查询词典 moisture

According to the fact that the dewpoint value in the drying chamber relates closely to the moisture content in a product, a new dewpoint-based method is proposed to make sure of the evolution of the moisture in freeze-drying process.

本文根据冻干过程干燥室内的露点值和物料的水分含量有关提出一种新的方法－露点法来监控冻干过程物料的水分迁移情况。

The rainfall was highest in August, and lowest in September. The temperature was highest in July, and lowest in May. The average soil moisture content in the semi-fixed dune land in June was less than that in August and equal to that in September. The average soil moisture content in the natural reconverted grazing land was lowest in September, and highest in August.

半流动沙地6月平均土壤含水量小于8月，8月平均土壤含水量等于9月；放牧自然恢复地平均土壤含水量9月最低，6月其次，8月最高；退耕自然恢复地平均土壤含水量8月最低，9月其次，6月最高。

The moisture measurement in three different states of the silicone by applying the Coulometry and the evaporating equipment of moisture were introduced.

运用库仑法及水分蒸发技术对3种不同状态硅树脂材料中的水分含量进行检测。

This desiccant has a disadvantage as being agglomeration after regeneration.In addition, mechanism of moisture adsorption of corn hull desiccants. By the phenomena of adsorption and calculative activation energy, the mechanism of moisture adsorption was validated.

另外，本文对玉米渣皮干燥剂的吸附机理进行了探讨，并通过玉米渣皮干燥剂吸水过程中所表现出的性质和吸附活化能的计算结果对吸附机理进行了验证。

Furthermore, the reliability of heat and moisture absorbing and desorbing index is verified by use of testing data, and the correctness of heat and moisture transfer model is verified indirectly in this paper.

并利用主厂房实测数据对本文给出的热湿吸放指标的可靠性进行了验证，同时也间接地验证了热湿传递模型的正确性。

The heat and moisture transfer process in porous material, heat and moisture absorbing and desorbing process on wall surface and thermal and humid environment in the underground plants are first researched systemically in this paper.

本文首次对水电站地下厂房多孔围护结构的热湿传递过程、壁面热湿吸放过程和厂房室内热湿环境进行了全面系统的研究。

We adopted Karl-Fischer method to measure the moisture of electrorheological fluids and discussed the effect of different moisture on ERF.

采用卡尔-费休法测定了配制的电流变液中的含水量，讨论了不同含水量对钛酸钡的电流变性能的影响。

The results also suggest that only wood particle with moisture content near fiber saturation point can reach the required final moisture content after one drying process, and ailflow temperature and flux can improve the drying capacity significantly.

气流温度和流量对提高系统的能力有明显的增强作用，它们是干燥能力改变的重要影响因素；在带载率增加的情况下，干燥后的终含水率略有增加，系统的去水能力随着带载率的提高几乎线性地相应提高。

In the process of wood drying, because that the dry rate on the surface of wood is ten times than which inside, the moisture content of wood on the surface reduce to the fiber saturation point first, and begin to shrinkage, but the moisture inside content of wood is far higher than the fiber saturation point, the higher the standard criterion in wood drying, the more obvious of shrinkage.

摘 要：在木材干燥过程中，由于木材表面水分的蒸发速度比木材内部水分移动的速度大10倍左右，因此木材表面的含水率首先降低到纤维饱和点，并开始发生干缩，而此时木材内部的含水率还远远高于纤维饱和点，干燥基准越硬，这种现象越突出，木材发生开裂的可能性就越大。

The free water in wood is very closely related to the density change of wood during drying, so that the sound speed measured by tap tone completely obeys the physical law relating sound speed and properties of solid materials. 2. When moisture contents are higher than the fiber saturation point, the weight changes or the moisture content changes of the wood can be estimated with high accuracy by measuring the changes of sound speed using the tap tone method.

试验结果显示：木材中之自由水分在打音时完全表现在生材之密度变化上，因此打音音速完全遵守音速与材质关系之基本物理定律，故在含水率高於纤维饱和点之生材状态，利用音速变化来推定木材重量变化或含水率变化具有相当高的精度，是合理可行的。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。