查询词典 monomer

The results indicated that the UV coatings made from epoxy acrylate resin/TPGDA monomer by the weight ratio of 80/20, and 3% dosage of benzil dimethyl ketal photoinitiator had an excellent films properties such as hardness, tensile strength, gloss and weatherability, while it possessed a poor impact resistance and adhesion of films.

试验结果发现，以预聚合体/单体比例为80/20、单体种类为二丙烯酸三丙烯乙二醇酯、光引发剂Benzil dimethyl ketal添加量为3%调配而成之UV涂料，其涂膜硬度、拉伸强度、光泽度及耐候性等性质优良，但涂膜耐冲击性、附著性不佳。

The diamine monomer, 2-(4-aminophenyl)benzo(1,3)oxazol-5-amine, was synthesized by condensation reaction.

117膜，而且PWA的引入并没有改善复合膜的电池性能。

Bis-(4-bromobenzoyl) benzene as the monomer of poly was synthesized by Friedel-Crafts benzoylation reaction. Poly-Ⅱ synthesized via palladium-catalyzed aryl amination reaction using 1, 4-bis-(4-bromo-benzoyl) benzene and 4, 4'-diaminodiphenyl ether as monomers.

通过傅－克酰基化反应合成了1，4-双－（4'-溴苯酰基）苯，以1，4-双－（4'-溴苯酰基）苯和4'4-二氨基二苯醚为单体，通过钯催化的胺基化缩聚反应合成了高性能聚合物－聚亚胺酮－Ⅱ。

The introduces binaphthyl bisphenol monomer on side-chain benzene ring of sulfonic group on molecular level, prepares sulfonated poly aryl ether with sulfonic group only on naphthalene ring of side chain, so that ensures chemical stability of main chain with high molecular weight, while having no influence on mechanical property thereof.

本发明从分子水平出发，将磺酸基在侧链苯环上的联萘双酚单体引入，制备仅在侧链苯环上有磺酸基的磺化聚芳醚，从而保证了高分子主链的化学稳定性，且不会影响其优异的物理机械性能。

Mol〓 by examining the acid number of the system during polymerization. The monomer emulsion of St and CTUP was formed by adjusting pH to 8, and the self-emulsified emulsion polymerization was initiated by using KPS and sodium bisulphite.

以CTUP和St为单体，通过调节体系至弱碱性(pH=8)制成单体/水的乳化液，并在过硫酸钾-亚硫酸氢钠氧化还原体系的引发作用下进行自乳化乳液聚合。

The factors which affect the average molecular weight of the polymer of AM and DMDAAC were investigated. The optimal reaction conditions are as follows: the concentration of monomer AM was 30%, while DMDAAC was 5%; the reaction temperature was 30℃, the amount of initiators at the low temperature stage was 0.05‰(compared to the weight of the monomers joining the polymerization), while V-50 was 0.025‰, the weight ratio of potassium persulphate to sodium bisulphite is 1:1, the amount of carbamide was 40‰, and complexing agent was 0.05‰, besides, aerate nitrogen gas for 8min, then the high molecular weight polymer (M=1.217×10^7) could be got after 16h reaction.

研究了影响AM与DMDAAC共聚物的平均分子量的因素，得到了优化条件为：单体浓度为30%，DMDAAC与AM摩尔比为5：95，聚合温度为30℃，低温段引发剂用量为0.05‰，K2S2O8与NaHSO3质量比为1：1，偶氮二异丁基脒盐酸盐(V-50)用量为0.025‰，尿素用量为40‰，乙二胺四乙酸二钠(EDTA-2Na)用量为0.05‰，在此优化条件下聚合反应16h后得到分子量为1.217×10^7的阳离子型聚丙烯酰胺。

The monomer ofbromostyrene was synthesized fromβ-bromobenzene by eliminating hydrogenbromide under sodium hydrate.

溴乙基溴代苯在氢氧化钠的作用下，发生溴化氢脱除反应，得到溴代苯乙烯单体。

UV-Vis spectrum showed that some monomer or oligomer were existed in this film. The results demonstrated that the PPy chains were served as both the reductant of chloroauric acid and the ligands to stabilize gold-NPs.

接着利用吡咯单体及寡聚体具有的还原性，将新合成的聚吡咯膜浸泡在氯金酸水溶液中搅拌反应，通过扫描电镜观察发现，在膜中还原生成了大量的金纳米粒子，同时在膜的表面也观察到了金纳米粒子的存在。

ABSTRACT NW/NB-PSCTLC has been prepared by doping a small amount of diacrylate monomer in cholesteric liquid crystals.

在胆甾相液晶中掺入少量的单体材料分别制备了常白和常黑模式PSCTLC。

By changing the pitch of cholesteric liquid crystal monomer can be achieved and add reflective bistable display, transmissive, scattering ...

通过改变胆甾液晶的螺距和添加聚合物单体可实现反射式双稳显示、透射式、散射式。。。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新