查询词典 model after

After inlet model s three dimensional structural grid was generated, proper numerical scheme and onflow model were choosed, then numerical computation on flow field of inlet was taken, finally the better results were got.

通过建立三维结构化网格模型，选择合适的数值格式与湍流模型，对进气道流场进行数值模拟，得到了合理的结果。

People usually use adjectives to express emotion. An emotional model based on adjectives is provided in this paper. Based on the idea of "dimension" from psychology, semantic differential method and factor analysis are used to construct an orthogonal emotional space. The measurement of similarity in the emotional space is analysis. After that, the emotion model is used in image retrieval.

通常人们用一些形容词来表达自己的情绪，本文提出了种情感模型用来处理这些表达心理的形容词，从心理学的"维量"思想出发，采用语义量化技术和因子分析的方法建立情感空间，并分析情感空间的相似性度量方式。

Cut off five sixth of rat′s kidney to make chronic kidney adynamia model,divide into pseudo operation group,model group,surround aldehyde oxygen amylum group,"Shenshuaining"group and traditional medicine compound high,middle and low dosage group,perfuse stomach separatehy,after four weeks,measure guantiey of Hb,RBc and weight.

采用切除大鼠肾脏5 6制备慢性肾衰模型，并随机分成假手术组、模型组、包醛氧淀粉组、肾衰宁组及中药复方的高、中、低剂量组，分别灌胃给药，四周后测血红蛋白及红细胞计数，并称量大鼠体重。

Methods: Prepared the epilepsy model of rat with picrotoxin injection, then it was interfere the model with immunoglobulin injection either before or after seizure respectively.

用印防已毒素制备癫痫大鼠模型，在发作前、后分别给予IVIg进行干预处理，检测脑组织匀浆内TNF-α和IL-2、4、10的浓度变化，并与对照组比较。

Based on the power series expansion of the general flexible matrix of the sub-system, a general expression of the dynamic stiffness matrix of the reduced model was derived from the exact expression of the reduced model for the direct substitution dynamic condensation methods. The general expression was also expressed as a power series of the unknown eigenvalues. After that, the validity and error of the Guyan condensation method were analyzed.

对于动力缩聚直接代入法，本文从降阶模型的精确表达式出发，利用子系统广义柔度矩阵的幂级数展开式，导出了降阶模型动刚度矩阵的一般表达，并把它表示为未知特征值的幂级数形式，在此基础上对 Guyan缩聚法的适用范围和误差进行了一般分析。

After rational predigestion of the heat exchanger of the thermoelectric generator''s physical model in this paper,by using the Fluent software,adopting the SIMPLE arithmetic and k-εmodel,the 3D inner flow of the heat exchanger of the thermoelectric system was simulated numerically.

本文在对温差发电系统的冷端换热器的物理模型进行了合理的简化处理后，应用Fluent通用软件，采用Simple算法和标准k-ε湍流模型，对温差发电系统的冷却端换热器内的流场进行了三维数值分析。

For the accuracy and complexity of different complexity analysis method are different, firstly, the ultimate strength of pressure hull is mathematically analyzed and calculated by ANSYS, and then the empirical formulation is modified according to the modified factors, which are gotten by the accurate model of ANSYS. So that the calculation accuracy will be improved and the calculation time will be reduced after the analysis model of pressure hull structure is integrated.

不同分析方法的准确度和复杂度不同，本文采用ANSYS这种高精度分析方法对于载人球壳的极限强度进行计算，并根据所得到的计算结果来对采用经验公式方法得到的结果进行修正，使得多学科设计优化模型中集成修正后的载人球壳结构分析模型以提高计算结果的精确度和降低运算时间。

The paper puts forth that the numerical model of actual forming part is reconstructed by RE and the surface is regarded as actual trimmed surface, then grids and nodes mapping relationship between design model and actual forming part is acquired through compelling deformation simulation, and the design trimming line is dispersed into points according to a certain precision and the projective points and the coordinate values of the intersection points of projective line on the grids formed by discrete points are calculated along trimming direction, the new coordinate values of projective points and intersection points of projective line after deformation are calculated based on the mapping relationship of grids and nodes, the deformed trimming line can be acquired through fitting the points into curve.

本文提出通过逆向工程技术重构出实际冲压件的型面并以此型面为修边后实际冲压件的型面，然后采用强制变形仿真的方法建立设计模型和实际冲压件重构模型的网格和节点映射关系。将设计修边线按一定精度离散成点，然后根据修边方向计算出各点在网格上形成的投影点和投影线交点，根据之前计算出来的网格和节点映射关系就可以计算出投影点和投影线交点在变形后的新坐标，将其拟合成曲线就可以得到变形后修边线的形状。

Results showed acceptable reliability and proper factor validity. After factor analysis, an empirical model was modified from the conceptual model for SEM analysis and hypothesis testing.

本研究使用验证性因素分析以及结构方程模式（Structural Equation Modeling， SEM）针对整体模式进行分析及假设之检定。

After having completed the model analysis of the pressurized water reactor core barrel in an 1:10 model,the dynamic characteristics are obtained.

在反应堆1：10模型上进行了堆芯吊篮结构的空气和静水中模态分析试验，获得动态特性。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