查询词典 natural vibration

Firstly, this paper researched the mechanism of tubing string vibration when natural gas flows in horizontal well tubing string. Secondly, established whole tubing string undamped and damped vibration system model according as reasonable assumption data of one horizontal well. Apply finite element analysis software to calculate tubing string natural characters, simple harmonic dynamic behavior of stable gas production and nonlinear dynamic behavior. Finally, this paper carried out the safety varied frequency of gas well and the method of vibration reduction.

本文首先从理论和数值模拟研究了天然气在水平井油管柱内的流动诱发油管柱振动的机理，然后在合理假设的基础上结合某水平井数据建立了全井段油管柱无阻尼和有阻尼振动系统模型，利用有限元软件计算分析了油管柱固有特性、稳产简谐动力学响应和非线性动力学响应，针对油管柱振动规律提出了天然气安全调节频率范围和减振措施。

The effect of tribology factors on bearing vibration is studied experimentally. AR model and WPT are used to processing the normal arid abnormal signals. The results are as follows:1. The vibration of ball bearings is caused by the tribology action of contact pairs of ball and ring races and has the essential of tribo-dynamics. Any factors affecting the tribology characteristics of contact pairs will affect vibration and noise of bearings consequently.2. Vibration characteristics of bearing keep almostly unchanged with the increasing of axial load expecting the increasing of nature frequencies. When radial load increasing with axial load unchanged, nature frequencies keep unchanged but some new vibration peaks appears in the spectrum.3. Vibration amplitudes are damped and nature frequency are enhanced with sufficient lubrication. Vibration and noise of bearings increase obviously and roar can happen and the contact surfaces scratch slightly under insufficient and unclean lubrication state. Bearing will be disabled in a few minutes without any lubrication.4. Bearing vibration is unstable under low speed. With the speed increasing, the vibration become stable and natural frequencies increase slightly but the amplitudes increase apparently.5. Bearing vibration can be excited only by some harmonics ofwaviness without lubrication and by all harmonics with lubrication based on the theoretical analysis.6. The nature frequencies of ball bearings decrease with the increasing sizes. When international clearance increasing, nature frequencies decrease in radial and increase in axial and angular and the amplitudes increase in radial and decrease in axial and angular. When the number of balls increasing, nature frequencies increase and amplitudes decrease. When the pitch diameter increasing, axial nature frequency increase and others nearly keep no change. When outer race groove curvature radius increasing, nature frequencies increase in radial and decrease in axial and angular and amplitudes keep no change in radial and increase in axial and angular. When inner race groove curvature radius increasing, nature frequencies decrease and amplitudes increase.7. The distortion in amplitude and frequency components of bearing vibration signals picked up by the present probe measurement method is founded and right conclusions cannot be achieved by the signals. When accelerometer is rigidly screwed with steel stud onto a flat outer surface of a ball bearing, vibration signal can be got without distortion and the reliability of research on bearing vibration is assured.8. AR model is suitable for large samples of bearing vibration signals, square root of length of samples can be used as the upper limitation of order determination and the FPE order selection criterion is effective. Many advantages of AR spectrum are founded over the classical based on FFT.9. Time-Frequency analysis is necessary for abnormal noise of ball bearings. WPT overcomes the principle shortcomings of STFT and proved to be a best tool to process the abnormal signals.

理论分析和试验研究表明： 1球轴承振动是钢球—滚道接触副中的各种摩擦学作用引起的，具有摩擦动力学的本质，任何对接触副的摩擦学特性有影响的因素都将对球轴承的振动和噪声特性产生影响； 2中心轴向载荷作用下，载荷增大使球轴承的固有振动频率升高，载荷越大同样的载荷增幅引起的频率升幅减小，足够大的中心轴向载荷作用下载荷的变化对球轴承振动的频率特性不会产生明显的影响； 3轴向和径向联合载荷作用下，径向载荷不大时球轴承振动的固有频率基本不变，但是可能引起变刚度激励的非线性振动，出现新的频峰，过大的径向载荷将使部分钢球脱离接触，使球轴承的振动和噪声呈现不稳定状态； 4润滑对球轴承的振动和噪声特性有重要的影响，良好的润滑对振动有明显的抑制作用，润滑不充分时，振动和噪声的水平会有明显增高，一定条件下还会激发接触副中的谐振，发出啸声，造成接触表面的伤害，无润滑干接触时，短时的运转就会损伤接触副表面，使振动和噪声迅速增大，并随时可能引发严重的磨损和卡滞失效；接触副润滑良好时，油膜的"刚化效应"使球轴承振动的固有频率有所提高，润滑剂中含有弥散性污浊时，振动的幅度总体升高，但弥散性污浊不会改变球轴承振动的频率特性；浙江大学博士学位论文：球轴承振动的研究 5低速时，球轴承振动的基本特征呈现不稳定状态，随着转速的提高，球轴承振动的频率特性趋于稳定，固有频率频峰升高； 6理论分析表明，干接触时钢球和滚道表面波纹度的某些谐波分量能激励球轴承的振动，振动的幅值与谐波幅值成正比，实际球轴承中钢球的分布不可能完全均匀，波纹度的激励作用会随时发生；润滑接触的分析表明，波纹度的任意谐波分量均能激励球轴承的振动； 7球轴承的几何和结构参数分析表明，球轴承尺寸越大，径向、轴向和角振动的固有频率越低；钢球中心圆直径增大，球轴承的径向和轴向振动的固有频率基本不变，角振动的固有频率有所上升，振动的幅频特性基本不变；径向游隙加大使球轴承的径向振动固有频率降低，轴向和角振动的固有频率有所升高，径向振动幅频特性的幅值升高，而轴向和角向降低；钢球的数量增多使球轴承振动的固有频率上升，幅频特性的幅值下降，径向振动的幅值下降最为明显；外圈沟曲率半径系数增大使球轴承径向振动的固有频率升高，轴向和角振动的固有频率降低，径向幅频特性基本不变，轴向和角向幅频特性幅值升高；内圈沟曲率半径系数增大使径向、轴向和角振动固有频率均下降，振动幅频特性的幅值均有升高； 8试验对比表明，传感器采用探针式安装时，由于探针接触副接触特性的影响，钡(量得到的球轴承振动信号有失真，采用专门设计和制作的试验球轴承，以固定式安装加速度计，首次测量得到了球轴承振动的真实信号，通过对振动信号的分析，验证了球轴承振动的理论模型； 9)基于时间序列分析的AR模型适用于大样本球轴承振动信号的分析，以样本长度的均方根值作定阶上界，FPE做判阶准则，给出的AR谱光滑，频率分辨率高，是球轴承振动分析的简便而可靠的手段； 10以时频域分析的小波包变换分析球轴承异音信号能够比较好地定位和聚焦异音发生的时间，时间间隔，频率范围，同样是球轴承振动分析的可靠的手段，可用作球轴承故障诊断技术。

