查询词典 mode

This paper introduced an eigen-mode decomposing method to decouple zero sequence parameter in double circuit. The decomposing matrix of eigen-mode component is given. The zero sequence component relationship between voltages or currents at two terminals of double circuit was achieved by composing eigen-mode components.

提出一种采用特征模量分解方法对同杆多回线间的零序参数解耦，并给出了同杆双回线零序参数特征模量分解矩阵，通过特征模量分解得到同杆双回线路两端之间的零序电量关系。

Besides covering the low, middle, and high end in regard to price, Unicom, with the introduction and more types of dual mode and standby cell phones, is making groundbreaking adjustment to its sales mode as well, as it included Coolpad 288, a dual mode and dual standby cell phone, into the GSM channels for sales.

除了价格上对高、中、低端的全面覆盖，随着双模双待机型的不断增加，联通在销售模式上也做了突破性调整：首次将双模双待机酷派288纳入到GSM的渠道加以销售。

This paper describes the necessity and development of infrared / millimeter wave dual mode guidance technology, explores the principle and feature of IR /MMW dual mode noncommon aperture complex guidance, common aperture complex guidance and IR / MMW dual mode receptor of energy.

介绍了红外/毫米波双模制导技术的必要性及发展情况，探讨了红外/毫米波双模分口径复合制导、共口径复合制导和红外/毫米波双模集能器的工作原理及特点。

In this paper, the OMT based modeling method is investigated firstly. Then, the object mode, function mode and dynamic mode are built, which lays a solid foundations for the automatic generation of dyn...

本文首先研究了对象建模的方法，并以之为指导，建立了FMS的对象模型、功能模型和动态模型，为FMS动态仿真软件的自动生成打下了基础。

Therefore, we should change the traditional consumption mode, build up a kind of consumption mode which accord with environment rule—— ecotype consumption mode.

为此，必须改变传统消费模式，建立一种符合生态规律要求的、生态化的消费模式——生态消费模式。

It comprises following steps: dissolving cross linker, functional monomer, mode molecule and initiator into pore-generating agent, getting mixing solvent; hypersonic de-gassing the mixing solvent; venting nitrogen after even mixing, sealing at nitrogen condition or vacuum condition; proceeding polymerization reaction, employing heat initiation for molecule engram polymer; grinding got molecule engram polymer after polymerization, sifting and removing mode molecule with organic solvent, checking with high efficiency liquid chromatography- ultraviolet until there is no mode molecule; vacuum drying and getting final product.

具体为：首先将交联剂、功能单体、模板分子和引发剂溶解在致孔剂中，得到混合溶剂；将混合溶剂超声脱气；混合均匀后，通入氮气，氮气状态或抽真空状态下密封；进行聚合反应，分子印迹聚合物采用热引发；聚合反应结束后，将合成的分子印迹聚合物取出研磨、过筛后用有机溶剂除去模板分子，通过高效液相色谱-紫外检测，直到检测不到模板分子；将除去模板分子的聚合物，真空干燥，得到利血平特异的分子印迹聚合物。

For a heterogeneous elastic solid consisting of two homogeneous layers, three homogeneous layers whose shear wave velocities increasing with depth, or three homogeneous layers whose interlayer has high velocity, if there are multi-mode dispersion curves, the phase velocity V〓 of the first mode will close up to the Rayleigh wave velocity of the bottom layer when frequency f→OHz, and V〓 of the first mode will close up to the Rayleigh wave velocity of the top layer when f→∞.

由多导波模式的相速度频散曲线还可知，对于二层固体介质、结构层的横波速度随深度而递增的三层固体介质、含硬夹层的三层固体介质而言，若频率f→OHz，其基阶模式的瑞利波相速度V〓→V〓（V〓为最底层介质的瑞利波速度）；若f→∞，其基阶模式的V〓→V〓（V〓为最上层介质的瑞利波速度）；因此，随着频率f逐渐升高，野外实测的瑞利波相速度V〓曲线应该主要为基阶导波模式。

In this article two functional modes of the Fly-back Converter (Continuous Conduct Mode and Discontinuous Conduct Mode) are particularly analyzed, which include their characteristics, applications, the critical pattern of two functional modes is argued, both the exact boundary from the angle of circuit parameters is crystallized, at the same time, basic principle of PFC under the DCM mode is introduced, which settle theoretical basis for the subsequent design; by establishing the mathematic model of the converter, a further investigation of the configuration is made, qualitatively and quantitatively, analyzed to settle exactly theoretical basis for the subsequent emulation and the experimental parameter; from the angle of steady-state analysis, the transfer function of the system is deduced to establish dynamic small-signal state equation, emulating the system with the help of matlab, then according to the simulation result and the theory of PFC revise the system, lastly, we adopt the project which add a zero-pole compensator to the voltage loop, by this way, a satisfied system performance is gained and the PFC scheme is ensured successfully; finally, based on the previously-done work, we combining with the situation of specific design requirement, acquired the numerical value of each unit devices in this converter

详细分析了反激式变换器的两种工作状态，连续模式(Continuous Conduct Mode ，简称CCM)和断续模式(Discontinuous Conduct Mode，简称DCM)以及各自的特点、应用场合，论证了两种工作状态的临界模式，从电路参数的角度明确了二者的界限，同时还介绍了DCM模式下PFC的基本原理，为后面的设计奠定理论基础；通过对整个变换器系统建立准确的数学模型，对此变换器的电路结构做了进一步的研究，定性、定量地分析了变换器各部分的工作状态，为仿真和实验参数的确定以及电路参数的优化提供理论依据；从稳态分析的角度，为系统建立了动态小信号状态方程并推导出系统的传递函数，利用matlab对系统进行仿真，进而根据仿真结果以及PFC的相关理论对系统进行校正，采用在电压环加入零点—极点补偿器的设计方案，得到了满意的系统特性并且保证了PFC的顺利实现；最后，在前面所做工作的基础上，结合设计要求计算出此变换器系统中每个元器件的数值，利用Pspice对其进行了仿真、优化，然后根据仿真结果搭建了硬件电路。

Through the use of the Gauss theorem and the Ampere loop theorem to solute the Maxwell's equations, the mathematical expression of the PCB ground plane inductance is obtained, and then through the analyze of the current-driven mode radiation, the common-mode voltage expression of current-driven mode is got.

通过对共模辐射的模式化分析，得到电流驱动模式共模辐射的数学表达式。

It is proposed that theoretically there exist two kinds of thinking mode: subsistent mode of thinking and generative mode of thinking.

从理论上看，存在两种可能的哲学思维方式：现成论的思维方式和生成论的思维方式。

Liapunov—Schmidt method is one of the most important method in the bifurcation theory.

Liapunov—Schmidt方法是分叉理论的最重要方法之一。

Be courteous -- even when people are most discourteous to you .

要有礼貌──即使当別人对你最不礼貌的时候。