查询词典 mol

Where the absorbance A is proportional to the concentration (c, in mol/L) of the solute, the length of the path the light travels through the sample, and the constant of proportionality,ε, called molar absorptivity coefficient (L mol-1 cm-1) or molar extinction coefficient

那里的吸收度A正比于溶质的浓度，l是通过样品的光路的长度，而比例常数ε叫做莫耳吸收系数(L mol-1 cm-1)或者莫耳消光系数。

It was rev ealed that:cuprite,malachite and tenorite are the three main kinds of copper-bea ring minerals which would be supersaturated when Cu concentration in the solutio n is high enough(higher than 0.0016 mol/L,0.0079 mol/L separately) under the stu dy conditions.Copper exists in the solution mainly as the species of CuCO3 ,Cu2+ and CuOH+.The corresponding content of CuCO3 would be decrea sed following the deposition of the copper-bearing minerals,nevertheless,Cu2 + and CuOH+ would be increased.

模拟结果表明，在土壤中常见的E h和pH及研究区的年平均温度条件下，溶液中铜离子的含量达到一定的浓度时，可以生成赤铜矿(当Cu≈00016 mol/L)、孔雀石及黑铜矿(当Cu≈0 0079mol/L)等次生矿物，溶液中Cu的存在形式也发生了变化，即CuCO3所占的比例不断减小，而Cu2+和CuO H+的含量则相继增高，且Cu2+的增幅大于CuOH+。

The results revealed that the conversion was 92.4% when aniline concentration was 1 mol/L, feeding temperature was 25℃ and residence time was 11 s. With feeding temperature being the main factor, the effect of residence time decreases successively. The diazotization anomalies could be caused at aniline concentration above 1.5 mol/L. The proper feeding temperature which can lead to the highest conversion was 20~30℃.

试验结果表明，在苯胺浓度为1 mol/L，进料温度为25℃，停留时间为11 s时反应转化率达92.4%；苯胺浓度、进料温度、停留时间对反应影响程度各不相同，其中进料温度的影响最大，停留时间次之，苯胺浓度高于1.5mol/L后，对反应影响加剧，导致反应异常；从进料温度对反应的影响试验分析可得，反应转化率最高的进料温度在20~30℃之间。

Results: When the quantity of monochloroacetic acid was 0.3 mol, The preferable conditions were 0.42 mol dimethylamine, reaction temperature about 40℃, 2-hour reacton time and 50 ml dilute water.

结果 当氯乙酸投料量为0.3mol时的最佳反应条件为二甲胺0.42 mol，缩合温度40℃左右，缩合时间2h，稀释水量50ml。

The experimental result showed that three byproducts was formed and the optimal condition was as follows: the molar ratio of ethylene glycol, hydrogen bromide, and acetic acid was 1:1:1.3, when ethylene glycol was 1 mol, refluxed 5 h under the action of 100 mL toluene.

结果表明：较适宜的合成条件为乙二醇1 mol， n：n：n=1：1：1.3，在带水剂甲苯(100 mL)的作用下，回流反应5 h，约4 h后分两次追加0.12×2 mol醋酸酐，合成效果最好，产率可达到95%，反应副产2-溴乙醇及少量的1， 2-二溴乙烷、乙二醇二乙酸酯和二乙二醇二乙酸酯。

A method was developed to determine the activation energy and material parameters in the hyperbolic sine constitutive equation.The activation energies determined are 570 kJ／mol and 548 kJ／mol for steel T122 in saturation stress and peak stress,respectively.The values of critical strain for dynamic recrystalli...

采用应变硬化速率—应力曲线图较精确地获得了饱和流变应力和峰值应力；用回归法确定了双曲线本构方程中的变形激活能及材料常数，确定了T122钢在饱和应力和峰值应力条件下的变形激活能分别为570和548 kJ／mol；采用力学方法直接从流变曲线确定了T122钢发生动态再结晶的临界应变量，并回归出临界应变量与Zener—Hollomon参数的关系式。

Moreover, the catalytic current presents linear dependence on the concentration of glucose in the range from 5μmol·L~(-1) to 2.8 mmol·L~(-1), with a detection limit of 1.0μmol·L~(-1) by amperometry.

安培法测得肼的催化氧化峰电流与肼的浓度在2.5μmol·L~(-1)-0.2 mmol·L~(-1)范围内呈线性关系。

The fluorescence intensity of lobeline-treated cells was significantly higher than that of the controls, when the concentration of lobeline was more than 10 μmol/L.

洛贝林（20 μmol/L）的多药耐药逆转有效率为经典耐药逆转剂维拉帕米（20 μmol/L）的71.6%，但毒副作用显著降低。

Result In rat microsome, the apparent KM of squamocin and bullatacin were (1.6±0.5)μmol/L and (2.0±0.4)μmol/L.

结果］在大鼠肝微粒体中，squamocin和bullatacin的表观米氏常数KM值分别为(1.6±0.5)和(2.0±0.4)μmol/L。

A liner relationship between the concentration of L- ornithine and the optical density in the range of 0 to 0.20μmol/mL was obtained, and the least detectable concentration of L

该反应体系稳定，受其他氨基酸的影响程度很小，或者在发酵液等的实际测定体系中存在量极少而可以忽略不计，线性范围为0～0.20μmol/mL，检测精度为0.01μmol/mL。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。