查询词典 negative plate

A photo-tool is prepared which is a negative of the required etch image and is often a silver photographic emulsion plate.

一个照片工具准备这是一种必要的蚀刻负面形象往往是银感光乳剂板。

In addition, when the modified PVA resins fulfilled requirements in the following: 1 the acetalization degree varied from 60 mol% to 80 mol%, 2 the esterification degree varied from 10 mol% to 20 mol%, 3 the amount of hydroxyl group was 5-25 mol%, 4 the range of value of B/P(the mass ratio of the binder to diazo resin) was from 4 to 4.5,5 the range of its molecular weight was from 4×10^5 to 8×10^5, the negative PS plate obtained had excellent sensitivity, hydrophobic property, good developability, good ink receptivity and good scratch resistance.

因此其分子量、酯化度和缩醛度的确定，必须综合考虑各项性能之间的平衡。缩醛度为60-80 mol%，酯化度10-15mol%，羟基5-25 mol%，分子量约为4-8万，B/P为4-4.5时，制得的阴图PS版的感度、显影性、着墨性和耐磨性都较好。

In this paper, NO is generated by negative pulsed discharge between needled and plate electrodes in dry air at the atmospheric pressure, Some of the important parameters affecting concentration of NO and NO2 have been investigated. These include the pulsed discharge frequency, the distance between electrodes and electrode polarity.

脉冲电弧放电是产生医用吸入性NO 的一种新方法，因此，本研究采用负脉冲电弧放电，以大气压下的干燥空气为原料，研究了放电频率、电极间距和电极极性等参数对NO 和NO2浓度的影响。

Goldenrod paper: Opaque orange paper on which film negative is assembled for plate -making.

黄花纸：橙色不透明、拼负片大版用的基纸。

2Nd, the identical kind of particulate matter in the identical kind of electric field, impossible one to be able to bring the positive electricity, one can bring the negative electricity, can only have one kind of electric charge, then on the plus and minus two pole plate's material is various, fact everybody saw on two pole plate's materials are entirely alike, does not have the difference phenomenon

同一种颗粒物质在同一种电场中，不可能一会带正电，一会带负电，只能带一种电荷，那么正、负两极板上的物质是各不相同，事实大家看到的两极板上的物质是一模一样，沒有区别的现象。

The opened magnetic circuit is composed as tow NdFeB permanent magnets and a top plate without U-yoke. After take analyzed deeply for the opened magnet circuit with FEMM (Finite Element Method Magnetics) we find out the field distributing that is separated into three sections . One is the main area what we called as positive field section. Beside the main field there are tow areas that are called the inverted field sections. Loudspeaker arise a very serious distortion when the voice coil moving into inverted field areas. The direction of induced current in the coil part of entered inverted field area is same with the current driving into loudspeaker so that total currents increas largely and heat increase rapidly. With more coils moving into inverted area the voice coil will take on negative inductance properties. It is the main reason that voice coil is burned by heating with increasing current due to arise negative inductance. So opened magnetic circuit is not suitable for the woofers in which the voice coil have wider displacement range. When using this kind magnetic circuit design, the voice coil moving range should be less than the range of positive field to avoid loudspeaker arise serious distortion and heating. Even though voice coil moving range is in the positive area, loudspeaker will still arise more distortion because the field distribution is very cliffy at tow sides of the positive area and full range of magnetic field distribution is not parallel that will arise distortion. Base on above reasons, opened magnetic circuit is not an ideal magnetic circuit for low-frequency loudspeakers. But it can be used in mid-range or high-frequency productions.

