查询词典 ni

Therefore,〓 and 〓 are good fluorescent switch for pH in presence of Cu or Ni. In the view ofthermodynamics, the electron transfer process from M ( M = Cu, Ni ) center to fluorenyl isfavored as indicated by the positive value of 〓.

从热力学的观点考虑，因为计算出的电子转移的电势变化〓是一个较大的正值，电子转移是有利的。

The Ni-Fe and Mg-Al-Fe-LDH show paramagnetism at normal temperature, the calcined samples of LDHs show super-paramagnetism. The magnetization increases with the higher Fe~(3+) content and is independent of the crystal structure of LDHs. Magnetization of the calcinates of Ni-Fe-LDHs is higher than the Mg-Al-Fe-LDHs.3. Two novel SFME systems were found for the first time, that is furaldehyde/DMF/water and furaldehyde/ethanol/water system.

结果表明，Ni-Fe和Mg-Al-Fe型LDHs本身及其煅烧产物在常温下均呈现顺磁性，其煅烧产物均呈现超顺磁性；同类LDH中其煅烧产物的磁性大小与Fe~(3+)含量成正比而与LDH的晶体结构无关，Ni-Fe LDHs及其煅烧产物的磁性强于Mg-Al-Fe LDHs及其煅烧产物，。3。

Ni-P-mCMC/mCS bipolar membrane was prepared from carboxymethyl cellulose modified with phosphorylated agent as a cation exchange layer and chitosan modified with glutaraldehyde as an anion exchange layer. The electrolysis cell was constituted by Ni-P-mCMC/mCS BPM as a septum for electrogenerating furfural alcohol and furoic acid.

以磷酸化试剂改性羧甲基纤维素钠制备了阳膜层，以戊二醛改性壳聚糖制备了阴膜层溶胶，将阴膜层溶胶流延于阳膜层上，制备了P-mCMC/mCS双极膜，而后以化学镀方法在阳膜层表面镀镍，制备了Ni-P-mCMC/mCS双极膜，并应用于成对电合成糠醇、糠酸。

Among whole technique exploitation process, this paper will emphasize in UV-LIGA process discussion , thick film photoresist SU-8 reflows generable fluid situation for dot shape influence and fixed Ni stamper manner whether it suits below thickness 0.5mm insert influence of electroforming Ni stamper.

在整个技术开发过程中，本文将著重在UV-LIGA制程上的探讨、厚膜光阻SU-8热回流时，所产生的流动情形对Dot形状的影响以及固定镍模仁之方式是否适用於厚度0.5mm以下电铸镍模仁的嵌入情形。

Methods Twenty-four extracted teeth block were bonded with Ni-Cr alloy and 24 resin block were bonded with Ni-Cr alloy by two kinds of adhesive material. Those were Gluma comfort bond and Single bond. Those bonding complexes were stored in normal saline solution for 72 hours.

用两种通用型粘结剂（G1uma comfort bond与Single bond）分别将24颗离体牙试块与Ni-Cr合金粘结，24个树脂试块与Ni-Cr合金粘结，生理盐水中储存72h后分别测量抗拉伸强度和抗剪切强度。

Studied the coordination chemical reaction of Fe、Co、Ni、Cu、Mg、Ca、Al with TC,OTC,CTC and the ternary association of Co-OTC、Ni-CTC with DAN,we found that the formation of new compounds improved significantly the hydrophilic properties of TCs,the TCs are transformed into hydrophobe from hydrophilic matter.

2研究了Fe、Co、Ni、Cu、Mg、Ca、Al与TC、OTC、CTC之间的配位化学反应和Co-OTC、Ni-CTC与DAN之间的三元缔合作用，发现新化合物的形成显著改善了TC、OTC、CTC的亲水性能，使其由亲水物质转变为疏水物质，有利于提高亲水有机溶剂气浮浮选体系对水样中痕量四环素类抗生素的测定灵敏度和分离/富集效率。

By IBAD method, the amorphization ranges obtained in Ni-Nb, Ni-Mo and Co-Mo systems were 20-80 at.

研究结果表明，对于Ni-Nb、Ni-Mo和Co-Mo三个系统，IBAD方法获得的非晶合金形成范围分别为20-80at。

XRD and SEM analysises show that the V, Ti and Ni elements interdiffuse between the granules and Ni powders took places, resulting in forming a diffusing interlayer, its thickness increased with raising of the sintering temperature.

经XRD及SEM分析表明，烧结后，V2.46TiFe0.54合金颗粒与Ni粉之间发生了V、Ti、Ni的扩散，形成了扩散中间层，该中间层的厚度随烧结温度的升高而增厚。

Choose NI China to laun ch your career and grow with NI China!

如果你想和我们共同迅速地成长，那就选择NI China开始你职业生涯的第一步吧。

It is also showed that,by the second warm compaction,the monophase Cu-Ni solid solution is easier, Cu powder and Ni powder sinter has higher density and hard.

结果发现，在铜粉和镍粉反应过程中，二次温压对烧结体显微组织、密度和硬度有重要的影响。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"