Use the cubic function to be the displacement funtion, then base on the energy variation principle, the natural vibration equation is derived, which considers the pressure force and the boundary conditions of the compressed bar.

采用三次函数作为压杆单元的位移函数，基于能量变分原理，构造了一种可以考虑初始内力及边界条件的压杆单元。

In the experimental work, application of proportional controller to active vibration control incorporated with passive vibration isolator to suppress its resonant oscillation of natural frequency is studied in this project. Vibration acceleration acquired from accelerator is inputted to controller as feedback signal. The processed signal from controller is transmitted to voice coil actuator to control vibration. Firstly, based on the theoretical equations which govern the system vibration, the physical mechanism of active control in total system is studied.

在实验部分，则运用比例控制器进行被动式隔振系统自然频率共振抑制之主动控制实验，控制回馈讯号采用加速规量得之振动加速度值，经由控制器计算输出控制讯号驱动音圈致动器进行主动控制。

This paper presents natural vibration experiment and sine excitation experiment of the frame with different energy dissipation braces （the little character brace or the unidirectional diagonal brace or the little- character-toggle-brace）and compared their capability of energy dissipation.

介绍了空框架以及附加单向斜撑、小八字撑以及小八字曲拐撑的4种结构的自由振动试验以及正弦稳态激振试验，比较了其消能能力。

The structural model of a beam with bending-resistant spring hinge is established for the natural vibration analysis of prefabricated highway steel bridge s.

引入抗弯弹簧铰模拟结构接头传递弹性弯矩的特性，建立了用于装配式公路钢桥竖向自由振动分析的带抗弯弹簧铰梁模型；利用有限元程序ANSYS对接头进行数值仿真，得到了抗弯弹簧铰刚度。

The distribution of gear's contact stress, root stress, and contact engagement line in the engagement situation of gear pairs, were obtained on the base of explicit integration method. 3. Adopting the method of system matrix, the torsional vibration differential equation of general shafting was gained. The simple harmonic forms of excitation torque under the normal combustion or piston flameout of in-line engine and v-type engine were analysed. The decoupled algorithm of free vibration and forced vibration and the solution to the vibration damper's energy of resistance and the off-resonance calculation were studied. The sensitivity formulations of the natural frequency and vibration mode to physical parameters of system were derived by solving the eigenvalue problem. These sensitivity formulations provided the theoretical base for the dynamic modification of structure.

运用系统矩阵法建立了轴系的扭振微分方程，并对直列和V型发动机在正常发火和气缸熄火工况下的激振力矩进行了详细的简谐分析；基于精确方法推导了自由振动和强迫振动的解耦算法，给出了能量法计算中的减振器阻尼功求解和非共振计算方法；并研究了曲轴系扭振非线性分析中的变惯量问题，得到了单缸转动惯量的精确求解公式以及变惯量和固有频率的关系式；最后，从特征方程和振型正交性出发，推导了固有频率和振型对轴系转动惯量和刚度等物理参数的灵敏度，为扭振系统的结构动力学修改提供了理论基础。

The energy method is applied to derive the natural vibration frequency and mode shape for a simply supported beam and simply supported plate before and after damage.

利用能量法近似地得出了损伤前和损伤后简支梁和四边简支板的自振频率和振动模态。

According to the structural properties of tuning blade-disk assemblies, the matrix perturbation method is used to analyze the influence of mistuning on the natural vibration characteristics. The formulas for perturbation values of first and second order are derived.

根据谐调叶盘的结构特点，用矩阵摄动法分析了失调对叶盘固有振动特性的影响，推导了孤立特征值和密集模态组二种情况下固有频率和振型的一阶、二阶摄动计算公式。

The natural vibration period of structure,story drift, variation characteristics of story lateral displacement,stiffness,energy dissipation feature and investment-income of the three structural schemes of eccentric braced steel frame,knee braced steel frameand moment resisting steel frameare compared.

偏心支撑、隅撑支撑钢框架通过耗能梁段发生剪切屈服耗能，大震下既能提供足够的刚度，又能保证一定的延性，具有较强的耗能能力，是高烈度地震区理想的结构体系s。'〕。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。