查询词典 moisture-proof

ChamaecyparisIawsoniana ParI and picea sitchensis Carr.wood treated with BTCA:Values of weigh percentgainreached 9.05% and 8.25%.Values of antiswelling efficiencyreached57.2% and 55.45% respectively.Values of moisture excluding efficiencyreached47.95% and 44.89%.Chamaecyparis Iawsoniana ParI and picea sitchensis Carr.wood treatedwith 1,2,3,4-butanetetracarboxylic acid and glycerin:Values of weigh percent gainreached 13.12% and 12.24%.Values ofantiswelling efficiencyreached 61.11% and63.12% re.Values of moisture excluding efficiencyreached 46.91% and 48.93%.Woodsurface colour of Chamaecyparis Iawsoniana ParI and picea sitchensis Carr.were slightlyvaried from red to yellow and from dismal to bright in crosslinking reaction.

处理后美国扁柏和西特克云杉两种木材，分别达到：WPG9.05％和8.25％；ASE57.2％和55.45％；MEE47.95％和44.89％；酯化剂中加入丙三醇，酯化处理美国扁柏和西特克云杉木材，分别达到：WPG为13.12％和12.24％；ASE为61.11％和63.12％；MEE为46.91％和48.93％；在酯化反应中，美国扁柏木材材色由偏红向偏黄、由稍暗向明亮方向有些变化。

Before establishment of SEASM, if southerly moisture transportation through the meridional moisture channel is very strong, the convection activity becomes more active around the IndochinaPeninsula and the rainy season begins earlier in Yunnan corresponsively.

当这一水汽通道中南风水汽输送在季风建立前异常偏强时，相应地中南半岛附近的对流也增强，对应着云南的雨季开始偏早，初夏降水偏多，反之则初夏降水偏少。

Generally, the moisture content of timber should be lower than 12% and then the timber can be used for furniture producing, otherwise, exorbitant moisture content will make the furniture appear deathful quality problems easily, such as transmogrifying, dehiscing, ungluing, etc..

通常木材的含水率应低于12%方能用于家具的生产，否则过高的含水率会使家具在日后的使用过程中容易出现变形、开裂、和脱胶等致命的质量问题。

450M, 1650m, 1850m and 2050m it is 54.04mm, 42.8mm, 56.38mm and 66.22mm respectively, showed in typical this world lay aside of moisture of slope upside soil is measured the biggest, of declivous seating arrangement, the region with moisture the poorest condition gives the slope in now.

结果表明：海拔1450m、1650m、1850m和2050m的0~50cm土层的年平均贮水量分别为54.04mm、42.8mm、56.38mm和66.22mm，表明了在典型阳坡上部土壤水分贮量最大，下坡位次之，水分条件最差的地带出现在中坡。

The results showed that covering the dich slopes with shrub could significantly increase soil shear strength, compactness and moisture content, and the formed vegetation had significant effects on retarding runoff and removing TSS (P.05). Applying live fascines could significantly increase soil shear strength and TSS removal rate (P.05), but its effects on increasing soil compactness and moisture content and retaining runoff were not significant.

结果表明：与对照相比，使用灌丛垫技术修复后的坡岸土壤剪切力、紧实度和土壤湿度显著提高(P.05)，坡岸植被延缓径流和去除悬浮物效果显著(P.05)；使用柴笼技术修复后的坡岸土壤剪切力和悬浮物去除率显著提高(P.05)，但对土壤湿度、紧实度和雨水径流的延滞作用不太明显。

This experiment uses lime carbonate, kaolin clay and starch as filler, uses sorbitol, ethanediol and chitosan as hygroscopic agent, under without foaming and foaming systems conditions, study filler and hygroscopic agent affect on tear strength, tensile strength, moisture coefficient and gas permeability of this film, and research mechanics of ventilation and moisture-penetrability of experiment preparing PE film by SEM.

本实验以碳酸钙、高岭土和淀粉为填料，山梨醇、乙二醇和壳聚糖为吸湿剂，分别在无发泡体系和有发泡体系的PE薄膜中，研究填料和吸湿剂对聚乙烯微孔薄膜的撕裂强度、拉伸强度、透湿系数和透气性能的影响。

By testing the material's hydroscopic properties, hygroscopic property, moisture vaporizing and moisture retention, we analyzed the effects of configuration of the substrates on the environmental behavior.

从材料的吸水性、吸湿性、水分蒸发性和保水性等方面探讨了纤维原料的单体纤维形态、材料面密度、蓬松度等因素对基材环境学特性的影响。

To discuss the hygrothermal stress influence on strength of the building material caused by the change of temperature and moisture content,on the basis of the coupling equations of thermal conduction and moisture diffusion,its transient temperature and humidity field are derived.

为探讨温湿度变化引起的热湿应力对建筑材料强度的影响，从热传导、湿扩散的耦合方程出发，求得瞬态温度场和湿度场，并推导出包含热湿效应的各向同性材料的本构方程，从而由数值法得出材料应力大小及分布。

The lumber is dry is in fact through the change lumber 干燥窑 intemperature, the humidity controls the lumber drying in transit thelumber moisture content, causes the lumber moisture content accordingto certain technological requirement slow reducing, guarantees to thedifferent 材种 dry quality requirement.

木材干燥实际上是通过改变木材干燥窑内的温度、湿度来控制木材干燥过程的木材含水率，使的木材含水率按一定的工艺要求缓慢的降低，以保证对不同材种的干燥质量要求。

It has been found that at room temperature, moisture absorption had little effect on the mixed-mode interlaminar fracture toughness of T300/5405, but at high temperature, the fracture toughness of laminate increased as the moisture content increase.

研究的结果表明：室温时，吸湿量对材料的断裂韧性影响不明显；高温时，吸湿会使得T300/5405的层间韧性增加。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。