查询词典 mol
- 与 mol 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
This paper discussed the effect of soluent,refluence time,the oxidation state of iron in ferric salt and the mol ratio of DBU and Phn on the species,crystal form and productivity of composite.
本文讨论了溶剂、回流时间、铁盐中铁的氧化态及 DBU 与邻苯二腈的摩尔比对合成产物的物种、晶型及产率的影响,提出了合成酞菁铁的较佳试验条件。
-
The results show that dynamic softening is easy to occur in these ingots and flow stress becomes steady finally; the material constants of hot deformation are procedural parameters that stress-level coefficient α, strain rate sensibility exponent m and deformation activation energy Q are all increased with strain increasing, while stress exponent n is decreased gradually; the values α and m of the alloy homogenized are the biggest and the value n is the smallest, dynamic softening effect of the alloy is the most obvious, which can deform evenly; influence of strain on the value Q of the alloy homogenized is a little and the average value of Q is only 176.5kJ/mol, so the alloy is easy to deform; the alloy matrix shows the regular recrystallization grains when the strain is 50%; dislocation cell structure re-formed in the grains with increase of strain.
结果表明:经不同处理的Al-1Mn-1Mg合金均易发生动态软化并最终呈现稳态流变特征;热变形材料常数是过程量,随应变量的增加,应力水平参数α、应变速率敏感性指数m和热变形激活能 Q 随之增大,而应力指数 n 则逐渐减小;均匀化退火后,铝合金的α和m值最大而n值最小,动态软化效果最明显且变形均匀,在该状态下,铝合金的 Q 值受变形量影响小,平均仅为176.5kJ/mol,易进行热变形;当应变量为0.7时,基体呈现规则的再结晶晶粒组织,随着应变量的增加,晶内重新形成了位错胞结构。
-
Results, We have successfully prepared SPIO, and its core component was Fe3O4 crystal, with a size of 20~35 um, a T2 relaxivity of 0.155×10^6 mol^(-1)sec^(-1), a specific saturated magnetization of 68.39368 emu/g, and a retentivity of 21.46374 Gs.
结果:成功制备纳米级SPIO,其核心颗粒为Fe3O4晶体,颗粒大小20~35nm,T2弛豫率0.155×10^6 mol^(-1)s^(-1),比饱和磁化强度68.39568 emu/g,剩磁21.46374 Gs。
-
Results LPA at the concentrations of 5, and 25 p.moL/L increases the activity of Rho protein.
LPA主要通过Rho信号转导增强肝癌细胞的体外侵袭转移能力。
-
Theδ~(13)C of Robinia pseudoacacia and Fraxinus chinesis were gone beyond the range of C_3 plants,and the averageδ~(13)C of 7 trees under 720μmol·mol~(-1)CO_2 were higher than the average of C_3 plants,which is 27.0‰.
针叶树的叶δ~(13)C值高于阔叶树,叶δ~(13)C值明显小于枝条和根系的,刺槐和白蜡的δ~(13)C值超出了全球C_3植物的δ~(13)C值的极限范围,720μmol·mol~(-1)CO_2所有树种的平均值远高于C_3植物的平均值27.0‰。
-
Affecting behaviors of H3BO3, NaOH and PVA are studied. The optimum test conditions are as follows: 10 mL of 2%H3BO3, 10 mL of 1 mol/L NaOH, 1 mL of Rochelle salt solution, 0.16 mL of 5%PVA, 1 mL of Nesslers reagent solution, and the reaction time is 10 min.
对H3BO3,NaOH和PVA的影响规律进行了研究,提出了最佳实验条件:以2%H3BO3溶液作吸收液,1 mol/L NaOH溶液10 mL,罗谢尔盐溶液1.00 mL,5%聚乙烯醇 0.16 mL,纳氏试剂1.00 mL,反应10 min。
-
The enzyme follows typical Michaelis-Menten Kinetics with apparent Km of 3.40mmol/L for Salicin. The activation energy of the enzyme is 50.63KJ/mol.
测定该酶的最适反应温度为43℃,最适反应pH为5.1;在pH5.1,45℃下,该酶催化水杨素水解的Km值为3.40mmol/L,活化能为50.63kJ/mol。
-
The synthesis condition of PSFCS were: Fe-to-Si mol ratio being 2, silicic acid activation pH being 2, silicic acid activation time being 30~40 minutes, ageing time being 2~2.5 hours.
PSFCS的合成条件:Fe/Si摩尔比为2,硅酸活化pH值为2,硅酸活化时间是30~40 min,陈化时间是2~2.5 h。
-
Silver chloride prefers to disperse at the top site and bridge site of activated carbon surface and the interaction energy is between 46.26 and 47.64 kJ/mol.
AgCl在活性炭上的负载对位置有明显的选择性,主要以银端垂直附着在活性炭表面的顶位和桥位上,作用能在46.26~47.64kJ/mol。
-
The emulsion preferably contains an oxidatively dimerized form of a mesoionic compound having a thiolate structure, and a silver chloride content of at least 90% by mol.
该乳剂优选含有氧化二聚形式的具有硫醇盐结构的介离子化合物和至少90摩尔%的氯化银。
- 相关中文对照歌词
- Tell Me
- 1 Of 4 (Thank You)
- Aria
- Meten Presión
- 推荐网络例句
-
In contrast to the ubiquitous rising-sun-with-rays military flag of the Japanese, Chinese banners and ensigns feature a range of designs.
与遍地都是的太阳军旗不同,中国人的旗帜和徽章设计得各式各样。
-
From their small corner of Feng's Guangzhou headquarters -- a jumble of pink leashes, squeezable rubber steaks, and plastic doggy Santas for Fido's stocking -- Soleil's designers come up with at least five new products a month.
从Feng 设在广州总部的产品展示柜台上可以看到,Soleil的设计师每月至少设计出5件新产品。
-
FFT is important for additive synthesis because it helps us to estimate the values for the oscillators that produce the partials of the synthesised sounds.
FFT对加法合成是很重要的,因为它有助于我们评估产生合成音分音的振荡器的价值。