查询词典 ni

2Before the addition of Ni-Ti alloy, hard phase was nearly spherical shape; the shape of hard phase became multiangular with the increasing of Ni-Ti alloy, the interface between hard phase and binder phase presented line.

2未加Ni-Ti合金以前，陶瓷相多为球形；而随着Ni-Ti合金加入量的增多，Ti基金属陶瓷中出现了多边形的陶瓷相，陶瓷相与粘结相的界面呈现直线关系。

Gentle and soft shell shell, the daring is clear and bright, passionate joys joys, very naughtily face, natural and unrestrained Ni Ni!

温柔的贝贝，胆大的晶晶，热情的欢欢，调皮的迎迎，潇洒的妮妮！

The results show that all aluminum anodizing sludges were slightly neutral to acidic and mainly consist of more than 50% Al2O3; the similar total contents of Cu, Pb, Zn, Ni, Cd, and Cr in the 7 samples were found, namely, the concentrations of Pb, Cd were relatively lower, but that of Cu, Zn, Ni, and Cr were higher; the leaching tests indicate that all the samples were classed as nonhazardous wastes; but each of metals in the sample shows very different leaching behavior, possibly depending on their total contents and the final pH of leachates.

结果表明，铝型材污泥属于中性偏酸性物质，主要由Al2O3组成，含量在50%以上。各试样中Cu、Pb、Zn、Ni、Cd及Cr的总含量的分布趋势基本是一致的，其中Pb、Cd的含量较低，Cu、Zn、Ni及 Cr的含量较高。浸出毒性试验表明铝型材污泥属于非危险废物，但污泥中各重金属的浸出特性又各自不同，可能主要与它们在试样中的总含量和浸出液的最终pH值有关。

The coarse needle-like or nubby Al9FeNi phase existed in the cast microstructure of high content Fe and Ni alloy 2618(2#). After hot extrusion, it was broken into coarse multi-angle Al9FeNi particles. The contents of Fe and Ni have no effect on aging characteristic and the hardness of the alloy after aging.

含锆的高铁、镍2618合金经熔体高温过热处理后(4#)，在合金铸态组织中获得均匀细小的针片状Al_9FeNi相，热挤压后获得均匀细小的颗粒Al_9FeNi相；弥散Al_3Zr粒子的存在可使2618合金得到细小的再结晶晶粒组织，该合金既可获得较高的高温强度，还可获得较高的延伸率。

The results show that, Au-19.25Ag-12.80Ge brazing alloy is better, its melting temperature range is 446.76494.40 ℃, and the temperature interval between the solidus and the liquidus is 47.64 ℃. When the brazing temperature is in the range of 510550 ℃, the alloy has a good spreadability and wettability with Ni. Interface structure observation reveals that there is one continuous intermetallic layer between the brazing alloy and the base metal Ni when welding. X-ray energy spectrum analysis results show that the intermetallic layer is Ge3Ni5, and because of its brittleness, the overthick intermetallic layer will decrease the shear strength of the welding joint, therefore, the welding technology should be controlled so as to gain an ideal welding interface structure.

研究结果表明：Au-19.25Ag-12.80Ge合金的性能较好，其熔化温度范围为446.76~494.40 ℃，结晶温度区间为47.64 ℃；焊接温度在510~550 ℃范围内时，Au-19.25Ag-12.80Ge钎料合金与Ni基体具有良好的铺展性和润湿性，焊接时钎料合金与Ni基体之间形成了一条连续的金属间化合物层，能谱分析表明该金属间化合物层为Ge3Ni5，由于该化合物较脆，过厚的金属间化合物层使焊接接头的剪切强度下降，故应适当控制焊接工艺以获得理想的焊接界面组织。

The process of three-step countercurrentleaching is presented, in the first leaching step Fe as leading impurity inthe matte is leached priorly, Co and Ni are enriched in the residue of thefirst step and then are leached in the second leaching step with a lowconcentration acid, the residue from the second step containing hardleaching Fe, Co and Ni are leached with a high concentration sulfuricacid in the third step, and Cu stays in the final resude, the leachate of thethird leaching step is diluted and divided into two parts as the leachantsto the first and second leaching step.

在此基础上，提出了三段逆流选择性浸出技术：即第一段用低酸优先浸出钴冰铜中杂质铁，将钴镍富集到第一段的浸出渣中，第二段再用低酸浸出渣中部分钴镍，第三段用高酸浸出第二段渣中难浸的钴镍铁，将铜留在最终的浸出渣中，第三段浸出液经稀释，分流，分别返回至第一段，第二段作低酸浸出介质。

In this paper, the fabrication method and process of Ni-Cr-Ni-Si thin-film thermocouples are introduced reasonedly.

这样用Ni-Cr/Ni-Si丝作为冷端补偿导线时会产生较大的误差。

Finally, the MLCC (Multi-Layer Ceramic Capacitor) chips after different duration of reoxidation process were utilized to analyze dielectric performance and oxidation of Ni inner electrodes. The results showed that the formation of NiO would result in the discontinuity of Ni electrode and further degrade the capacitance and IR of the chips.

最后，本研究将制作完成的多层电容元件，经过不同补氧时程的处理，结果显示镍电极的氧化，会造成电极的不连续情况，以及降低电容和绝缘电阻值。

It was observed in the Cr-Ni-Mo steels that the intergranular ductile fracture is caused by the reprecipitation of MnS particles in the steel with ordinary S content, and the overheating is also performed by the repreeipitation of AlN or VC particles along the prior austenite grain boundaries in one containing low S. Thus, a proposal seems to be made that the mechanism of overheating of Cr-Ni-Mo steels is related to the solution and reprecipitation of MnS, AlN or VC particles along the prior austenite grain boundaries.

MnS粒子的重新析出使普通硫含量的Cr-Ni-Mo钢发生沿晶延性破断，而AlN或VC粒子在高温奥氏体晶界的重新析出也能使低硫的Cr-Ni-Mo钢过热。

Sixteen Scenedesmus species or strains have been employed to investigate the maximum capacity of nickel accumulation in 10 mg/L Ni solution. The results showed that the capacity of accumulating Ni from aqueous solution in 16 Scenedesmus species or strains showed the diversity.

对不同Scenedesmus品种的藻细胞从含镍水溶液(10mg/L)中累积金属镍的能力进行了分析，结果表明：藻细胞对镍的生物累积量表现出明显的品种差异性。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"