than in air, because N_2 acted to retard the oxidation of the TiB_2 and the formation of the oxide layer on the tool rake face.

结果表明：低速干切削时，Al2O3/TiB2陶瓷刀具的磨损机制主要表现为粘着磨损和磨料磨损；而在高速干切削时，刀具的磨损机制主要表现为氧化磨损，刀具表面经由氧化反应生成具有润滑作用的反应膜而起到固体润滑作用，从而使刀具的耐磨性能提高，随着TiB2含量和切削速度的增加，反应膜的减摩抗磨作用增强；而在切削区通入氮气时，由于刀具表面氧化膜形成受阻，刀具的抗磨能力有所降低。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48