查询词典 modulus

Results The results showed that more accurate uniaxial modulus can be extracted using 4 parameters inhomogeneous triphasic model, and the predicted results appeared to match the experimental strain data better than other models.

结果 运用非匀质4参数三相模型可以提取更精确的软骨轴向模量，与其它模型相比，该模型对软骨膨胀的预测结果更接近实验结果。

The increase in dry unit weight of specimens from 13.3 to 15.7 kN/m3 increased the unconned compression strength by 190% in specimens containing 10% bentonite and by 133% in the specimens containing 15% bentonite, whereas the increase in unit weight of specimens from 13.3 to 15.7 kN/m3increased the secant modulus at the maximum stress by only 13% in specimens containing 10% bentonite and by 10% in he specimens containing 15% bentonite.

登录后回答可以获得积分奖励，并可以查看和管理所有的回答。登录|增加的干重度的标本从13.3上升到15.7 kN/m3的无侧限抗压强度的190 ％，标本中含有10 ％的膨润土和133 ％的标本中含有15 ％的膨润土，而增加了单位重量的标本3月13日至7月15日kN/m3increased的割线模量的最大应力的只有13 ％的标本中含有10 ％的膨润土和10 ％，他的标本含有15 ％的膨润土。

The experimental results are summarized as follows: the tensile strengh and bending strengh of steel fiber reinforced lightweight aggregate concrete can be improved significantly by the addition of steel fiber; to some extent ,the addition of steel fiber can also increase the compressive strength ,although little , it radically improves the compressive toughness , and the steel fiber reinforced lightweight aggregate concrete will not fall apart with cracks; with the increase of the volume fraction of steel fiber, the elastic modulus is also rising somewhat; Poisson's ratio is influenced little with the addition of the steel fiber and the effect regularity displays unconspicuously.

本文试验研究结果可归纳如下：钢纤维的加入能明显提高钢纤维轻骨料混凝土的抗拉强度和抗折强度；掺入钢纤维使钢纤维轻骨料混凝土的抗压强度有一定程度的提高，增长幅度不大，但抗压韧性却有很大改善，使钢纤维轻骨料混凝土裂而不散；钢纤维轻骨料混凝土的弹性模量随钢纤维体积率的增大有一定提高；泊松比受钢纤维的加入影响不大，规律性不明显。

The results show that for high lead solder, underfill with low CTE and high modulus is preferred.

对高铅焊锡凸块而言，选择低热膨胀系数和高弯曲弹性模数之底部填胶可以有效提高其可靠度。

During the establishment of sediment yield dynamic model at the watershed outlet, it was difficult for us to carry out dynamic monitoring of each impact factors in the whole basin, because it was a long time research and was in very large-scale watershed. Taking into account the interannual variability of sediment yield mainly affected by hydrological conditions of rainfall - runoff and underlaying surface changes caused by soil conservation measures, a combined influence factor which is related to surface runoff modulus and the implementation time of the water and soil conservation project was proposed for the first time. Furthermore, its specific expression was determined through dimensional analysis and non-linear regression multianalysis.

在流域输沙量动态模型的建立中，由于研究时段长、研究流域尺度大，对输沙量各影响因子进行全流域逐年动态监测十分困难，考虑输沙量的年际变化主要受降雨-径流水文条件和水土保持措施等土地管理活动的影响，首次提出与地表径流模数和治理时间相关的综合影响因子，并通过因次分析法和二元非线型回归法确定了具体的表达式。

Elastic modulus of specimen processed by PPT method and HP method are obtained by adopting three-point bend test and tensile test of unnotched specimen respectively.

采用无缺口试件的三点弯曲试验，得出PPT法制备的试件的弹性模量；通过柔度变化率曲线上的第一转折点得出基体的破坏应变，并由此得到基体的强度。

The apparent degree of network chains for the different swollen extent of the same unswollen hydrogel sample increased linearly with the increase of swelling ratio, however, the apparent modulus did not decrease monotonously with the increase of swelling ratio. Furthermore, the dependence of apparent degree of network chains on swelling ratio had nothing to do with the swelling agent. The above results reflected the changes of entanglement and the contribution of entanglement under different swelling ratio, and the results could be explained with the theory of Flory-Erman's constrained junction model and LangleyGraessley relation.

发现同一水凝胶样品的不同溶胀程度试样经应力应变测试得出的表观网链密度随体积溶胀率的增加而线性增加，等效模量并不随溶胀程度的增加而单调减小，而表观网链密度的溶胀程度依赖性与所选用的溶胀剂无关，该结果反映了不同溶胀程度下缠结的变化及缠结对弹性的不同贡献，并可由Flory-Erman的constrained junction模型及Langley-Graessley公式得到解释。

Firstly, material tests of both steel stud and wallboard are taken to get the elastic modulus and ultimate strength.

在试验研究方面，首先，对钢材和墙板进行了材性试验，得到了材料的弹性模量和强度。

Results: Solution concentration range depended on 0.5~50 mg/L lineaity, relation fine, the relevance modulus amounted to 0.999 without exception. The soursulfan acet ophenetidin ilamide potassium, benzoic acid, dehydro aectic acid, sorbic acid, saccharin sodium minium inspects up out tickness being 0.062, 0.074, 0.066, 0.370, 0.105mg/L The standard deviation was smaller than 5.0%. The additive hit hack rate was 96.8% in drink pickle and the nature bean product fermenting 101.6%.

结果：本方法测定食品中5种添加剂，溶液浓度范围在0.5~50mg/L线性关系良好，相关系数均达0.999；乙酰磺胺酸钾、苯甲酸、脱氢乙酸、山梨酸、糖精钠最小检出浓度分别为0.062，0.074，0.066，0.037，0.105mg/L；标准偏差均小于5.0%；饮料、酱菜和发酵性豆制品中添加剂的回收率为

Key words: metallic material; bimetal casting; computer simulation; modulus ratio

关键 词：金属材料；复合铸造；计算机模拟；模数比

The witness also told the jury at the Royal Courts of Justice in London that he saw a paparazzo fighting with a member of the public who was trying to stop him taking pictures in the minutes before the emergency services arrived.

他还告诉在伦敦皇家法庭的陪审团，在急救服务到来之前，他当时看见一个狗仔队正和一群阻止他拍照的人打架。

The entire N／C program on a tape is made up of an accumulation of these successive data blocks.

纸带上的整个数控程序由这些连续数据单元连接而成。