查询词典 n-tetracosane

In terms of absorption proportion, element N was the nutritional limiting factors in spring, summer and autumn, while element P in winter. However, both became the nutritional limiting factors in all years in term of absolute absorption.

从浮游植物吸收N、P 的配比分析， N为春、夏、秋3 季的营养限制因子， P 为冬季的营养限制因子，但从N、P 的绝对值看， N 和P 都是全年的营养限制因子，因此其水质营养类型属于亚热带贫营养型。

The effects of various reaction conditions were studied by GC analysis. Reaction time has slight effect on the conversion of acenaphthene. The selectivity of N-phenyl aminoacenaphthene increases with reaction time. Biacenaphthenyls or N-phenyl aminoacenaphthene is in the majority, 77.6% or 90.2% when the molar ratio of AlCl3 to acenaphthene is 1.2 and 2.4 respectively.

GC考察了不同反应条件对苊转化率和产物选择性的影响，时间对苊转化率影响不大，N-苯基氨基苊的选择性随着时间增加而增大；随着AlCl3用量的增加，苊转化率和N-苯基氨基苊的选择性随之增加；AlCl3与苊的摩尔比为1.2和2.4时，产物中联苊和N-苯基氨基苊的选择性分别达到77.6%和90.2%。

Let H. f and g be real polynomials in x, y of degree n+1, at most n and at most n respectively,△ be a set of h such that the real algebraic curve H =h has a compact component δ, and ω=gdx-fdy be a polynomial 1-form.

设H是n+1次实多项式，f，g为至多n次的实多项式，记△为使实代数曲线H=h有一个紧分支δ的所有h之值的集合，ω=gdx-fdy为多项式1-形式。

We posed the concept of sufficient intersection about s(1≤s≤n) algebraic hypersurfaces in n-dimensional space and proved the dimension of polynomial space Pm(which denotes the space of all multivariate polynomials of total degree≤m) on the algebraic manifold S=s(f1,…, fs) where f1(X=0,…, f s=0denote s algebraic hypersurfaces of sufficient intersection, then gave a convenient expression for dimension calculation by using the backw ard difference operator.

给出了n维空间中s(1≤s≤n)个代数超曲面充分相交的概念，证明了n元m次多项式空间Pm在充分相交的代数流形S=s(f1，…， fs)（f1=0，…， fs=0表示s个代数超曲面）上的维数，并利用倒差分算子给出一个方便计算的表达式；构造了沿代数流形上插值适定结点组的叠加插值法；证明了在充分相交的代数流形上任意次插值适定结点组的存在性；给出代数流形上插值适定结点组的性质和判定条件。

The experimental result of anaerobic ammoniation shows, the most appropriate hydraulic retention time is between six and eight hours, the longer the HRT , the higher the rate of NH3-N net increase.

现场调查分析表明，屠宰废水是一类富含有机氮的有机废水，其NH_3-N浓度在整个生物处理工艺过程中存在一定变化规律，特别在厌氧之后，NH3-N浓度将大幅增加(净增加70%—150%)，显然多数以进口NH_3-N指标进行硝化及反硝化的设计是错误的，且是导致NH_3-N难以达标的一个重要原因。

The new materials(N/BBCC and J/BBCC) and their transmigration parent put up the similar phenotypes in development stage,morphological characters,POD enzyme activity,and so on.But differences in male fertility,proline content and relative conductance rate were existed among them,in which the development of androecium in N/BBCC was abnormal,showing serious male sterility,and the proline content and relative conductance rate in N/BBCC and J/BBCC were much lower than their transmigration parent,C/BBCC.

两个新材料及其轮回亲本C/BBCC在生长发育时期、植株外部形态特征、POD酶活性等方面表现基本一致，但在雄性育性、脯氨酸含量及相对电导率上存在着明显差异，其中N/BBCC雄蕊发育不完善、花药瘦小、药内花粉量很少且多为无生活力的畸形花粉，表现严重败育；J/BBCC和N/BBCC的脯胺酸含量及相对电导率明显低于其轮回亲本C/BBCC。

It can be seen that the bulk modulus depends mainly on electrons per atomic volume and mass density, while covalent structure of chemical bonding and N content make more contribution to theoretical hardness, and appropriate content N—N covalent bonding in the same direction tends to increase the shear modulus of nitrides.