开式磁路是由2片钕铁硼磁铁和主导磁板和导磁垫片组成，我们在实践过程中发现这种磁路结构不适合于低频扬声器的使用，我们通过使用FEMM（Finite Element Method Magnetics）软件包对该磁路进行了分析，该磁路的磁场范围被分成3个区域，其中在主导磁板附近形成一个正向磁场，在正向磁场的两边存在反向的磁场，音圈在工作时有很大一部分进入了反向磁场中，在反向磁场内线圈的感应电流方向与驱动电流方向相同，使得音圈呈现出负感抗特性，由于音圈的负感抗特性引起电流的增加导致音圈发热甚至烧毁，因此在扬声器中使用开式磁路时，音圈的运动范围应控制在正向磁场范围之内，否则音圈运动到反向磁场区域时将会产生很大的失真和发热，即使在设计时已经将音圈的运动范围控制在正向磁场范围之内，由于正向磁场的2个边缘磁场强度衰减太快，同时开式磁路中磁场的分布不是平行的，而是自由发散的分布，这样肯定会导致扬声器的非线性失真，因此我们得到的结论是：开式磁路并不是一个理想的磁路，它不适合于低频扬声器的使用，但它还可以应用于中高频扬声器。

Recording electrode was placed on the scalp near the olfactory bulb. Results Electrically evoked olfactory potentials composed of triphasic negative-positive-negative peaks, named N1, P1, N2 respectively, were detected on the olfactory region. The latencies of N1, P1, N2 were 16.27ms, 25.36ms, 49.75ms respectively in cribriform plate.

结果 电极置于筛板和鼻甲嗅区粘膜可记录到一组&负-正-负&三相的诱发电位波，依次命名为N1、P1、N2，当刺激强度为2.0 mA时，筛板粘膜诱发电位的潜伏期分别为16.27、 25.36、 49.75 ms；鼻甲嗅区粘膜诱发电位的潜伏期为20.29、31.31、 46.83 ms。

Using electric operation controlled lifting system so that the floating plate safe, stable, powerful stress job to ensure that the molding, simpler and quicker. 2 strong suction system without phase vacuum suction, negative pressure may have been the ideal state, the use of more convenient. 3 equipment, power can achieve the best working state of the lowest electricity consumption standards. 4 soften me with automatic temperature control system can be made under different heating plate settings required. 5 operating system, the use of numerical control system to operate, effective improve the efficiency of the operator. 6 advanced technology can be a cooling suction pressure molding, may also be under the light box, the different effects of the word alone or in a separate suction pressure, so that light boxes, forming a word.

产品特点：1。采用电操作控升降系统，使浮动板安全，平稳，工作压力强大，确保成型更简便，快捷。2 吸气系统功能强劲，无需阶段吸真空，可一直处于理想负压状态，使用更方便。3 设备功率可达到最佳工作状态的最低电耗标准。4 软化箱装有自动恒温控制系统，可根据板材不同的加温需要设定。5 操作系统采用数控系统操作，有效的提高了操作人员的工作效率。6 技术先进，可吸压冷却一次成型，也可根据灯箱，字的不同效果，单独吸或单独压，使灯箱，字一次成型。

These properties include: loading function of soil body under raft plate;"dense outside and disperse inside"or "otherwise" pile distribution method ; negative resistance of soil block under raft plate and at top pile; settlement of pile raft foundation and deformation characteristics of soil mass under pile end;and application of dispersed pile raft foundation for high buildings.

主要包括：筏板底土体分担的荷载作用、&外密内疏&和&外疏内密&布桩法、带裙房桩筏基础的处理、筏板下块状整体及桩上部负摩阻力、桩筏基础沉降及其桩尖下土体的变形特性、疏桩桩筏基础在高层建筑中的推广应用等。

In ancient times, when vacuum tubes were still in use, the A battery (often about 6 volts) heated the filament or cathode to boil off electrons, the B battery, positive with respect to the cathode, sucked the negative electrons to the plate, while the C battery, a few volts negative with respect to the cathode, tended to repel the electrons back toward the cathode.

古时候，还在使用真空管时，A电池（通常为6V）通过加热灯丝或阴极来蒸发电子，B电池，正极连接阴极，将负电子吸引到极板上，而C电池，只有几伏，负极连接阴极，将电子击回阴极。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