英语人>网络例句>model t 相关的网络例句
model t相关的网络例句

查询词典 model t

与 model t 相关的网络例句 [注:此内容来源于网络,仅供参考]

The results showed:(1)the factors which influence causal judgment were that the cause was the real cause or stimulative,the familiarity of the cause,and the covariation degree of causes with outcomes;(2)the character of questions didn't influence causal judgment;(3)causal judgment in some conditions were in accord with the probabilistic contrast model and the causal model theory,but they couldn't explain causal judgment in all conditions.

例如,在两个刺激同时出现并且之后伴随着一个结果事件出现的情况下,其中一个刺激对结果的作用可能被认为减弱了,另一个刺激被认为更易引起结果事件的产生[1]。多原因相互影响的现象,最初在动物条件反射中观察到,现在也已经在人类因果判断的实验中证实了[2]。研究因果判断中的多原因相互影响这一现象是有理论意义的,因为它证明了因果判断产生的情境重要性。

At first step, the processor before the deformable body contact the end face of cone die cavity regarded as an extrusion process. The minification of core boss's cross-section regarded as compressibility of direct extrusion, which acted as definition factor when construct the Direct Extrusion Model element. Another step, the model element of flat punch extrusion on wedge piece process was constructed when propose the process of deformable body overflow die corner. In this way the spherical end face of blank looked as cone end face one, t he approximate treatment is one of originality innovation in this paper. At last, the two elements have been connected and constructed the model element of cone boss part's deformation in the open die forging.

对于锥形凸台成形的第一个特征时段,即坯料和锥形凸台型腔的端面接触之前的变形过程,本文将凸台的截面缩小率转换成挤压成形的压缩率并以此为界定,建立了不同截面缩小率时的锥形模正挤压的模型单元;对于锥形凸台成形的第二特征时段即锥形模的角部充满过程,在详细考察锥形型腔端面对变形过程影响的基础上,将变形体的球形端面近似成锥面建立了平冲头挤压楔形体的模型单元;最后将前述两种模型单元有机连结,构建了开式模锻中整个锥形凸台成形过程的定量描述。

The results of numerical experiments, using the four-dimensional variational data assimilation system of the nonhydrostatic mesoscale model MM5, show that: the tangent linear model and adjoint model conducted by keeping the "on-off" switches the same as the basic state, can provide a good approximation of the first-order information to the NLM perturbation and a good descent direction for the minimization procedure; switching on and off at every other time step in the Kuo cumulus parameterization scheme don"t impact the convergence rate of cost function; the existence of the switches don"t impact improvement to the MM5 model rainfall prediction because that not only specific humidity ,but also wind, temperature and pressure are assimilated into the model.

非静力中尺度数值模式MM5的四维变分资料同化系统进行的数值试验结果表明:"开关"变量保持与基态一致,所构造的切向线性模式能够提供关于非线性模式扰动的一阶近似,伴随模式所计算的梯度值能够为最小化过程提供较好的下降方向;郭氏降水参数化方案中对流每隔一个积分步的交替发生并不影响目标函数最小化的收敛速度;"开关"变量的存在也不影响将风、温度、气压和比湿结合起来同化对MM5降水预报准确性的提高。

We structure a general equilibrium dynamic model of optimize behavior under the stick price, the model is made up of IS equation , AS equation and interest rate rule , these three equations :::: We utilize state space model and Kalman filter to measure the variable which can't be observed --The China Real Interest Rate Gap and China potential GDP .

我们构建了粘性价格下基于主体最优化行为的一般均衡动态模型,模型由IS方程、AS方程和利率规则这三个方程组成::::我们利用状态空间模型和卡尔曼滤波的方法对于不可观测变量——中国实际利率缺口和中国潜在GDP进行了度量。

The result indicates that conicoid anti error is smaller than that of plane and three cubed anti error fitting model, but the validity of the model doesn't necessarily have relationship with model steps.

结果 二次曲面抗差的结果要好于相关平面与三次曲面抗差的结果精度,并非抗差模型阶次越高有效性越高。

In Comlex model group the endangium plaque were widespread, while in that of High cholesterol group there was only single small plaque. The pathological heart changes of both High cholesterol group and Complex model group weren't obvious, with mild oedema and small fat drops. The liver cells of High cholesterol group showed mild oedema, while fat drops in the liver of Complex model group were more typical.

病理显示主动脉弓变化明显,复合模型组内膜斑块弥漫,而单纯高脂组内膜只出现单个小斑块,单纯高脂组和复合模型组心脏病变区别不大,均见轻度水肿和小脂肪滴;单纯模型组肝脏细胞轻度水肿,而复合模型组肝脏脂肪滴明显。

According to Meese's exchange rate model in 1986, in this paper, we modified Meese's (1986) model and suppose the Interest Rate Parity is untenable, the risk premium factor and real exchange rate parameter are considered, and the Purchasing Power parity doesn't follow random walk, we derive our modified equilibrium model. Base on the State Space Model, we try to estimate bubbles and risk premium which are unobservable variables by Kalman Filter to test which one is or both are the main factors that to cause the real assets price biased from the market fundamental price.

本文是以Meese(1986)所决定的汇率模型为基础,但Messe一文并未讨论到风险溢酬的问题,故本文为了克服此一缺憾,而假设未抛捕的利率平价说(uncovered interest parity,UIP)不成立,以加入风险溢酬因子,且更进一步假设偏离购买力平价理论(purchasing power parity,PPP)不服从随机漫步,若如此则顺利将实质汇率变数纳入於模型中,重新建立均衡汇率模型,为了验证本文所创立的模型,实证方法以状态空间模型为基础,运用卡门滤波器递回法来估计不可观察的变数,以观察台湾的外汇市场上是因泡沫现象还是风险溢酬造成资产价格偏离市场基要价值或是两者皆是造成实际资产价格偏离市场机要价格的因素。

Additionally, small winglets/stabilizers with no other discernable purpose are okay to be used as greeble as long as they aren't a major portion of the model, and if the model wasn't designed for pure space usage in mind.

另外,如果模型不是只纯粹用于太空,小翼/水平尾翼上有些突起只要不让人觉得是模型的主要部分,这都是允许使用的。

Additionally, small winglets/stabilizers with no other discernable purpose are okay to be used as greeble as long as they aren't a major portion of the model, and if the model wasn't designed for pure space usage in mind.

另外,如果模型不是只纯粹用于太空,小翼/水平尾翼上有些突起只要不让人觉得是模型的主要部分,都是允许使用的。

The imaging under in passive scene are provided , and t he f unctions of t he scene model , at mosp heric t ransmission model and p hysical property of materials acting on IR imaging are explained.

然后分析各种辐射对成像的影响,给出辐射计算公式,分别就无源和有源场景进行了分析,提出无源场景温度的求解方法,说明了场景模型,大气传输模型和材料的物理特性对红外成像的作用。

第24/65页 首页 < ... 20 21 22 23 24 25 26 27 28 ... > 尾页
推荐网络例句

However, as the name(read-only memory)implies, CD disks cannot be written onorchanged in any way.

然而,正如其名字所指出的那样,CD盘不能写,也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口,替代木托盘,免薰蒸,符合欧盟、北美各国对出口货物包装材料的法令要求;喷涂钢托盘适用于重载上货架之用,托盘表面根据需要制作成平板状、波纹状及间隔形式,满足不同的使用要求。

A single payment file can be uploaded from an ERP system to effect all pan-China RMB payments and overseas payments in all currencies.

付款指令文件可从您的 ERP 系统上传到我们的电子银行系统来只是国内及对海外各种币种付款。