说明在Tc的氮化物中，其体弹模量与材料的晶体结构、平均每个原子上的电荷密度和材料的质量密度有关；化学键的共价性结构和氮元素的含量对理论计算硬度有正作用；而剪切模量的极大值则与其层状结构及体系中一定量的方向基本一致的N—N键相关。

The characteristics of pentacene/perylene derivatives based organic solar cells are investigated in this thesis Donor and acceptor layers are pentacene and N N'-dioctyl-3 4 9 10-perylenetetracarboxylic diimide (PTCDI-2~13C) respectively Twelve organic solar cells with pentacene/PTCDI-2~13C heterojunctions were fabricated to study the influence of various alkylic perylene derivatives on the power conversion efficiency Under the sunlight simulator with AM1 5G filter and 100 mW/cm2 the solar cell of pentacene/PTCDI-7C heterojunction with cathode of Ag/Al bilayer has the best performance among the devices with pentacene/PTCDI-2~13C heterojunctions In PL spectrum analyses the pentacene/PTCDI-7C film had lower recombination rate than the other pentacene/PTCDI-2~13C films; therefore more excitons could reach the P/N junction and enhance short-circuit current Furthermore the PTCDI-7C film grown on the surface of penatcene was more matched than other PTCDI films analyzed by the PL peak shifts of 10 nm and 45 nm thick PTCDI-2~13C and images of atomic force microscope More lattice match between the films of pentacene and PTCDI resulted in fewer defects in P/N junction and more carries can reach electrodes Accordingly the power conversion efficiency approach 2% was obtained from the solar cell with the active layer of pentacene/PTCDI-7C

本研究探讨以五环素/骈苯衍生物异质接面太阳能电池之特性，利用pentacene作为电子施体有机材料，PTCDI -2C~13C作为电子受体有机材料，制作出异质接面为pentacene/ PTCDI-2C ~13C等12种有机太阳能电池，比较不同碳数的骈苯衍生物对於有机太阳能电池之光电转换效率之影响。在AM1 5G、100 mW/cm2的模拟太阳光下，以pentacene/PTCDI-7C异质接面太阳能电池具有短路电流9 882 mA/cm2、开路电压0 376 V、填充因数0 523及光电转换效率达1 945%，皆比其他pentacene/PTCDI-2C ~13C异质接面太阳能电池来的大。由薄膜分析可知PTCDI-7C在这12种太阳能电池中具有较低的电子电洞复合发光效率，可以让较多激子到达异质接面进行电荷分离，减少电子电洞对复合发光的机率；此外，由光激发萤光光谱之峰值位移配合原子力显微镜表面结构图，可以得知当PTCDI-7C成长在pentacene上时会顺著pentacene的结构成长薄膜，故较无缺陷产生在P/N接面处；而在其他结构下则无此现象产生，致使在pentacene/PTCDI-7C薄膜中的载子有较大的机会可以移动至电极，使光电流提高，进而使光电转换效率提高。

In the problem, there are m persons who are to be assigned to do n jobs, and the number of the persons who are assigned to do the jth job is bj, where bj is an unknown positive integer number to be calculated such that djbjej, dj and ej are known positive integer number (j=1,2,…,n) such that ∑nj=1bj=m and m≥n.

考虑一类较一般的最优指派问题：欲指派m个人做n项工作，要求每个人只做一项工作，第j项工作可以由bj个人共同去做，其中bj是待求未知数，满足dj≤bj≤ej(即ej，dj为第j项工作所需人数的上下限)及∑nj=1bj=m，dj，ej为已知常数，j=1，…，n。

The absorbance reproducibility of the samples was good, RSD=0.99%(n=6),the average recovery was 96.67%,RSD=0.45%(n=6). There had a difference between biuret menthod and Folinlowry.

结果 双缩脲法快速、简便，得到样品的含量为47.21%，精密度实验RSD=0.20%(n=6)，样品重现性好，RSD=0.99%(n=6)，平均回收率为96.67%，RSD=0.45%(n=6)；两种方法测定之间有差异。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。