查询词典 model set

On the basis of simplified calculation model presented by Doctor WangXiaoPing, some finite element models are set up.

柱子的抗弯刚度对屋盖结构的受力性能及稳定承载力亦有着较大影响。

In the article,the research based on the the design parameters calculated above to set up finite element model, and to do deal with the previous calculation.

文中以上文提出的设计计算方法得到的计算参数建立有限元模型，并做先前计算处理。

A three-dimensional finite element model was set up to validate the reliability of the theoretical method using the software of Abaqus.

为验证该解析法的合理性，采用非线性较强的有限元软件Abaqus建立了空间模型，模型考虑了剪力连接件和材料的非线性。

In order to optimize the structure for the firer base plate by means of FEM,A three- dimensional shell model has been set up for a particular type of firer base plate.

为了优化发射器座钣的结构设计，采用有限单元法对某型号发射器座钣三维空间板壳结构进行了整体三维建模，同时运用弹性力学有限元法对座钣建立的有限元模型进行模态分析和瞬态动力学分析。

When the threshold for the logistic model was set at the first quartile, this resulted in a sensitivity of 86% for detecting all stroke and a sensitivity of 94% for detecting hemorrhagic stroke.

当Logistic模型的界值设定为第一个四分位数时，结果显示检测出所有卒中的敏感度为86%，而对出血性卒中则为94%。

In my opinion, the simplest approach is: Normally, the hard drive to back up a partition table (not, to find a model with the same hard disk partition table can be), the event was to get rid of a hard disk, floppy disk with both fixed, it can be hard in the bios will set none, to start after the backup to restore the partition table back to the hard disk and then change the settings back from the new start, fdisk it.

我认为，最简单的办法是：在平时，将硬盘的分区表备份一个（没有的话，找一个与之相同型号的硬盘的分区表也可以），万一硬盘被干掉了，用软盘都起不动的话，可以在bios里将硬盘设为none，启动后，将分区表的备份恢复回去，然后将硬盘的设置改回来，从新启动，fdisk就可以了。

By processing normalized data set in last fixed time period, trained sample data to determine the parameter of prediction model.

在最近固定时间段的数据集数据进行归一化处理的基础上，构造样本数据并进行训练，确定预测模型的各项参数。

The theoretical model s for hydraulic parameters of fluidics downhole boost compressor were set up with the fluid mechanics network method on the basis of structure and work principle of the first generation of downhole boost compressor.

基于射流式井底增压器第一代样机结构和工作原理，运用流体力学网络分析方法，建立了射流式井底增压器的水力参数理论模型。

Based on the analysis for these characteristics and vertical evolution、sedimentary process, it is raised that Nanduan formation is a set of proximal wide-ranging-happening (no-fan model) grain flow、turbidite and shelf sediments in the wave-control delta front slop and deep shelf environment, and is not abyssal flysch suite.

在对这些特征及垂向演化、沉积机理分析基础上，提出南段组为一套浪控三角洲前缘斜坡至深陆棚环境中的近源片泛性颗粒流、浊流及正常陆棚沉积，并非深海复理石建造。

This paper expounds the approach to simulation of the roller gear indexing cam based flexible cam axes,and studies the method of forcing between flexible cam axes and rigid graduator to set up the model for simulation of the roller gear indexing cam based rigid-flexible coupling .

阐述了在考虑凸轮轴柔性条件下实现弧面分度凸轮机构运动仿真的途径和步骤，结合有限元技术和虚拟样机技术，研究了如何在柔性体凸轮轴与刚体分度盘之间施加作用力的思想和具体实现方法，为该机构的刚柔耦合运动仿真提供了基础模型

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。