查询词典 modulus

Figure 5. Shear and bulk modulus relation for sandstone and weakly cemented sands.

图5。砂岩和弱胶结砂体中剪切模量和体变模量之间的关系。

Simulation results shows that when the effective bulk modulusβe and the reaction force f change, the controller is robust.

仿真结果表明，该滑模控制器在体积弹性模量βe和锻件抗力f变化时具有鲁棒性。

The structure data of simulation results at ambient temperature were agree well with the experiments, and the thermal expansivity and bulk modulus of TiO〓 and K〓Ti〓O〓 were obtained.

常温下模拟得到的结构参数能很好的和实验数据吻合。模拟了随温度和压力变化造成的热膨胀系数和体积弹性模量，对本实验室合成的六钛酸钾晶须的性能进行了预测。

Calculated structural properties、bulk modulus and elastic constants compare very favorably with experimental data and other first principle calculations.

其中，铀的晶格参数、弹性常数和体模量等与实验及其它第一性原理计算结果十分吻合。

The relaxing ability of atoms in epilayer is also important in the formation of Moiré structure, which can be related to the bulk modulus of epilayer.

外延岛的面内弛豫行为与外延层和基体之间的相对刚度有关，弹性模量较大的外延层具有较强的延展能力，对Moir 结构的形成有利。

Using the continuity conditions of displacement and radial stress, a closed-form solution of the plain strain bulk modulus of concrete was derived.

利用位移和径向应力的连续性条件，导出了混凝土平面应变体积模量的闭合解。

With increasing in bulkiness of the ester group of the acrylates the hardness, tensile strength, and 100% modulus decreased because of decreased stiffness of the acrylate phase.

物理机械性能表明，随着甲基丙烯酸酯的酯基体积增大，IPN的硬度、拉伸强度及100%定伸强度减小。

It was found that, for the control treatment the average runoff depth was 3.72mm per 10mm, the water loss index was 37.2%, the average soil erosion was 43.6 kg*hm-2*10mm-1, and the soil erosion modulus was 7.42 t*km-2*a-1, which are all high in the 4 treatments. For the other three treatments, the surface runoff and the average soil erosion amount were 2.20%-67.08%and 43.81%-90.83%lower than those of the control, respectively. The most effective pattern for soil conservation was the artificial forest with underbrush treatment, and the best water conservation pattern was the treatment of planting tea bush on contour terrace.

结果表明，CK的平均径流深度为3.72 mm/10 mm，降水流失率为37.2%，平均每10mm降雨的土壤侵蚀量为43.6kg*hm-2，年土壤侵蚀模数为7.42 t*hm-2；其它3个不同植被覆盖处理的地表径流量比裸地对照降低2.20%～67.08%，平均土壤侵蚀量减少43.81%～90.83%；林下地表覆盖处理的保土效果最好，等高梯田种植茶树处理的保水效果最好。

And the calculation method of theresistance modulus has been given by rule and line. The flow state in the pipeline of the densecolloid slurry is carried on numerical value simulation by the software CFD Fluent, which hasbeen grasped. And the critical flow velocity of the dense colloid slurry in the different ratio ofbetween water and earth is obtained by numerical calculations.

通过使用 CFD 软件 Fluent 对稠化胶体泥浆在管道内的流动状态进行了数值模拟，获得了稠化胶体泥浆在胶体流动性实验台管路中流动时的流型，并且通过计算得到了稠化胶体泥浆在不同水土比下的临界流速。

Conclusion］1? It showes a higher stress dodge in the calcar femorale after using various kinds of prosthesis implantation? After using CFR/PSF of lower elastic modulus as handle, the stress dodge rate is lower in femur, but the interface stress is higher, and this is the main factor and reason for the prosthesis loosening? 2? The stress force rule meets the design principle that the stress force decreases gradually in the bone interface from proximal to distal? The stress value in different combination of same prosthesis handle has no significant difference, that showes mechanical factor is not the main standard for selecting prosthesis combination?

［结论］ 1、各种假体植入后均在股骨距处形成较高的应力遮挡，而用弹性模量较低的CFR/PSF作为柄，其股骨相应区域的应力遮挡率较低，但股骨相应界面应力较大，而界面应力过大是产生假体微动主要因素。2、股骨界面从近端至远端呈逐渐增高趋势的应力规律符合该假体的设计原理；相同假体柄的不同组合其股骨和髋臼相应界面应力值无明显差别，实验表明力学因素并不是选择假体组合的主要标准。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。