查询词典 moisture-absorbent

The first part discusses about the effects of the five factors:temperature,relative air moisture,rate of frass sifting,density of larvae,fodder water percentage to growth speed and survival rate of older mealworm (Tenebrio molitor L.) larvae through rotational composite design of quadratic regression. Two models were established to describe the effects of the five factors. The models showed that percentage of fodder water is the major factor that has effect on the growing speed of T. molitor larvae,and fodder water is the major factor on death rate. The models also show that temperature on growth speed,temperature and fodder have important effects on death rate,and the significant test showed they have significant difference on 1% or 5% level. From the two models,by frequency analysis,we can get the optimizing rearing condition,in which the mealworm larvae overweight 10% per day,temperature is 25-26 ,frass sifting rate is once 2-4 days,density of larvae is 0.61-0.79 g/cm2,fodder water is 33.27%-39.71%. And the rearing condition,in which total death rate of T.

第一部分：采用五因素二次正交旋转组合设计，以黄粉虫幼虫饲养过程中饲养温度(X_1)相对湿度(X_2)、虫粪筛除频率(X_3)、饲养密度(X_4)以及饲料含水量(X_5)五因素为参试因素，考查它们对黄粉虫高龄幼虫的生长及存活的影响，建立了以黄粉虫幼虫增重率及死亡率为目标函数的回归模型，并进行了简化： Y_增=127.5079+18.6559x_5+2.7894x_3x_4-2.3854x_3x_5-3.0594x_1~2+1.8241x_3~2-3.8559x_5~2 Y_死=1.7459+0.4108x_1+0.0975x_2+0.9025x_4+0.3442x_5+0.0834x_1~2+0.3060x_4~2-0.2623x_5~2 分析结果表明：影响黄粉虫幼虫生长后期增重及死亡的主要因素分别为饲料含水量和饲养密度；饲料含水量和温度对黄粉虫增重有着重要的影响，饲养密度、温度、饲料含水量对黄粉虫的死亡有着重要的影响，其影响均达1％或5％显著水平；黄粉虫幼虫后期日增重率大于10％的饲养条件为：温度26～27℃、筛粪频率2～4天／次、饲养密度0.61～0.79g／cm~2、饲料含水量33.27～39.71％。

The analytical results indicate that the standard absorption moisture possesses the better sort feature, but the classification grade is obviously higher according to the above specification, and the free swelling ratio of expansive soil in the middle area of Anhui Province is lower.

开展了系统的膨胀土特性试验，对各项判别指标之间的相关性和判别结果的一致性进行研究，探讨新规范推荐标准在皖中地区膨胀土判别与分类中的适用性以及合理的分级评判标准。

The moisture flux in case 2006 was more than case 2005. The frontogenesis process in case 2006 was obvious; it showed that the front system was accompanied with a strong temperature gradient. The mid and low-level frontogenesis process played an important role in the development and maintenance of causing the front convective systems. The jets were formed with the difference of horizontal ageostrophic wind in vertical direction.

由水气收支计算可得到水平水气通量辐合对於对流系统之水气来源扮演正回馈作用，其中2006年个案中水气通量较2005年个案来得大。2006年个案之锋生过程显著，中低层锋生过程扮演导致锋面对流系统之发展与维持重要角色；而低层喷流生成的条件主要来自於横向非地转风垂直分布之喷生作用。

In the experiment, we mainly analysis the module, frost heaving, thaw settlement in freezes under the condition to the subgrade soil, the soakage change rule have carried on the actual, and have carried on fast and slow experiment contrast analysis in several primary factors that affected the roadbed to freeze the characteristic: The initial moisture content, the freeze speed, the load and so on.

试验中，重点对路基土在冰冻条件下，回弹模量、冻胀、融沉、吸水量的变化规律进行了实测分析，并对影响路基冰冻特性的几个主要因素：初始压实度、冻结速度、荷载等进行了快速、慢速试验的对比分析。

Results showed that TPSⅠ and TPSⅡ could dissolve in water and not in organic solvents of high concentration, and they had capacities of oil absorption, frothing and froth maintenance as well as capacities of moisture absorption and retention in humid and dry environment.

结果表明它们能溶于水，不能溶于高浓度的有机溶剂，随着纯度的提高，溶解性能降低；它们还具有吸油性、起泡性和泡持性，在湿润和干燥的环境中具有吸湿和保湿性能，纯度的提高增强了茶多糖的表观粘度，TPSⅡ的粘度是TPSⅠ的4倍。

Da Fengfan has our own drying equipment. In order to ensure the moisture content of timber reach to the standard, all inacceptable timber need fumigate for two weeks, and can be used after all the examination indexes are eligible.

冠森拥有自已的木材烘干设备，为确保木材的含水率达标，所有含水率未达标的木材都要进行为期两周的熏蒸，待所有相关检测指标合格后方能使用。

The fuming is a result of hydrogen chloride's reaction with moisture in the air.

冒烟是氯化氢同空气中的水蒸汽反应的结果。

Optimization experiment being single factor shows that the best condition of tannase production should be in the gallnut amount of 8%, the initial moisture content of 50%, the initial pH 6.0, temperature of 30℃.

单因素优化试验表明，五倍子用量为8%，初始水分含量为50%，初始pH6.0，温度30℃为优化产酶条件。

In the packing design effect design mainly displays in the below aspect:①The protection performance design, including moisture-proof, the mold proofing, worm-preventing, quakeproof, guards against leaks, guards against garrulously, guards against the extrusion and so on.

包装图案中的功效设计主要表现在以下方面：①保护性能设计，包括防潮、防霉、防蛀、防震、防漏、防碎、防挤压等。

These products are notable for their superior dimensional stability, long-term creep resistance, long-term fatigue resistance and excellent resistance to moisture, chemicals and fuels, even oxygenated fuels and gasohol.

这些产品因其优异的尺寸稳定性、长期抗蠕变性、长期抗疲劳、耐湿、耐化学，以及耐燃油而著名。它们甚至耐氧化性燃油和酒精汽油混合燃料。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。